Question about 2003 Oldsmobile Alero
I have the part but can not locate where the sensor is or where it is? I do not if it is in the oil pan or near it
The level sensor should be in crankcase oil pan, if you have one. Your not talking about oil pressure sensor, correct?
Posted on Nov 28, 2014
Most if not all are visible from Oil Pan , you will have to search fom under neath car with good flashlight . Often wires become heat damaged cracked /oil soaked or The O Ring sealing unit to Pan Leaks = = False reading . But reason to trigger code / trouble light is often due to heavy footed acceleration when engine is actually low on oil . Be sure to unplug Negative battery cable 30 minutes to reset code reading - - YOU May Not Need New Part if reset clears code now that oil is FULL or if recently changed all newer GM models must have a reset to tell %#$@$$&^$$$ computer oil was changed . ...Hope above helps save $$$ by not installing new part ..
Posted on Nov 28, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is no V8 Oldsmobile Alero 2003 and 2007 Olds Alero
for V6 Olds Alero 2003
Valvoline / 1 gal. SAE 10W-30 All Climate Motor Oil
Pennzoil / 1 gal. SAE 10W-30 Advanced Protection Motor Oil
Any Brand Syntetic Motor Oil SAE 10W-30
The same for 4 cylinder
Posted on Jan 14, 2009
cant help with this one because i have never seen one here in spain,but look for engine oil dipstick first then the auto is often close by ,but some cars dont have one its done from underneath
Posted on Mar 16, 2009
It is located in the exhaust manifold between the front of dash and the engine. Its a little difficult to get to and requrires a special wrench to remove it.
Good luck, let me know.
FIG : HO2S1 (Bank 1) location on 2.2L (L61) engines (exhaust manifold heat shield removed) CLOSE X
Posted on Mar 29, 2009
I have a 2001 Oldsmobile Alero, Its located behind the hazard button to the right of the speedo cluster. If you have a clicking noise as if your turn signal was on or hazard buttons pressed. Its not your flasher problem. I had to tear apart half the dash and found out that was not problem. Its the turn signal/ wiper switch located on top the steering column. Its very easy to change. The top piece above the turn lever and wiper lever just snaps out. One torx screw holds it in. Unscrew then lift up there are a few wire plugs in the back. Lift up on the wire tabs and pull plugs out. Reverse order to replace with new part that I bought from Napa auto parts for around $150. You can do this if you have very novice skills and 1 torx bit tool. If can help in any other way, just let me know and good luck.....YOU CAN DO IT!!!!
Posted on Sep 15, 2009
Tips for a great answer:
Nov 08, 2015 | Cars & Trucks
Dec 01, 2011 | 2001 Oldsmobile Alero
Sep 16, 2011 | 1999 Oldsmobile Alero
Apr 14, 2011 | 1999 Oldsmobile Alero
May 10, 2010 | 1999 Oldsmobile Alero
Mar 18, 2010 | 1999 Oldsmobile Alero
Mar 16, 2009 | 2003 Oldsmobile Alero
122 people viewed this question
Usually answered in minutes!