Question about 1999 Jeep Cherokee
The problem lyes in your shift cable .maybe lubed but should be replaced
Posted on Nov 29, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The tail lights and the brake/turn lights use the same bulb but, there is 2 filamants in the bulb. One for tail lights and one for brake/turn lights. So just because the brake lights and turn signals work doesn't mean the bulbs are good. If bulbs are good you can check to see if there is power getting to the tail light assy's by unplugging the connector at the assy and using a test light probe the connector (harness side) with the headlights on. If you are getting power to the assy the test light will light. To make sure, turn off the headlights and test light will go off. Hope this is helpful. Good luck.
Posted on May 29, 2009
this sounds like the recirculation door in the heater box is broken and this is a difficult and can be an expensive repair as the dash has to be removed for access. a quick check for this is if you release the glove box and let it hang you will see the heater box if you reach up to the left top you will feel a grid and the recirc flap is housed there you can operate the blower and hot and cold and see if flap moves
Posted on Jun 22, 2009
There are two parts to it, a voltage resistor, and the EL panel itself.
You need to remove the console first. There are 2 screws under the front rubber pad, two under the cup holder, two in the bin. Remove those six first, take the storage bin out, then slide the rear cupholder out, remove the two screws under the cup holder, and one in front of it.
There are a total of 6 flat screws, and 3 self tapping screws you have removed.
Put the parking brake on, shift the tranny to N, and the transfer case to the middle position if equipped.
Remove the entire console. Slide the shifter beezel as far up vertically as you can. There are 4 clips you ned to remove to do it.
You will see a blue and black wire running into the back. Follow those wires to the resistor. You will see a transparent EL panel attatched to the resistor by two clips.
Usually, one or both of these clips has come loose, causing the light to work intermittantly. Clip them back on, and turn on the headlights to confirm that the light works correctly now.
Re-install everything in the opposite order.
Posted on Oct 11, 2009
Tips for a great answer:
Dec 17, 2013 | 1998 Jeep Grand Cherokee
Dec 16, 2012 | 1999 Jeep Cherokee
Jan 30, 2011 | 1994 Jeep Grand Cherokee
Dec 10, 2009 | 1999 Jeep Grand Cherokee
Dec 04, 2009 | 1999 Jeep Cherokee
Jan 22, 2009 | 1999 Jeep Cherokee
Jan 11, 2009 | 1999 Jeep Grand Cherokee
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: