Question about 1988 Suzuki Samurai

2 Answers

How do i get piece out of transmission that speedo cable goes in on 88 suzuki samurai.

Replaced cable

Posted by on

  • Richard Clark
    Richard Clark Nov 26, 2014

    Hi George Thompson, I want to help you with your question, but I need more information from you. Can you please add details in the comment box?

    You have, or want to replace cable

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Hi
Is it the bit of broken cabe you want to remove?

Posted on Nov 26, 2014

Ad
  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 37 Answers

You can try using some heat to free up the corrosion around seam. Or a penetrating oil and let soak for some time

Posted on Nov 26, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my 88 suzuki samurai is blowing oil out of exhaust


Your compression is low, the rings in the piston engine are worn out , you will need an engine overhaul , probably you have low power also .And blue smoke to boot ..

Jan 23, 2013 | 1988 Suzuki Samurai

2 Answers

Speedometer cable


Parts stores still might be able to find that for you. Or try a few salvage yards Replacement is pretty easy. It unscrews from the transmission, and behind the instrument cluster where it connects to the back of the speedometer, is usually held on there by a plastic clip that depresses to release. You will probably have to pull the cluster out a few inches to get your hand back there to release the cable clip...and the electrical connector if you want to remove the cluster and put new illumination bulbs in while you have it out.

Jun 17, 2012 | 1987 Suzuki Samurai

1 Answer

When driving my land cruiser there is a whining noise ,Ive been told that it is the speedo cable,the sound is coming below and back a bit from gear stick,sounds like it could be coming from area wear...


This sounds more like a u joint or internal transmission bearing to me. Normally if the speedo cable goes bad the speedo will not work. It could also be the gear that drives the cable too. I would have a trusted transmission expert look at it.

Mar 02, 2011 | 1985 Toyota Land Cruiser

1 Answer

I have an 88 suzuki samurai, the headlights will only come on when i put the high beams on. no low beam at all, the running lights come on. :-)


the relay for the low beams is bad, replace it and you should be good to go... you could also test it by switching it with the high beam relay, just to make sure

Dec 05, 2010 | 1990 Suzuki Samurai

1 Answer

My speedometer isn't working on my 1987 Samurai Suzuki


Check vehicle speed sensor or wiring,check engine light should be "on".If light not on bad speedo head in dash.If cable driven[unlikely] check for a broken cable from trans to dash.

Apr 17, 2010 | 1987 Suzuki Samurai

3 Answers

88 suzuki samurai


Look on the transmission near the bell housing, this is where the speedometer cable connects to the transmission. Loosen the nut and pull the end out. Turn it manually by hand to see if it is turning and inspect it for damage. This is usually the spot where the cable breaks. You may find it loose and stuck in the transmission when you remove the cable. You can take the broken end out with a pair of needle nose pliers.
Please remember to rate this fix.

Feb 16, 2009 | 1988 Suzuki Samurai

2 Answers

88 Suzuki samurai 4x4 will not engage.


The shifter sheet is worn out or not even there (its rubber) from multiple uses. It eventually decades.

Tons of Samurai enthusiast retailers carry them. Lowrangeoffroad, Petroworks, Trail Tough, and more.

They also carry the one for the tranny shifter.

Jan 13, 2009 | 1987 Suzuki Samurai

2 Answers

How do I change my clutch on an 1986 suzuki samurai


I have found it easier to remove the engine to replace the clutch on my 1986 Samurai it you have the proper tools to pull the engine it took less time than pulling the transmission in my experence.

Nov 29, 2008 | 1986 Suzuki Samurai

1 Answer

88' samurai idles to high


88 model its a carbureter,need a clean by the sound of it

Nov 05, 2008 | 1987 Suzuki Samurai

1 Answer

Samurai engine swap


It will fit if you:

1. Use an adaptor for the new front wheel engine and the original transmission of your suzuki ( ask your machinist)
2. Have your propeller shaft from the transmission to the independent transfer case resized depending on the outcome of your engine mount.
3. adjust the bracket of your transfer case if you need more room for the propeller.(optional)
4. you dont need to change gear ratio if you plan to use the same tires



Oct 11, 2008 | 1989 Suzuki Samurai

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...