Question about 1994 Toyota Land Cruiser
In my land cruiser Jeep the diff lock button is working properly but in switch board all the time the diff lock indication light is on what can I do for it ?
Check wiring under/behind the switch chances are it is a "dead short" which is keeping your light on. Look for bare wire(s). Peace. God bless
Posted on Nov 27, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
This is normal if I'm reading this right. The door locks are supposed to pop up when you turn off the key when in "child proof" mode. The reading lamp is wired to prevent low battery conditions by only operating when the engine is running. Did you just get the car?
Posted on Jul 29, 2008
91-97 Land Cruisers had a factory option for front and rear locking differentials. This is a seperate switch and is usually located to the left of US model Land Cruisers. The center dash button locks your transfer case differential changing your Land Cruiser from all wheel drive to four wheel drive depending if you have ABS or not this button either says ECT or Center Dif Lock. If you do not have the Front/Rear locking differential option then your Land Cruiser has open Front and Rear. Hope this answers your question.
Posted on Mar 21, 2009
SOURCE: my 00 toyota land cruiser
Yes!! probably the front diff actuator is sticking , the wire that command the disengagement is not making contact properly, or the actuator itself is bad, also if you replace the tires with a size different from the manufactures that can create an engagement problem.
Master Diagnostic Technician for Toyota
Posted on Dec 19, 2010
SOURCE: swapping out radio from salvaged
Is the salvaged radio EXACTLY the same as the original radio? Are you sure everything is plugged in correctly? If the radio is not EXACTLY the same. the circuits could be different and the wiring harnesses may not provide power at the correct pins on the radio. Also, do you have the security code for the salvaged vehicle? The code for your radio will not work in the salvaged vehicle radio.
Also check to be sure that you did not cause the fuses to blow when disconnecting/connecting radio components. If you attempted this job without first disconnecting the battery cable, there is a very good likelyhood that this has occured. Damage to the salvaged radio could also have occured if the salvage vehicle battery was not disconnected during removal of the salvaged radio.
Posted on Jul 31, 2011
Tips for a great answer:
Nov 26, 2014 | 1994 Toyota Land Cruiser
Jan 28, 2014 | 1991 Toyota Land Cruiser
Mar 04, 2013 | 1992 Toyota Land Cruiser
Dec 19, 2010 | 2000 Toyota Land Cruiser
Aug 02, 2010 | 1994 Toyota Land Cruiser
Jul 13, 2009 | 1993 Toyota Land Cruiser
Jun 28, 2009 | 1988 Toyota Land Cruiser
Jan 19, 2009 | 1994 Toyota Land Cruiser
Jul 18, 2017 | 1992 Toyota Land Cruiser
68 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: