Question about Hyundai Tucson

1 Answer

Hyundai Tuscan crdi 2ltr crank angle sensor where on the engine is this part

You tube

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 28 Answers

Darren, this is from a 2007. But give it a look. Hyundai Tuscan crdi 2ltr crank angle sensor where  - 25300560-tld3yejbcqcrludchedm25ji-5-0.jpg

Posted on Nov 29, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 121 Answers

SOURCE: We are attempting to change the Crankshaft Angle

crank shaft sensor don't normally go bad on hyundai.do you have a code for this?and what is the complaint?on the v-6 its behind the timing belt.next to the crankshaft gear.on the 4 cyl. its on the front of the block below exh. manifold. and easy to remove.

Posted on Oct 21, 2009

  • 608 Answers

SOURCE: hyundai 2001 accent wont start intermittently.

I'd check the key at the dealership. The battery may be flat in it. Also have the key code match to the CPU checked. The security may be the problem or it may be an electical fault such as sticky starter motor brushes or a dead segment in the starter motor amature.

Posted on Mar 18, 2010

Navmesha
  • 313 Answers

SOURCE: 2006 hyundai diesel CRdi will

immobiliser problem

Posted on Aug 10, 2011

alicantecoli
  • 22114 Answers

SOURCE: Why does my hyundai accent 03 cut out sometimes

Have had this before where it will cut out and then sometimes it will not pick up and it was the mass air flow sensor just by airfilter faulty ,why it shouild have made it cut out i cannot fathom out but it did on this model car and i only know this because i went with the owner of the car to tha hyundai garage to translate and he went straight to the stores and changed the sensor and didnt charge any labour .So he must have have had product knowledge which i didnt because i couldnt cure it thats for sure

Posted on Feb 14, 2012

  • 286 Answers

SOURCE: Engine Problem Hyundai Santa Fe CRDI 4wd 2002

4. Head gasket!! Check the oil and see if it's way overfull or has a milky color to it. All your symptoms are indicators of a head gasket problem

Posted on Apr 23, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2.0l Can cam sensor affect both fuel injectors and spark?


Yes cam sensor can have that effect. The management system needs to know which stroke the timing cylinder is on - the crank sensor supplies information about crank angle and the cam sensor tells it which stroke it is on.

Mar 27, 2016 | 2004 Hyundai Tiburon

1 Answer

My Hyundai Accent 2005 CRDi cold starts perfectly, after running to few kms if i stop for a while say for 15 mins it doesn't starts at all. It require at least 1 hr to start it again.


You need to scan the ECM to see if there are any stored DTCs. Just guessing, it sounds like a bad cam or crank sensor. They can be temperamental when they get warmed up, if they are bad.

Mar 31, 2015 | 2005 Hyundai Accent

1 Answer

Engine won't start but it crank.The diagnostic found injector low pressure. Injector 1,2 is leaking, It is possible that we replace injector's and cam shaft sensor too for hyundai santa-fe CRdi..any h


what code was that? fuel pressure regular is probably the culptrit theres a guage to check the pressure looks like a compression dial on the face

Dec 22, 2014 | Hyundai Cars & Trucks

1 Answer

Cranks but wont start


May have dirt on crank angle sensor ,loose/damaged. Located usually close to bottomf pulley on engine.. Remember to keep it simple and check for the obvious first (fuel/pump? is emergency shut off tripped accidentally from towing ? Turn ignition on and have someone listen at fuel neck for pump operation. Check all fuses.

Aug 31, 2009 | 2006 Hyundai Sonata

2 Answers

Hyundai Excel 97 will not start, cranks well.


I finally traced my similar problem to a broken wire into the plug going to the crank angle sensor which on this animal is located at the front of the motor on the right hand side when looking at the motor from the front. It is just below the clutch slave cylinder and is held in place by a 10mm headed bolt or phillips head (posi drive) bolt.
Good place to start.
franknpeg

Apr 18, 2009 | Hyundai Excel Cars & Trucks

1 Answer

We are attempting to change the Crankshaft Angle Sensor and struggling with what all needs to be taken off of the engine to get to the bottom of the sensor. 2004 Hyundai Sonata.


crank shaft sensor don't normally go bad on hyundai.do you have a code for this?and what is the complaint?on the v-6 its behind the timing belt.next to the crankshaft gear.on the 4 cyl. its on the front of the block below exh. manifold. and easy to remove.

Apr 11, 2009 | Hyundai Motor 2004 Sonata

1 Answer

Check engine light is on


remove positive battery for five minutes to re set the computre hook it back it should go out

Jan 05, 2009 | Hyundai Motor 2004 Sonata

3 Answers

1998 Hyundai excel. Engine stops when car is warm and will not restart until engine cools down. Seems to loose spark.


Thanx, have fixed the problem now... wasn't the computer lol. It was the crankangle sensor.... thank you all for your help.

Nov 01, 2008 | 1992 Hyundai Excel

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...