Question about Cars & Trucks

1 Answer

How do I access a copy of the manual for Motomaster Eliminator 700A Booster Pack?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Go to Canadian Tire store or online

Posted on Nov 28, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I replace the power brake booster? I am looking for a link to a service/repair manual, even a Chilton or Haynes book would do! Local auto parts stores didnt stock them.


25960073-j3ypv2wzqhzzlgvrg3bd11qz-1-1.jpg This is pretty much what the booster looks like. The brake master cylinder is connected to the two studs on the left. You only need to remove the studs and pull the master cylinder aside, being careful not to damage the brake lines. There will be a vacuum line attached to the engine compartment side of the booster as well. This must be disconnected. The rod extending from the bellows on the right is inside the vehicle and it connects to the brake pedal with a clip of sorts. Remove the clip and disengage the rod. Then, remove the two nuts holding the booster to the firewall (on the studs facing to the right, and pull the booster from the engine side. Installation is done by reversing the process.

Nov 14, 2015 | 2011 Mazda CX-9

1 Answer

Why does booster pack not charge


The batteries go bad over time just like a car battery does. Just had to replace one on my booster.

Oct 20, 2014 | Cars & Trucks

1 Answer

Battery for 07 CTS is dead. Now I can't take key out of ignition. What shall I do?


you have to replace the battery to get the key out or use a booster pack under the hood. there is a red and black jumper post under the hood you can hook a booster pack to and then once that is hooked up you can remove the key from the ignition

Sep 06, 2011 | 2007 Cadillac CTS 3.6L

2 Answers

Flat battery on my bentley flying spur how to open boot


There should be a red "+" point under the hood. Connect jumper leads or a booster pack to this point and a good earth point on the chassis or engine block and use the remote key fob to open the trunk.

Jan 18, 2011 | 2006 Bentley Flying Spur

3 Answers

I've been told by a Porsche dealer,that you should not jumpstart from another car battery( like we've all done with our first old cars some 40 years ago) and that I should use a booster pack! I have a W...


The booster pack has a lower amperage ability and will not allow you to cross connect the jumper cables and possibly fry you electrical system. Simply saferand usually idiot proof

Jan 10, 2011 | 2002 Porsche Boxster

1 Answer

What battery should be bused asb a replacement


Any battery unless you have upgraded equipment/electronics. I can tell you what battery NOT to get, Motomaster or Eliminator. I have replaced more of these than I can count. Go with one that has a good warranty and/or Roadside assist

Jan 10, 2011 | 2000 Chevrolet Tracker

1 Answer

Battery seems to be dead. How to replace it, and which one?


Its quite ez to replace. The big question is with what brand. It all depends how much u want to spend. Optima Batteries are the best but a little pricey. Interstate, Die Hard & similar brand are a bit less but still durable. Look for warranty & roadside assistance. I would stay away from Motomaster or Eliminator batteries. I have replaced many of these! If they didnt have warranty, Id never get another one!

Jan 10, 2011 | 2003 Saturn L-Series

2 Answers

Replacing a battery on a 2003 Nissan Sentra


if you have access to a booster pack, hook it up to the battery cable terminals before starting, this will keep power in the car and prevent you from losing your radio memory etc. the battery should be held down by 2 10mm bolts on threaded rods - loosen one, and remove the other and swing the hold down out of the way. loosen and remove battery terminals - first negative, then positive. remove battery. if the there is any corrosion on the cable terminals, clean it off now with a wire brush. put new battery into position. reconnect terminals and tighten - first positive then negative. remove booster pack (if you are using one). reposition battery hold down and tighten nuts - not too tight, just enough to hold the battery steady. if there is a plastic case around the battery, don't forget to put it around the new one. if you have one, and it does not fit the new battery (this is common), don't worry, its not really a necessary item, they typically get thrown away. good luck!

Apr 05, 2010 | 2003 Nissan Sentra

1 Answer

Can not access my 1990 Jaguar soveriegn due to flat battery


the key should open the door without any batt power central locking is batt , the key should open both front doors!!owered so it should not be a problem !

Jan 24, 2009 | 1990 Jaguar XJ6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

784 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...