Question about Cars & Trucks

1 Answer

I have a four 350 v 10 2003 my ABS light comes on it feels lack I have no breaks.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,368 Answers

Probably an ABS module failure. Before somebody can help you you need to give us the make and model number. You have the unit and know what it is, we don't.

Posted on Nov 29, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Murphybanton
  • 2004 Answers

SOURCE: abs and t/c lights are

When there is such a feeling, it is the brakes that needs total replacement.

Also you might have to check the master brakes for any leaks. And you need to check the bushing rubbers on the steering rack too.

Be careful and fix this on time.

Rate this solution.

Posted on Sep 08, 2009

dmsr63
  • 2050 Answers

SOURCE: ABS and trac off lights come on periodically

Sounds like a wheel sensor is bad. It monitors the speed of your wheels. A scanner hooked up will tell.

Posted on Feb 04, 2010

redbeard00
  • 957 Answers

SOURCE: I have a 2002 sierra gmc 4 x 4, when I come to a

This is a common problem with these trucks. You will need to set-up an appointment with the service Dept. at the dealership. There is an update for the ABS system. The function of this update is to reduce the sensitivity. When you get down to five MPH (with the brake applied) the ABS turns on (no light on dash) and you get the sensation of Sliding (braking is reduced).
This is assuming that the tires are the same size and pressure, And that there are no defects in the wheel speed sensors. Good-luck and please let me know what you decided to do and how it went.

Posted on May 15, 2010

  • 12104 Answers

SOURCE: ABS problem with GMC 2002 Sierra

its a low speed abs activation the problem is in the front sensors they need to be cleaned or replaced they [or one] probably has some corrosion on the sensor --[the 99 chevy tahoes had a limited recall over this issue and the fix was to remove and clean the abs sensor or if to corroded replace ] this problem doesnt set off an abs code or trouble light also sometimes the abs will activate by itself at under 4 mph without even touching brake

Posted on May 15, 2010

billio0104
  • 72 Answers

SOURCE: abs light and engine light

if the pedal jerks when you are applying the brakes, then the rotors are probably out of round

Posted on Oct 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tahoe speedomoter abs break light on


More than likely you have a bad speed sensor on the transmission. If that goes bad it will make the needle bounce and give you false readings. The brake system sees this information and tells the computer something is wrong. The ABS system has monitors on all four wheels that measure wheel speed. Also at worst if your cluster is bad it will do the same thing. Start with the easiest less expensive part. There are tests you can run too but you will need a service manual. Good Luck.

Jul 21, 2012 | 2003 Chevrolet Tahoe

1 Answer

The abs light comes on, and the car vibrates when breaking.


the ABS light indicate that there is one of four speed sender have disconnect . first check if all wheel bearing is ok and tigh no loose from the middle nuts ( for axle end or hub rear side ) second all sensor are ok (reach the sensor ring)no disconnect cable . if your indicator light is yelow .in case it;s red you have to check ABS pump stuck

Jul 10, 2011 | Volkswagen Jetta Cars & Trucks

2 Answers

I have a BMW 1999 wagon with 64,000 mi . It runs great and I feel no apparent break problems. But... the ABS break light comes on with the triangle (caution) with the circle arrow with the exclamation...


The ABS brake light will go on whenever it doesn't see a signal coming from the wheel speed sensor on any of the 4 wheels.

May need to have it scanned for ABS Brake codes to determine which wheel is affected.

Aug 16, 2010 | 1999 BMW 323 Series

2 Answers

Audi ABS breaking system error


if the ABS fault light comes on as you turn on the ignition and control unit can't be accessed with a fault reader then the control unit itself is faulty and must be repaired or replaced. if can be accessed, should store a fault in the memory, most probably in a wire to wheel speed sender. if light comes on only after vehicle is in motion than fault will be a dirty or incorrectly adjusted speed sender.

May 15, 2010 | 2001 Audi A4

1 Answer

ABS problem with GMC 2002 Sierra


its a low speed abs activation the problem is in the front sensors they need to be cleaned or replaced they [or one] probably has some corrosion on the sensor --[the 99 chevy tahoes had a limited recall over this issue and the fix was to remove and clean the abs sensor or if to corroded replace ] this problem doesnt set off an abs code or trouble light also sometimes the abs will activate by itself at under 4 mph without even touching brake

May 15, 2010 | 2002 GMC Sierra

2 Answers

Abs system


it is a failed wheel bearing.the hub and bearing comes with an abs sensor and when the bearing could not be located by the sensor it will turn on the abs light and make the car skip when braking.check to see if your not missing any brake fluid and that the truck is still able to brake.if all is good then change the faulty wheel bearing.if you dont want to invest right away just disconnect the connector for the abs to the bearing.braking will feel normal and youll just have the abs light on.

Oct 04, 2009 | 1999 GMC Jimmy

3 Answers

Abs and t/c lights are on have had full break job done both front and back wheel sensors are working but when coming to a slow stop I feel the car start to grind like if it needed breaks I can feel this...


When there is such a feeling, it is the brakes that needs total replacement.

Also you might have to check the master brakes for any leaks. And you need to check the bushing rubbers on the steering rack too.

Be careful and fix this on time.

Rate this solution.

Sep 08, 2009 | 2005 Chevrolet Equinox

1 Answer

"Chk Trac light" on 2000 Lincoln Town Car


MAKE SURE TIRES ARE ALL THE SAME SIZE FIRST OF ALL,NEXT MAY HAVE A SPEED SENSOR NOT OPERATING PROPERLY OR BENT OR MISSING EXCITER RING ON FRONT HUB OR REAR AXLE. EITHER WAY THERE IS AN ABS FAULT OR A DIFFERENCE IN WHEELSPEED ON ONE OF THE FOUR WHEELS CAUSING TRAC LIGHT TO ILLUM. VEHICLE THINKS YOU ARE LOSING TRACTION AND APPLYING ABS AND MISFIRING VEHICLE TO SLOW DOWN UNTIL TRACTION IS RECOVERED

Jul 19, 2009 | 2000 Lincoln Town Car

1 Answer

1994 Audi 80 2.0 ABS Light Comes On then Engine Cuts Off


abs fault if you feel it though the pedal its activating, it should not activated, you will probably need to replace the abs unit as it would be the valve in the pump. engine cuts out as its found a fault.

Jun 07, 2017 | 1992 Audi 80

1 Answer

2004 jeep cherokee


sounds like a ABS sensor is out, one sensor can throw off your computer. Get the code red at Autozone for free.

Jun 25, 2008 | 2001 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...