Question about Chevrolet Chevy

1 Answer

Why does my XM Radio fuse keep blowing in my 2011 chevy impala

Replacing the 10amp fuse but it blows as soon as I install.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 514 Answers

For some reason that happend to me once and i had to connect my radio groud direct to ground instead of battery ground cable and that fixed the problem. good luck

Posted on Nov 27, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

sicaudio
  • 96 Answers

SOURCE: XM Radio Fuse

sounds to me like you need to check the continuity to ground on the power line for the xm, you may have a power to ground short or a loose wire in the xm harness

Posted on Jul 19, 2008

  • 1 Answer

SOURCE: Radio fuse keeps blowing

something loose in the wireing when driving .the wires are grounding out

Posted on Aug 13, 2008

  • 85 Answers

SOURCE: Blows fuses when parking lights are turned on. Headlights work fine even running lights.

If it only happens when you turn the switchto the parking lights then it is most likely the swich that is the problem. Light swich failure appears to be a common fault with fords

Posted on Apr 23, 2009

  • 8 Answers

SOURCE: 1996 ford f150 blows the 10amp fuse going to the speed odometer.

I'm glad you found what was causing the fuse to blow. A wiring diagram is almost a must when troubleshooting electrical. you may be able to find that sensor at a pick-a-part or wrecking yard. Just be extreamly careful, it is very easy to set off the air bag. Make sure that all power is off before working around that area.

Posted on Jun 05, 2009

  • 2468 Answers

SOURCE: My chevy silverado keeps blowing the 40A fuse for the AC

the windings in the coil on the compressor clutch is shorted,you need to remove the drive pulley where the belts hook on the compressor,then unbolt the 4 bolts holding the coil assy

Posted on Mar 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Radio amp fuse blows


problem could be radio.10 amp fuse for ignition switch power up radio display the 30 amp fuse for radio amp system in which that circuit hot at all times.

Nov 18, 2013 | 1998 Lincoln Continental

1 Answer

Onstar fuse blows when i put new fuse in


The OnStar module is behind the trunks side wall on the passenger side. Try unplugging that and install the fuse. The XM radio is on the rear shelf which requires little more work to get to.

Jun 29, 2012 | 2008 Chevrolet Impala

1 Answer

2000 chevy impala keeps blowing fuse for cig lighter and radio


You have a short or a defective cig lighter plug. Check with an ohms meter for continuity.

Jun 12, 2012 | 2000 Chevrolet Impala

1 Answer

Main fuse keeps blowing. changed battery and installed radio. brand new fully connected postitive termial, vusually checked all wires coming off battery. some sort of radio relay clciks when radio plugged...


Hello! Identify which fuse is blowing...also, does it blow as soon as it is installed or does it blow when you turn the key? Lastly your not referring to a fusible link but a maxi-fuse...ie...40; Correct?

Oct 16, 2011 | 1994 Chevrolet Suburban

1 Answer

2004 chevy impala....my brake light fuse keeps blowing...fine when you replace the fuse but then when you step on the brake it blows (the fuse that say BRK SW}


you have a short somewhere. if it is the brake switch fuse it is probably the brake switch which should somwhere on the pedal arm or actuated by the pedal arm. also check your bulbs if you haven't already. hope this helps.

Mar 25, 2009 | 2004 Chevrolet Impala

1 Answer

Radio fuse keeps blowing


something loose in the wireing when driving .the wires are grounding out

Aug 11, 2008 | 2001 Pontiac Montana

1 Answer

XM Radio Fuse


sounds to me like you need to check the continuity to ground on the power line for the xm, you may have a power to ground short or a loose wire in the xm harness

Jul 09, 2008 | 2005 Chevrolet Equinox

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...