Question about 2008 Chevrolet Impala
If you have repaired them and the lights are still on, they need reset with a code reader. If they haven't been repaired, the lights will just come back on.
Posted on Nov 29, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you'll have to have it diagnosed at a repair shop to pinpoint the source. sorry, but thats how they make them. you could buy your own but it'll cost about 200$
Posted on Jul 01, 2009
The ABS sensor is a speed sensor also for Traction Control. This is why both lights are on , One of your front ABS sensors are bad or disconnected, or has a pinched wire.
Posted on Jan 16, 2010
You'll need to have the codes read from the computer. You will have a code that indicates one of the front wheel sensors is bad. This could be the case, but they are very expensive as they are built into the wheel bearing assemblies. It is more likely that the wiring harness between the frame and the part of the front spindle that holds the harness, has broken internally. It is a very common problem and can be repaired with a new wiring harness section or by tracking down the fault and repairing it.
Posted on May 31, 2010
Traction control only works when one wheel is spinning faster than the other it trys to even them out so it wont spin...sometimes if one of the wheels come off the ground in an uneven area or if you take a turn too fast and one wheel turns when the other one dont it is designed to operate.
I would remove all wheels and check the braking system...Is it 4 wheel disc or rear drum ?
If it has rear drums you could have a wheel cylinder leak that will sometimes lock the wheel because of fluid contamination....This would cause both lights to come on...If you find no problems
sometimes the abs sensor builds up fragments on the magnet and makes the light come on...
or if the abs sensor is not close enough to the exciter ring it will make the light come on because it will be out of adjustment.....all you do is press the sensor inward until it barely touches the ring and it will adjust itself....You can sometimes clean the magnet if it is contaminated and make the light go off ( only after you reach 6 to 15 mph. it will go off ).If it dont go off you have to buy a sensor.
Also make sure all tires have same amount and plenty of air to keep vehicle in balance/level.
Posted on Feb 21, 2011
Tips for a great answer:
Feb 03, 2016 | 2001 Buick LeSabre
Jul 20, 2015 | 2008 Chevrolet Impala SS
Nov 28, 2014 | 2008 Chevrolet Impala
Jul 28, 2014 | 2008 Chevrolet Equinox
Jul 20, 2014 | 2001 Chevrolet Impala
Oct 30, 2009 | 1997 Acura CL
Jan 13, 2009 | 2000 Chevrolet Impala
Dec 04, 2008 | 2002 Chevrolet Impala
160 people viewed this question
Usually answered in minutes!