Question about 1994 Isuzu Trooper
1994 isuzu trooper. i put in a new clutch, slave cylinder, and clutch master bled the system. clutch peddle starts to build pressure then looses it and a small leak starts. I cant tell where the leak is coming from. I repeated the bleeding process several times. Nothing. Any advice is appreciated.
You'll usually find a knicked o-ring or a fitting not secured. Don't dismiss the plausibility of bad new parts... we see that regularly.
Posted on Nov 25, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
To determine which type of clutch you have, servo hydraulic or cable.
Look down past the engine bell housing and determine the existance of a hydraulic clutch slave cylinder.(a piece of casting with a rod facing towards the rear of the vehicle pocket into a bracket protruding out of the gearbox bell housing. As well as a pipe and bleed nipple to be crude)
(which I believe you have).The hydraulic fluid for this unit is sourced from the brake master cylinder reservoir via a sneaky pipe partially obscured to the clutch master cylinder on the internal firewall.If you have no clutch slave cylinder near the bell housing there would be an obvious bounden cable running from the firewall down to the outer of which will be stopped at a bracket hanging off the engine.The inner will continue to a bracket protruding from the gearbox bell housing.
Posted on Mar 05, 2009
SOURCE: I have a 1996 Isuzu
Hello buiskit: My name is Roger and I will help you. If the fluid runs down the firewall or leaks down on the floor board or on your foot. The problem should be the clutch master cylinder. However should the fluid leak at the bell housing area.Then the problem is the slave cylinder. To replace the slave cylinder you will need to pull the transmission in order to replace the slave cylinder. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
Posted on Jul 23, 2011
SOURCE: My 1993 Isuzu trooper's clutch stopped working when I went to start it a morning after driving it...the clutch is extremely LOOSE.. When pushed down,it's just pushing air and then does not com
i had that problem with my car and all i had to do was put fluid in it and pump it up but it could be your clutch slave cylinder
Posted on Nov 21, 2012
Tips for a great answer:
Jul 16, 2014 | 1996 Isuzu Trooper
Jun 24, 2013 | Cars & Trucks
Nov 20, 2012 | 1993 Isuzu Trooper
Feb 26, 2011 | 1994 Isuzu Trooper
Mar 17, 2010 | 1999 Isuzu Amigo
Mar 05, 2010 | Isuzu MU-7 Cars & Trucks
Dec 22, 2009 | 1994 Isuzu Trooper
Jan 31, 2009 | 1994 Chevrolet Camaro
112 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: