Question about Cars & Trucks

1 Answer

Would the crank scenor help me on a 2007 pt crusier? With the starting problems?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 88 Answers

It could, the car will not start with a failed CPS because the ECU cant recognize the position that the crankshaft is in.

Posted on Nov 28, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
polarcycle
  • 1392 Answers

SOURCE: replace crankshaft sensor

Crank sensor on that car should be located near the pulley end of the motor, and near the firewall side. Fairly easy to get to.

Posted on Mar 06, 2009

JShreader
  • 50 Answers

SOURCE: NEED WIRING DIAGRAM FOR 2002 PT CRUSIER STARTER

Hello chk614, my name is JShreader. Thank you for choosing fixya.com.

Here is a picture showing the Wires connecting to the Starter...
42ff1ef.jpg
If you are looking for the formal Wiring Diagram...see below...
8f3c163.jpg
I hope this helps you. If you have any more questions or need any more diagrams, please don't hesitate to ask...Thanks again, JShreader!

Posted on Apr 01, 2009

  • 295 Answers

SOURCE: 2001 PT crusier sunroof will not close, motor must

The motor is gone and the switch could be gone too.

I would replace both to be on the safe side.
The switch is not that expensive. The motor is more expensve.

Posted on Apr 04, 2009

  • 6982 Answers

SOURCE: my 2001 PT Crusier has started "popping" out of

Most times that will only happen if the shift rail isn't adjusted right or if the internal fork that moves the synchro or the synchro itself is worn, all of the above preventing complete gear engagement. If all other gears are normal it's safe to assume that the problem is inside the transmission.

Posted on Jul 01, 2010

goldenglove1
  • 144 Answers

SOURCE: my 2001 PT Crusier will

It could be an ignition switch, ignition coil, starter, (most likely) or starter solonoid.

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put a water pump and a timming belt on 2002 pt crusier and it takes a while to crank and is sound bad


dont start it again until you can verify that the belt was installed properly and cams are in sync

Apr 19, 2017 | Cars & Trucks

1 Answer

2007 pt crusier will not crank after it has been run. Will not turn the starter over. Please help


Make sure battery has a full charge and battery connections all good, voltage and ground. Just about anybody answering questions here can tell you how to jump the starter motor, just to see if engine will crank? That doesn't mean it will start, that depends on the problem?
Make sure tranny is in park or neutral and parking brake is set. Safety is your responsibility. Remove starter relay, use jumper wire between terminals 1 and 4 in diagram. Terminal 1 should be hot the time. That should send voltage to starter motor and crank the engine.
I can't tell you what is wrong unless you can do some testing?
26336859-n0c3vcn2one5jjqic2gkdfxl-2-0.jpg

Nov 01, 2016 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2002 pt crusier won't crankoverbrake and engine lights come on


if the motor does not crank and the dash lights come and other lights . check the starter or starter relay

Jan 27, 2013 | Dodge Cars & Trucks

1 Answer

2001 pt crusier all lights shut off while driving at night


Have GM fix problem on lights. It's a common problem as is the transmission pin breaking. GM knows it but we have to pay??? Bad bad bad?....

May 22, 2012 | 2001 Chrysler PT Cruiser

1 Answer

2007 non turbo 2.4 pt crusier automatic some times it wont shift into gear it gets to 2 and half rpms and the car will ****


will it go over 2500rpm in neutral? if it will then it sounds like a throttle problem if so check all linkages, check air intake system is sealed. ask a dealer to have a look if all else fails

Nov 09, 2011 | 2007 Chrysler PT Cruiser Touring Hatchback

1 Answer

Replace crankshaft sensor


Crank sensor on that car should be located near the pulley end of the motor, and near the firewall side. Fairly easy to get to.

Mar 06, 2009 | 2003 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...