Question about 2001 Dodge Neon
The starter makes one tick but wont turn over all the sensors are plugged in starter tested good at autozone.
Bypass the switch that prevents starting in any gear but Park. That would interrupt voltage flowing to the starter. It might not be sensing which gear. May be normally open in all gears and closes in Park.
Be sure it is being actuated. First disconnect it and see if the starter works. Then jump it with a pair of clip leads and see if it starts. Check the wiring from that switch to be sure it is connected to the starter relay. Could be as simple as a plug out.
Posted on Nov 29, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: wont start
sounds like your not getting power to the starter. check the connections on the battery and the starter to see if any thing is loose. if not you could try taking off the starter, and taking it to a part store and have them test it.
Posted on Jan 02, 2009
SOURCE: 1999 dodge ram 1500 v8
Something else to check if not starter maybe starter relay is toast and if so it is $25 or less I am Canadian here its $25 US should be much cheaper.
Posted on Jan 15, 2009
check all you r fuses. There should be 2 sets, one under the hood and another in the passenger area(driver side under dash usually)
Posted on Jul 18, 2009
The starter is located under the car where the transmission and engine meet toward the front of the neon. The starter actually bolts up with face toward the transmission. You must get the car up on ramps or on a hoist to see the starter. This is just a general method; it is very hard to give words to describe some of the steps without pictures. Removal: Disconnect and isolate the battery negative cable. Raise vehicle on hoist. Remove starter bolts. Remove starter assembly. Disengage latch and remove solenoid connector from starter assembly. Remove battery positive connector from starter assembly. It is not necessary to remove the alternator output lead from the connector. Installation: Clean corrosion/dirt from the cable and wire terminals before installing wiring to the solenoid. Attach battery positive connector to starter. Ensure alternator output connector is snapped into the battery positive connector. Tighten the captive nut to 10 Nm (90 in. lbs.) . CAUTION: It is critical that the alternator output terminal be connected to the battery positive terminal of the starter solenoid, for proper operation of the charging and cranking systems. Install solenoid connector to starter. Ensure that latch is fully engaged. Position the starter face into transmission housing. Start bottom mounting bolt and thread in until bolt is snug. Attach ground cable to upper starter mounting bolt. Ensure the proper starter alignment before tightening the starter mounting bolts to 54 Nm (40 ft. lbs.) torque. Lower vehicle and connect negative battery cable.
Posted on Jul 13, 2010
Tips for a great answer:
Feb 05, 2016 | 2001 Dodge Neon
Jan 06, 2016 | 2003 Dodge Neon
Oct 05, 2011 | 2001 Dodge Neon
Jun 29, 2010 | 2001 Dodge Neon
May 02, 2010 | 2001 Dodge Neon
Mar 15, 2010 | 2001 Dodge Neon
Dec 16, 2009 | 2002 Dodge Neon
Aug 12, 2009 | 2004 Dodge Neon
56 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: