Question about Holden Cars & Trucks

1 Answer

How do I replace the right hand side head light for a 1994 Holden Calais vs?

Havn't started yet

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 364 Answers

There are plastic screws holding the bumper to the rad support, there is a screw under the top corner of the bumper near the wheel. { you may choose to partially remove the wheel splash guard to get easier acces to that screw.} The bumper then pulls with a little force from the side clips, you can then access the inner and top screws/nuts to remove the actual light.

Posted on Nov 30, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 53 Answers

SOURCE: spark plug on right hand side of motor pops out as

the spark plug hole need to be repaired and the smoke is probably due to the spark plug begin pushed out...combustion gas...

Posted on Jul 10, 2009

wireguy212
  • 1627 Answers

SOURCE: OLDSMOBILE CUTLASS CALAIS HEADLIGHTS DON'T COME ON

is your car a 79 or an 85?if it's a 79 you probably need to repace the dimmer switch on the floor,may be the same for a 85.

Posted on Jul 30, 2009

  • 1752 Answers

SOURCE: I need to replace right side head light.

Order it from the dealer.

Posted on Oct 15, 2009

sisadsl
  • 1508 Answers

SOURCE: reverse lights turn off when brake is applied

This would normally mean a loose earth wire to the light , but check the bulbs as well as a bulb with one filament gone can short or earth back through another circuit You can jump a small wire from the chassis to the light assembly body to check

Posted on May 16, 2010

  • 457 Answers

SOURCE: i have a holden calais 2001 model. the drivers

you have to break door panel and may be latch to open door.

Posted on Aug 05, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to find the build number on my 1993 holden calais international,


VIN# are in the on the dash, drivers side, at the bottom of the windshield. They are also on the drivers door or door frame. 17 digits long.

Jul 10, 2016 | Holden Cars & Trucks

1 Answer

How come my question went to a washing machine its a car ?


best option take it to an accredited auto electrician and have it tested before considering removing it.

Jan 24, 2015 | Holden Cars & Trucks

1 Answer

Hi I have poor reception in my car. Not sure exactly where the booster or being a calais where abouts is the second antenna? I heard that they had a built in one in the rear window. Is that true?


They came standard from the factory with an electric ariel, The ariel was located in the LHS Fr quarter panel just in front of the passenger rear vision mirror on the door. not sure if they had the adjustable electric ariel which would have an up and down arrow button just on the deck or under wear the factory head units were installed. The biggest problem for reception is if they are not earthed properly against the car. if the antenna has been replaced theres a good chance someone may have stuffed up the installation. its best to take the front left tyre off and remove the inner wheel guard/surround so you can get to the ariel unit. from there the cable just runs through the firewall panel and behind the dash to the stereo. they are easy to pull through but make sure you know which holes they came through. when pulling new cable you should remove the glove box to. just pull one of the back corners to the center and it will pop out then the rest is easy.
To simplify things you could just install a manual ariel aswell (430) new electric ones may cost around $100 for a aftermarket one.

Jul 08, 2014 | 2006 Holden Commodore SS

1 Answer

1994 holden barina


you need to take the top off to get to the head bolts inside. top is cam cover. then it is the head.

Oct 13, 2013 | Cars & Trucks

1 Answer

Rodeo petrol starts but wont rev


Holden Rodeo 1989 2.6mpi , start and only runs for 2 or so seconds themselves stalls, after putting on a fuel peesure gauge, fuel looked okay and slowly dropping, found the ECM relay was intermittently switching on and off, gave it a tap and the engine kept on running, relay not repairable, replace with new part. Located in the fuse and relay box on the right hand side of engine bay next to battery. Hope this helps.

May 24, 2012 | Holden Rodeo Cars & Trucks

1 Answer

Holden Astra TS 2003 power window problem


The Window Regulator will need to be either replaced or repaired...
You can Buy a Repair Kit, and DIY if you're Mechanically minded...

Jan 14, 2012 | Holden Astra Cars & Trucks

1 Answer

Reverse lights turn off when brake is applied


This would normally mean a loose earth wire to the light , but check the bulbs as well as a bulb with one filament gone can short or earth back through another circuit You can jump a small wire from the chassis to the light assembly body to check

May 16, 2010 | 1994 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Holden Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14338 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...