Question about Toyota Cars & Trucks

3 Answers

I have a 1994 Toyota camry LE the turn signals light and blink in the winter but only light and not blink in the summer. They usually stop blinking when the temp hits about 50 degrees. Any help would

I have a 1994 Toyota camry LE the turn signals light and blink in the winter but only light and not blink in the summer. They usually stop blinking when the temp hits about 50 degrees. Any help would be appreciated.

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 57 Answers

"The flasher for a '94 Toyota Camry LE (4-cyl 5SFE) is located behind the kick-panel on the Drivers side under the hood release"

"In the left kick panel you will see this junction block with the black rectangular turn flasher plugged into the upper right corner.The left kick panel is where you put your left foot while driving and is up against the side of the vehicle just in front of the door"

http://ww2.justanswer.com/uploads/Joecamel90/2010-02-13_235624_flasher.gif

Posted on Nov 25, 2014

Testimonial: "Thanks! I will look and change out the flasher unit."

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 95 Answers

I would change the blinker unit, it is a round small cylinder under the dash and it wont cost to mutch or go to a wreking yard that has wreked cars and get one from them most cars have the same sort of sytem so I would start with that. It sounds like a bad connection problem good luck.

Posted on Nov 25, 2014

Testimonial: "Thanks for your help. I will look for it there."

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

You obviously have a short that is impacted by a change in temperature. Have an electrician troubleshoot the circuit. It could be on of the fuses turning bad or a connecting wire is worn out and needs to be replaced. Have a very Happy Thanksgiving :-)

Posted on Nov 25, 2014

Testimonial: "Thanks for your help. Happy Thanksgiving to you as well!"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 373 Answers

SOURCE: 1994 2.2L toyota camry radiator fans do not work

Hi.....

The Normal Temperature Range to the Fan Start is: A/C ON 181 F.
A/C OFF 199 F. When the Engine Reach this Temperature the Fan should start.

OK. Do this simple test.
1---- Start the engine, Desconnect the ECT Switch located on the Radiator,
See if the Fan come ON. If yes, if not go to step #2
Connect the ECT SWITCH and leave the car Running and with a Temperature gage.
See the temperature, if the Temperature go more than 199 F.
Turn the Engine OFF.
Disconnect the ECT sensor and check for Ground at the WHITE/BLACK wire.
If ground exist, Replace the ECT switch.
But if not. Check the wire for any damaged, and the ground at the Front Left Fender.
Repair as need.

2---- check the Fuse link RDI FAN . 30 amp.
Check the Fuse link CDS FAN 30 amp.
Replace if need.
And Return to step # 1.
Check the Radiator fan Relay, Rad fan relay 2 and 3. Replace if need.

Ok. I hope this help on your question.
I can give to you the WIRING DIAGRAM of the Fans, But I need a E-MAIL adress to do that.

Thank you for use fixya....

Posted on Sep 25, 2008

  • 75 Answers

SOURCE: car wont start alarm light is blinking

yes factory alarm. there is a smal switch hiden under dasch board find it and turn the alarm of by reseting the boutton you can also open the driver side of car witt your keys

Posted on Dec 22, 2008

  • 1 Answer

SOURCE: Maintanance light on a 2007 Toyota Camry LE

Push and hold trip button on dash with key off, turn key on but don't start, odometer will clock down, when it is finished, lite will go off

Posted on Apr 08, 2009

litoshop
  • 298 Answers

SOURCE: 2006 Toyota Camry Security Light is blinking

Hi I'm litoshop if the security light stop blinking.then you deactived the alarm if your car has a factory alarm then the same light you see blinking look at it close and see if it's a switch push it in and put the key on and just turn on the dash light then turn it off the it should start blinking agian if it's not the light the look for a small red push botton and do the same as instructed above good luck. if this information has been useful please let us know thank you...

Posted on Aug 02, 2009

  • 1861 Answers

SOURCE: 1998 Toyota Camry tail lights and backup lights won't work

Hello.

I have a solution for you, as I see your same issue in my shop quite a bit...There are two possibilities:

You may have a broken wire. This is a very common issue.

Open up the trunk lid, and look at the hinge on the driver side. You will see a wiring harness, in a plastic tube, attached to the arm that holds th trunk lid to the car.... Remove the tubing, and follow the wires towards the back seat area. You are probably going to find a wire that has been broken, from the many actions of opening and closing the trunklid. Splice and resolder the wire, and you should be fine.

The other issue is the tallamp failure sensor may have burned out. This too is rather common. Open the trunk lid, and pull back the inner carpeting on the driver side of the trunk. Locate a small box (it will be white or blue), on a brace. The box is closer to the quater panel sheetmetal. Remove the box, and take it apart. If it looks or smells burnt, you need a new sensor.

Posted on Nov 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 toyota camry will go full speed in reverse but wont move in drive


Is the O/D light blinking? If so, the No1 and No2 shift solenoid assy has failed. This is a common thing in Camrys this age.

Sep 29, 2013 | 1994 Toyota Camry

1 Answer

98 toyota camry blinker lights not flashing?


if they are coming on and not blinking sounds like the turn signal switch might be bad.

Dec 20, 2012 | 1998 Toyota Camry

1 Answer

Oil light blinking


My 2002 Toyota camry oil light blinks when the car idls we changed toe oil sending unit and oil pump what can I do to get the oil light to stop flashing..

Feb 27, 2012 | 2002 Toyota Camry

1 Answer

Brainbox light comes up on the dashboard after driving few kilometres. I change it with another one but still the same problem. Toyota camry 1994 model.


Well, that's the check engine light I think. It is saying something is not normal. You can read out a trouble code to give you an idea of why it is on. Turn the ignition on, but engine stopped, and with a piece of wire bridge terminals TE1 and E1 in the service terminal box, at one rear corner of the engine compartment.

The check engine light will then blink. A steady blink 4 times per sec is "all normal".

Trouble codes are 2 digits, and these will be blinked - first digit - pause - second digit - repreat.

So the oxygen sensor fail code (a common one) is 21, and will show 2 blinks - pause - 1 blink - repeat.

There are 22 of these codes

Nov 18, 2011 | 1994 Toyota Camry

1 Answer

When ever i'm driving my 1994 toyota camry le 4 cylinder it just turns off on me at a stop sigh or stop light.


its the idle control valve and its dirty or not working its on the inlet manifold and it allows into manifold ,its on the engine side of the butterfly control flap but i cannot tell you exactly where as iam a general mechanic not a dealer mechanic

Jun 29, 2011 | 1994 Toyota Camry

3 Answers

AC light blinks and compressor will not run. Freon


Could be bad AC clutch relay. Just replaced mine ($11 at autozone). It is located in the relay box just behind the battery.

Mar 18, 2010 | 2002 Toyota Camry

1 Answer

Car turn signals work normal untill headlites


You need to go to autozone parts store and have the battery and altanator tested with lights on and blinkers on to see if you have a low voltage problem both could cause this condtion.

Nov 10, 2009 | 2003 Toyota Camry

2 Answers

2006 Toyota Camry Security Light is blinking


Hi I'm litoshop if the security light stop blinking.then you deactived the alarm if your car has a factory alarm then the same light you see blinking look at it close and see if it's a switch push it in and put the key on and just turn on the dash light then turn it off the it should start blinking agian if it's not the light the look for a small red push botton and do the same as instructed above good luck. if this information has been useful please let us know thank you...

Aug 02, 2009 | 2000 Toyota Camry Solara

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...