Question about 2000 Seat Ibiza

3 Answers

I have a fault code PO650on a seat can you help

Engine not working

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 28 Answers

16989 P0605 Internal Contr.Module ROM Test Error

Try here for help: http://tinyurl.com/pfhgxgd

Posted on Nov 26, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 969 Answers

Http://www.obd-codes.com/p0650 you must provide year, make,model engine info

Posted on Nov 26, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 131 Answers

If the fault detection circuit senses a voltage other than what is expected, the fault line status will change causing the P0650 code will set
Read more: http://engine-codes.com/p0650_pontiac.html#ixzz3KBuUP8Qv

Posted on Nov 26, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a seat ibiza 1.2cc and got a week 1 week coil pack will this mack it run bad and go it to limp mod pleas


lots of seat ibiza 1.2cc for sale ..going cheap

is the check engine light on

try clearing any fault codes
with radio code in hand
disconnect the battery terminals for a bit

then reconnect
see if it starts ,idles and is not in fail safe

if no better a diagnostic reader will be needed

you may need an used engine computer

26278521-rf1ryczm5xterh2ft3roh5nl-5-0.jpg26278521-rf1ryczm5xterh2ft3roh5nl-5-2.jpg

Sep 09, 2016 | Seat Ibiza Cars & Trucks

1 Answer

How to fix error code B223D for Jeep Grand Cherokee with engine 3.7L of year 2005


That is probably a fault with the sensor that detects a person sitting in the seat. That sensor is there so that if no one is in the seat and you have an accident the air bag won't go off. You need to take this to a dealer as it requires special tools to re-calibrate the sensor once it is replaced.

Aug 02, 2016 | 2005 Jeep Grand Cherokee

1 Answer

How to fix P0302 and P0401 error codes for Lincoln Town Car 2001?


code p 0302 i cylinder 2 --misfire detected ===causes --- engine mechanical fault ( valve seat insert loose , burnt valve , cam followers/ hydraulic followers faulty)---wiring---ignition/fuel system---injector--ECT/MAF sensor ---ECM
possible injector fault ( blocked tip)
code p 0401 refers to exhaust gas recirculation (EGR) system--insufficient floe detected ==== causes --hose leak/ blockage ---basic setting not carried out (if required)---wiring---EGR valve ---EGR solenoid ---ECM
as you admit to knowing little about cars , take it to an accredited service center that works on your make of vehicle and get a proper diagnosis and quote
Use the codes information and causes I have given you when discussing the problem

Jul 22, 2016 | 2001 Lincoln Town Car

1 Answer

Engine fault light flashing and car loosing power


could be a number of things so i would get the OBDII codes read at a garage or a mechanic you know , that will produce the code relating to the fault

Jun 26, 2015 | 2008 Seat Cordoba 1.4

1 Answer

Air bag light flashes 5 times then 1 time


That flashing indicates fault code 51. Fault code 51 indicates a problem with the driver's seat belt circuit. The seat belt buckle has a switch in it to determine if the belt is buckled up when the seat is occupied [determined by a pressure sensor in the seat bottom]. The switch in the buckle is either bad or the wiring to the switch is either short or open circuited.
Use of a computer scan tool can help narrow down the problem. There are four different scan tool fault codes relating to code 51. They are B2432, B2433, B2434 & B2435. These codes will give you more defined information on the actual fault. Most common faults are either a bad switch in the seat belt buckle or damaged wiring to that switch. Damaged wiring is usually caused by the driver placing objects under the driver's seat, which damage the wiring coming out of the seat belt. It is also possible to have a bad seat belt computer [Restraints Control Module or RCM]. A bad RCM is not common. Check for damage to the seat belt wiring under the driver's seat. Best to remove the seat and lift up the carpeting to do this. If no physical damage or water corrosion damage is present, replace the seat belt. After repairs, disconnect the battery for 1 minute to clear the fault code from the RCM's memory.

Aug 27, 2014 | 2003 Ford Crown Victoria

3 Answers

Service engine light stays on. changed oil last week.


The service engine light does not refer to oil changes, it is used to check for engine fucntion and emmision control sensors. Most likely you have a fault in one of the emmission control sensors.

Dec 04, 2010 | 2003 Chevrolet S-10

1 Answer

Seat ibiza 1.4 16v 02 plate cutting out at idle at junctions occasionally, regardless hot or cold, code reader shows no fault!


I have the same car and had the same problem, it turned out to be a hole in the vaccume pipe that leads to the engine.

If thats not the reason It may be the ignition coil, which is a common fault in seat ibiza's, this would cost around 75.00GBP to fix.

this site may help www.usedcarexpert.co.uk ,, the site gives good info about all cars and lists common faults and how to fix them.

Hope this helps

Mar 22, 2009 | 2001 Volkswagen new Passat

1 Answer

Check engine light an airbag light went on. what is causing this


Check engine light is on because you have a sensor telling the computer that something's wrong with your engine. Go to AutoZone or another parts store - most of them will code scan your car for free (a dealer will get up to an hour's labor for it). Post the codes here when you have them, and I'll help you figure out what's wrong. As for the airbag light, see if they'll scan your car for chassis and airbag faults as well. If you have side airbags in the seats, like I do in my Audi, chances are you moved the seat too far and pulled on one of the connectors. They're not designed very well, and moving the seat too far will strain them a bit, open them just a hair, and trip the fault light. I zip-tied mine tightly to hold them, and then turned the airbag light off. That (and clearing the check engine light) have to be done using a code scanner - you can't clear them by disconnecting the battery most of the time.

Aug 01, 2008 | Volkswagen New Beetle Cars & Trucks

1 Answer

Retrieve fault codes 92 900


Fault codes come from the fuel injection system diagnostic circuitry, which can store up to three faults. They can be read through the check engine light in the dash. You'll need to make a switched test lead with a spade connector on one end for connecting to the test connector. The other end is connected to ground. In 1992 the test connector is located beneath rear seat in sedan, or under the bellows ahead of shifter in convertible. With ignition off and test lead off, connect test lead to ground and test connector pin 2. turn ignition key to ON When Check Engine light comes on, turn test lead switch ON; Check Engine light should immediately go out When Check Engine light flashes ONCE, IMMEDIATELY turn test lead switch OFF Any fault codes will flash through the Check Engine light, with a long flash at beginning and end of each code; code flashes are short flashes, each block of flashes is separated by a longer space. With the engne OFF, the first fault code is that for "No RPM" 1 2 2 3 1, it will look like oooo x xx xx xxx x oooo where o = steady on, x = single flash There are over 20 fault codes, so get yourself a copy of the best source of info on this car: the "Bentley Bible" aka the Saab 900 Official Service Manual, costs about $40 from Amazon 16 valve manual: http://www.amazon.com/Saab-900-Valve-Service-Manual/dp/0837603137 8 valve manual :http://www.amazon.com/Eight-Official-Service-Manual-1981-1988/dp/0837603102 Hope this helps, if it does please give a "thumbs up", thanks Saabreur

Jul 29, 2008 | 1992 Saab 900

Not finding what you are looking for?
2000 Seat Ibiza Logo

180 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

78267 Answers

Adam Truesdale

Level 3 Expert

528 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...