Question about Cars & Trucks

1 Answer

How do I drain the air out of the fuel system after changing the fuel pup in my rx8 thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 259 Answers

If it's petrol it don't need bleeding , rx8 have a known problem of fouling up the plugs on short periods of running

Posted on Nov 25, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel pump located in a 1985 Isuzu pup?


Under air intake manifold. you should be remove front right whell then you can see fuel pump there.

Oct 10, 2014 | 1985 Isuzu Pickup

1 Answer

Fuel water separator


Their is a cable with a tee handle on it next to your trans dipstick , always grab the tube with one hand and pull with other or you will break the bracket that\'s attached to it . If this has been done regularly you will not have an issue , the drain tube goes down the engine on the right side and usually soaks your front axle. But if you are replacing the fuel filter you have to remove the air cleaner box and also the silencer box to access the filter . My advise is not to use drain valve , suck out as much fuel as you can and then thoroughly clean out that fuel bowl before you install the filter .I have seen many of these powerstrokes with low power issues stemming from lack of maintenance. Make sure you change your oil regularly 5-6000 miles and if you live in a cold weather state you need to use 10w30 motor craft diesel oil , it works the best with those injectors

Mar 29, 2014 | 2002 Ford E350

1 Answer

Drain water separator light on, will not start


for water to drain out there has to be a means for the fuel to be replaced. most probably the fuel didn't flow in as the water ran out so air got in as the water was coming out. That means that you will have to bleed the air out of the fuel system the same as if you changed a filter.

Mar 13, 2014 | 2008 Ford F 250 Super Duty 4WD

2 Answers

Hi there, please can you help? I have a 2005 231bhp Rx8 thats not running properly. It is displaying fault code PO410, and the car will not rev, little better when cold but really struggles to get over...


CODE PO410 IS SECONDARY AIR INJECTION SYSTEM PROBLEM. POSSIBLE CAUSES AIR SYSTEM MALFUNCTION. RESTRICTED OR DAMAGED IN THE EXHAUST SYSTEM. RESTRICTED IN THREE WAY CATALYTIC CONVERTER.PCM MALFUNCTION.

May 05, 2011 | 2004 Mazda RX-8

2 Answers

Rx8 won't start


Anti theft devise has locked out the starting system. I forget how to reset it but maybe one of the guys here might know.

Aug 06, 2009 | 2004 Mazda RX-8

2 Answers

MAZDA RX8 2004 Took it out of garage , then put it


Check to see if you are getting fuel to the engine.If not replace the pump relay.Then change the pump if still not working.Check for spark at the wires if you have no spark then change the crank sansor.If still no spark then change the coil pack.

Jul 19, 2009 | 2004 Mazda RX-8

2 Answers

Low acceleration and no power


i would take those 2 coils off and check the backing of the packs. any discoloration indicates they are bad or going bad. coils may be working, but not to full potential due to grounding issues.

Jul 03, 2009 | 2004 Mazda RX-8

2 Answers

04 RX8 won't start??


Hold the gas pedal to the floor and try starting the rx8 has anti flood technology that gives less fuel when gas pedal is to the floor I do it all the time hope this helps

Mar 07, 2009 | 2004 Mazda RX-8

1 Answer

Mazda rx8 fault code p0410 secondary air system


Rx8 2004 check engine light it just teas on

Dec 11, 2008 | 2004 Mazda RX-8

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...