Question about Toyota Camry

1 Answer

My car runs but after a while black smoke and stall?

Changinging computer box nd air flow meter

Posted by on

  • deanyoung
    deanyoung Nov 27, 2014

    1988 toyota camry gasoline 4cylinder

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 3,368 Answers

You need to give more information such as model.

Posted on Nov 27, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The vehicle reads DTC P0506 and the air bag and ETS OFF lights are on. What's wrong?


Check to see if there is any hoses disconnected causing vacuum leaks. This will cause a stall and idle issue. Make sure there are no electrical plugs disconnected or loose in the area you were working. If all ok, what did you use to clean throttle plate? Only carb cleaner I would hope

May 11, 2015 | Cars & Trucks

1 Answer

I have Hyundai i10 three was facing some problem when starting car have black smoke and scan the car fault code is p0171 pls give some solution


CAR IS RUNNING TO RICH ON GAS.
CHECK FUEL PRESSURE FIRST.
CHECK INJECTORS SECOND,
CHECK SPARK PLUGS THIRD.
CHE MASS AIR FLOW METER HOSE FOR BROKEN INTAKE HOSE.
CHECK MASS AIR FLOW METER,
CHECK OXYGEN SENSOR AND WIRES.
CHECK TEMPERATURE SENSOR FOR THE RIGHT VALUES, COUL BE OPEN.

May 22, 2014 | Cars & Trucks

1 Answer

Audi a4 tdi 2002 smoke and idle problem


The battery in a 2002 Audi A4 is located at the rear of the engine compartment (back near the windshield) & has a tie down requiring a 6mm Allen wrench to remove it.----------------------------------------------------------------------------------------
auto HID Xenon light

Jan 15, 2013 | Cars & Trucks

2 Answers

My car shut down wen im driving alot wen im at the lith 1996 mazda 626


have you checked if your air filter is blogged? since you removed the air flow meter and run ok means that the flow of the air is wrong read and the ECU is causing shut off the engine. Check also if the air flow meter itself is not working correctly.

Sep 26, 2012 | Mazda 626 Cars & Trucks

1 Answer

One min light on i checked code p0102 came up was on for a day then i used it this morning light was off for like 6hours then now its back on


The light will go on and off until the actual system has failed.

P0102 - Mass or Volume Air Flow Circuit Low Input.

Symptoms:
- Engine stall
- Engine running rough
- Excessive fuel consumption
- Excessive smoke
- Engine light ON

Possible Causes:
- Harness or connectors (The sensor circuit is open or shorted.)
- Intake air leaks
- Mass air flow sensor may be faulty

Possible Solutions:
- Replace air filter
- Clean air flow meter
- Replace air flow meter

Jan 18, 2011 | Pontiac Grand Prix Cars & Trucks

1 Answer

Stalled out, lurching drive, chk engine Lt


Look for a vacuum leak in the hose going from the filter box to the intake. The mass air flow meter is the item that is stuck in the middle of the air tube. You may need a new one. Unplug it and see if it runs a little better. The computer will take it to factory settings without it being hooked up and while you should not run it with out the meter, it will run better for you to help diagnose.

Hope this helps

Apr 09, 2010 | 1995 Buick LeSabre

1 Answer

Running rich and blowing black smoke


Could be a number of different things.Fuel pressure relief valve not working,injector pulse too long,Is the air box lid securely fastened and air cleaner clean.Are there no leaks between the air box and throttle body(intake tube).Have you checked oxy sensor.air flow meter may be also possible.Try squeezing the flexible fuel hose enough to allow the engine to run and see if the engine reacts better if it does you have excessive fuel pressure.

Nov 20, 2008 | 1990 Toyota Celica

1 Answer

1987 Maxima- runs rough at low speeds, won't pass 50/15 emmissions test. High speed ok, black smoke from exhaust when starting after stall at low speeds.


check your injectors.use a ohm meter and check resistance. 1987 maxima reading is somewhere between 10.1-14.2 ohms. if out of spec, replace. Also check your air flow meter and air box, make sure its all clean in there. good luck. post results.

Aug 09, 2008 | 2003 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...