Question about Dodge Ram Pickup 2500

1 Answer

Key not detected ram 2014 pickup if the alarm works

I lost the key to my pickup ram , programmed the new key and alarm only works , but not detected to turn on, on the screen says not detect the key

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 149 Answers

Make sure that your cellphone is not too close to your key fob.

Reset the computer by getting out of the truck & shutting the door; get back in, & try starting it.

Posted on Nov 29, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Brian032472
  • 150 Answers

SOURCE: Cannot turn off security Alarm

If this is a factory alarm try using the the key in the door lock and turning the door lock manually. I have seen this issue in chrysler models as well. If this does not work try replacing the batteries in the key fob as this will cause falfunctions as well.

Posted on Nov 02, 2008

  • 186 Answers

SOURCE: saturn won't start/ key problems

You need to program the system,it's probally in theft deterrent mode & disables the starter.To program your new remote locate the diagnostic connector under the drivers side of dash.To program the new remote Jumper a paper clip between the #4 & #8 terminal you will hear the locks cycle & the trunk will pop.While the terminalsv are jumped hold down lock & Unlock on the remote at the same time until you hear the locks cycle again,remove the jumper wire or paper clip & you should be good.

Posted on May 19, 2009

  • 169 Answers

SOURCE: Having a challenge programming a 1999 Lexus RX 300 newly cut key.

did the lock smith cut key with resister in in maybee not gotta go to dealer get one cut then put old key in start car then turn of remove key put new key in turn on till security light goes out then start car

Posted on Aug 29, 2009

  • 1 Answer

SOURCE: how to disarm alarm system

REMOVE THE DRIVERS SIDE KICK PANEL,PULL THE WIRE PACK OUT,THERES APURPLE WIRE WITH A YELLOW STRIPE.......GROUND IT OUT!! THATLL KILL YOUR FACTORY ALARM

Posted on Jan 20, 2010

emissionwiz
  • 76673 Answers

SOURCE: Key Card is not being detected. Had key card checked and it is ok.

You need to reprogram the key card

Posted on Sep 13, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Lost car key and fob,I have the valet key but starts for a few second then shuts down and alarm goes off How can I disarm the alarm?


The Valet key is not is not a ignition key only men't to open the trunk ect. your dealer can replace and program a new key for you.

May 24, 2016 | Cars & Trucks

1 Answer

2004 INFINITY G35 REPLACED ENGINE. LOST FOB. ALARM GOES OFF AND CAR WILL NOT START. HOW CAN I BYPASS ALARM


the alarm will be deactivated by key in door lock unlock, the no start is not alarm, check security red led is on, indicating key programing needed

Sep 23, 2015 | 2004 Infiniti G35 Sport Coupe

1 Answer

How to disable internal alarm on 99 Passat


You need to get your new key programmed

Jun 06, 2015 | 1999 Volkswagen Passat

1 Answer

My remote for alarm is broken how can I disable the alarm


When the anti theft system was created,the dealers forgot to tell the new car buyers about how much the fob matters to the vehicle,without it,owners are stuck,your anti theft device is activated,you need to lock and unlock your doors a couple times with the key fob,not the key,and then you need to put the key in the ignition and start it,if you dont have your key fob,call your car dealer to get a new one,they are programmed for each car only,you cannot bypass it.if you lost your fob or never had it,whatever,you need to have the exact fob that came with that car from the factory,the key and fob have a chip in them that only go to that certain car,if you do not have it,then you need to buy a new one from the dealer or ebay and then you need to contact your dealer about programming the fob to your car,you might not have to have it towed if they have the documents from the car,the only other way is to get a junk car,with the steering column,key,fob and all computer boxes and door locks and switch them,i just did that with a 98 dodge dakota,and it works.

Mar 29, 2015 | 2004 Dodge Ram 1500

2 Answers

What is the procedure to reconfigure a new key in a pickup ram 2014


You need two keys already programmed. If you do not have them dealer or locksmith has to do it.

Dec 01, 2014 | Dodge Ram 2500 Cars & Trucks

1 Answer

Key undetected ram pickup 2014


Sounds like an incomplete configuration procedure. Did you do this yourself or did you have the dealer do it? There may be a difference between configuring the wireless fob and allowing the vehicle to learn the new transponder to overcome the immobolizer.

Nov 29, 2014 | Dodge Ram 2500 Cars & Trucks

1 Answer

Lost key and alarm dodge caravan


to reprogram new key first you need to use 2 factory program keys.place first factory key in the ignition first turn ignition on for 3 seconds. then turn off ignition then install second factory in the ignition on position for 10 seconds.when immobilizer warning lamp begins to flash a acoustic signal is emitted.within 60 seconds. switch ignition off and remove key.then insert new key and switch on for 10 seconds a acoustic signal is emitted and immobilizer warning lamp remain illuminated for 3 seconds indicating programming completed.if all fails dealership has to reprogram new keys.

Dec 17, 2012 | 2000 Dodge Caravan

1 Answer

Peugeot 206 key fob


Try with brand new key fob battery and see.If that helps.
Otherwise May be keyfob needs to be reprogrammed.

KEYFOB PROGRAMMING


Keyfob remote reprogramming is not very difficult but on some cases it can be done by dealer service tools.

If the remote s faulty then key fob will not get programmed.

Insert the key in ignition. Turn the key to on position, and cycle the key three times off-on-off-on-off-on. Then with the key fob remote select your remote and then try to operate the vehicle with remote.

These are just the basic procedure, but sometimes it will not help.

On that case dealer is the only option.


---------

There are few much related troubleshooting links mentioned below for remote key fob reprogramming. I suggest you to go through the list and click the link below to go through its details and procedure: -------

2009 Toyota Highlander: Smart Key Not getting Detected?

http://whatisbyme.blogspot.in/2012/05/2009-toyota-highlander-smart-key-not.html


----------

2007 Toyota Prius: Reprogram Remote Keyfob?

http://whatisbyme.blogspot.in/2012/05/2007-toyota-prius-reprogram-remote.html

-----------

Pin that holds the flick key part to the key fob?

http://whoisbyme.blogspot.in/2012/07/pin-that-holds-flick-key-part-to-key-fob.html

-------------


2006 Toyota Hilux: Programming New Key?

http://technoanswers.blogspot.in/2012/04/2006-toyota-hilux-programming-new-key.html

----------

Where is Key chip memory located on 2004 ford Freestar?

http://technoanswers.blogspot.com/2012/01/where-is-key-chip-memory-located-on.html

----------

Ford Keyless Remote Fob Reprogramming?


http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html

----------

After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?

http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html

-----------

Audi A8 Key Fob Programming?


http://technoanswers.blogspot.com/2011/12/audi-a8-key-fob-programming.html

----------------

Oldsmobile Aurora Key Fob Reprogramming?

http://technoanswers.blogspot.com/2011/12/olds-aurora-key-fob-reprogramming.html

-------------

Buick Lesabre Key Fob Reprogramming?

http://technoanswers.blogspot.com/2011/12/buick-lesabre-key-fob-reprogramming.html

---------------

Keyfob remote not working on 2003 Ford E350 Econoline?

http://technoanswers.blogspot.in/2012/01/keyfob-remote-not-working-on-2003-ford.html

-----------

KeyFob will open the doors but not start on BMW?

http://technoanswers.blogspot.in/2012/02/key-will-open-doors-but-not-start-on.html

------------

Mitsubishi Car Key Not getting detected after replacing ECM

http://repairhelpcenter.blogspot.com/2012/11/mitsubishi-car-key-not-getting-detected.html

-----------

Key Fob will not lock and unlock doors?

http://technoanswers.blogspot.in/2012/02/key-fob-will-not-lock-and-unlock-doors.html

-------------

2000 Jeep Cherokee Limited: KeyFob Remote Not Working?

http://schematicsdiagram.blogspot.in/2012/06/2000-jeep-cherokee-limited-keyfob.html

-----------

Chevrolet Malibu: Key Stuck in ON position?

http://technoanswers.blogspot.in/2012/04/chevrolet-malibukey-stuck-in-on.html

-----------

Theft indicator not letting car to start?

http://technoanswers.blogspot.in/2012/02/theft-indicator-not-letting-car-to.html

-------------

2012 Dodge Ram: Ignition Key will not release?

http://whoisbyme.blogspot.in/2012/07/2012-dodge-ram-ignition-key-will-not.html

--------------


These details will help.

Thanks.

Nov 28, 2012 | Peugeot Cars & Trucks

1 Answer

Program new key


there is a special tool to program it, unless you have two valid keys.

Mar 25, 2010 | 1999 Jeep Grand Cherokee

1 Answer

1198 Dodge Ram Pickup


it sounds like you may have an aftermarket alarm system. it can be removed completely from the vehicle. if it is a factory system the key fob or unlocking the door wit the key should disarm the system. if they dont you may want to have a dealer or reputable shop check the system

Oct 12, 2008 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8522 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...