Question about Ford Cars & Trucks

1 Answer

How to drain cooling system on ford transit 2400cc lwb 2002

Nothing is there a drain plug on rad ?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 315 Answers

Hi there, a small tap located at the bottom of the radiator, turn the tap on to release the fluid from the system, do it wile the engine is cold as no pressure would have time to build up, once stated draining release the radiator cap and let it drain, hope this helps

Posted on Nov 27, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
keemo68
  • 1263 Answers

SOURCE: 2002 V.W. Jetta 2.0 liter overheat

turn your heater on to max heat and high fan. then see if you can feel the hoses on the firewall for heat they should be hot. make sure that the fan unit on the radiatoris working if the upper radiator hose is hot the fans should be running if they are not that means that either the relay is bad the thermo sensor is bad or the fan unit is shot... please rate the solution..........thanks

Posted on Sep 24, 2008

  • 7 Answers

SOURCE: location to replace oil filter for ford transit LWB

of it has a 6.0L engine it is on top of the engine righ where a carburator supposs to go, this is for a ford f350 diesel

Posted on Dec 07, 2008

  • 1 Answer

SOURCE: Diagram of Location of a Starter Motor on Ford Transit 2002/2003

i have a 2001y reg transit tipper and i think the starter motor is going when i go to start it like grinds then some times it starts perfect

Posted on Jan 25, 2009

Mustgo
  • 2359 Answers

SOURCE: 2002 chrysler 3.5 overheating - new rad, water

It can a the first stage of blowing head gasket.

Fill your coolant tank to the full mark when it's COLD.

Start the car, and pay close attention to the tail pipe for a small puff of white smoke.

After 15 minutes,If you do see any vapor then take the car for a 8 minutes drive.

Park the car and listen for bubbling sound from the coolant tank,

If you see bubbles coming up then you will need a head gasket change real soon.




Posted on Jul 17, 2009

  • 1 Answer

SOURCE: ford transit van dashboard display not working

ive got a 55 plate 85 T260 swb crewcab 68000 miles, , i bought it 12 months ago, red light flashes on dash board most days, some times arratically, sometimes quite slow, and all clocks, speedo and dash does not work?????????
the smallest scratch and the van rusts, no under seal, there just a use it and dump it van.

i would just like to say fords are ****

Posted on Dec 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i drain old antifreeze and put in new antifreeze in my 2002 ford sport trac


For most cars, set your heater temp control to hot, Make sure engine is cold. Open drain on bottom of rad, let it drain down, depending on model the overflow bottle should drain before the rad does, once its drained remove the rad cap and drain to completion. Make sure any spills are wiped up and no open containers of antifreeze are left sitting around. Cats and dogs love to drink it, but it will kill them if they do!

Feb 15, 2015 | 2002 Ford Explorer Sport Trac

1 Answer

Trying to locate drain plug for antifreeze. Just had work done on my 1998 ford club wagon and need to drain water and add antifreeze.


As far as I know there are no drains in the cooling systems any more. I took the bottom rad hose off and drained my Buick. They say you should not put water in car rads any more.

Nov 03, 2014 | Cars & Trucks

1 Answer

How to replace a radiator on a 2003 mitsubitshi lancer es


make sure the engine is cold , drain the coolant from the rad ,there will be a drain tap/bolt on the bottom of the rad ,be sure to us a container to collect the fluid as should'nt be left to run down a drain etc as is very toxic,disconnect the top and bottom hoses, there are usually two bolts either side of rad loosen these, rad may lift out if not remove the bolts and lift the rad away and out of vehicle , if the cooling fan is attached to the rad remove , will be obvious what bolts need undoing, replace this fan unit on new rad ,then refit new rad , reverse of removal , dont for get to check the drain plug is closed on the new rad , refill cooling system by adding coolant to the expansion tank, run the engine and bleed the air from system ,there will be bleed screws at various points around cooling hoses etc , allow engine to cool 1 hour min ,check coolant level top up and repeat bleeding process as neseccary good luck very straight forward job , keep me posted

May 11, 2014 | 1992 Lexus Es 300

1 Answer

How to drain cooling system


First drain the radiator. Next leave the rad drain open and remove the heater core hose from the top of the rad by the filler cap. plug the hole in the rad where the heater hose was and use an air gun to inject air into the cooling system via the disconnected heater hose. Be sure to use short spurts so that you so not over pressure the system. This will drain the majority of the engine and the coolant will come out in a hurry. Hope this helps.

Nov 13, 2010 | 2004 Chevrolet Express

1 Answer

FORD TRANSIT CONNECT 1.8TD T220L LWB H/ROOF Diesel workshop manual


got one for a ford escort diesel van 1980something model ,the engine is the same

Oct 05, 2010 | Ford Transit Connect Cars & Trucks

1 Answer

What is tyre pressure ford transit 330 lwb 2002


In the US, all vehicles have a sticker attached to the driver door post (some on the driver door) of inflation levels. Sorry I don't know the exact pressure, but hopefully you will find that info there.

Aug 20, 2010 | 2002 Ford F350 Super Duty DRW Reg. Cab

2 Answers

Cooling system problem


well it might overheat because air got into system, replace the thermostant and then fill system, run van keepin an eye on the temp, it will start to run hot because coolant has not filled the motor just the radiator, when it starts running hot shut it down, wait 3 minutes and start, now this is done with cap off,after restart coolant should get sucked in get filling radiator as needed,may get messy but got to bleed cooling system. hope thius helps.

Jan 10, 2010 | 2001 Ford Focus

1 Answer

How to remove 2002 ford taurus radiator


Remove the rad support cover, remove the electric cooling fan and shroud, disconnect the tranny cooler lines, drain the cooling system, remove the upper and lower hoses, remove the rad brackets on top of the rad (one on each side), have someone hold the AC core out of the way and carefully slide the radiator up and out

Nov 22, 2008 | 2002 Ford Taurus

1 Answer

Location to replace oil filter for ford transit LWB


of it has a 6.0L engine it is on top of the engine righ where a carburator supposs to go, this is for a ford f350 diesel

Oct 28, 2008 | 2004 Ford F350

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5522 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...