Question about 2000 Ford Windstar

1 Answer

Best way to remove transmission

Remove suspenion

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 14,394 Answers
Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When van goes over 50 mph, van shake bad.


The best solution to your problem is to see if you need new rotors,brakes,shocks,and suspenion,rocker arms. I have a regency elite 98 oldsmobile that did the same thing.

Mar 10, 2011 | 1994 Oldsmobile Silhouette

1 Answer

Air suspenion light says air suspenion is off how do i turn it back on 2 0007 expedition eddie byer 4 wheeh drive


If you recently had your vehicle serviced, it is a safety practice to turn off the suspension. The switch should be located behind a small access panel in the cargo area of your Expedition. The switch is usually on the Drivers side and paired up with the fuel pump Inertia switch. If you do not see it on the rear quarterpanel interior panel, try the passengers side. Do not confuse the solid plastic access panel with the Stero speaker cover.

A second type of control appeared in 2007 in Navigators. Yours is a sister vehicle. The off/on controls can be in the message center and you toggle the controls with the dash buttons.

The air suspension does have a fuse, but usually this does not break unless there is a problem. You can take it to a repair facility having a Air Suspension scanner, which can diagnose a hidden problem immediately.

Jan 27, 2011 | 2007 Ford Expedition Eddie Bauer EL

1 Answer

Honda Has 110000 miles whatmantaince should be done


90.000 mile maintenence should be done ,replace timing belt, check suspenion, check or change transmission fluid and filter, change oil and filter, check wheel bearings, rear wheel bearings, brakes ,calipers, rotors, fuel filter, battery, lube all joints,hope this helps and thank you for choosing fix ya.com need phone support? need live chat? all is available through fixya.com

Jan 01, 2011 | 2005 Honda Accord

1 Answer

The suspenion was raised will this cause the jeep to sway from side to side i have agran cherokee


When any vehicle is raised, it adversely changes the roll center. since the suspension stays at pretty much the original height, that will cause the body to roll on turns, especially in vehicles with coil springs.
It is my opinion that vehicles should never be raised, but if clearance for a slightly larger tire is needed, 2" should be the max allowed. (except on true off road vehicles that are not street driven).
Aside from removing the lift kit, your best option would be to get a pair of heavier (larger diameter) sway bars and a set of shock absorbers that not only match the new height but have larger piston diameters with slightly "stiffer" valving.

May 23, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Need to find out if I have a numatic suspenion or


give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local Volvo dealership in the parts department and they be able to tell you wish you the best of luck Michigan Man.

Feb 23, 2010 | 1999 Volvo S80

1 Answer

Need to know how to remove the drive axle and hub from the right side of the transaxle of my 2000 Chrysler 300M


You will have to take off the wheel and then rent or buy a axel socket and break that loose then remove the lower ball joint that has the lower part of the suspension connected. Then take off the lower suspenion assembly from the part that was connected from the lower ball join. After that swing it to the side which lets your have just enough space to remove the drive shaft. Please make sure that you drain your transmission fluid first so you don't have 2 or 4 litres of mess laying on the ground.

Good luck!

Aug 07, 2009 | 2000 Chrysler 300M

1 Answer

Suspenion line has a hole rubbed in it can it be fixed


If it is a air suspension line, fix it with a compression fitting.

Feb 28, 2009 | 2002 Cadillac Deville

1 Answer

99 dodge durango ball joints


Please take this to a shop!! Your life as well as others could be in danger! This is a very major part of the suspenion that could be cause an accident!! Frankster016


Nov 30, 2008 | 2001 Dodge Durango

Not finding what you are looking for?
2000 Ford Windstar Logo

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5581 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...