Question about 2002 Chevrolet Blazer

1 Answer

Location of vent canister solinoid on 2002 chevy s10 blazer

Need to find location of vent canister solinoid

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,501 Answers

Should be under vehicle, close to gas tank.

Posted on Nov 25, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0449 fault code on 2001 Blazer S10


EVAP Vent Solenoid Control Circuit Malfunction, should just need a Evaporative Emissions (EVAP) Canister Vent Solenoid/Valve.
first test and check the wiring and make sure that its 100% the vent solenoid before you replace it, follow the steps below. you will need a volt meter and ohm meter which is available at any auto or hard ware store.
Tips:Evaporative vent solenoid is located on the rear of the frame cross member behind the fuel tank.

1. Test the voltage at the disconnected Powertrain Control Module (PCM) terminal Key On, Engine Off (KOEO).

2. If 0 volts, test voltage at the canister vent solenoid White wire.

3. If 0 volts, test voltage at vent solenoid Pink wire.

4. If 0 volts at the vent solenoid Pink wire, test at the ENG 1 labeled fuse.

5. If the fuse is B+, test at the under hood fuse block C3 32 cavity Red connector terminal F3. Should be B+.

6. If terminal is B+, trace and repair the wire from the under hood fuse block to the vent solenoid.

Feb 02, 2012 | 2001 Chevrolet Blazer

1 Answer

2004 chevy blazer. can,t pump any fuel ito tank. check engine light on. high pressure when removing cap


your tank is not venting properly. check along fuel line from tank to motor for a pressure relief valve to canister

Apr 04, 2011 | 2002 Chevrolet Blazer

1 Answer

Where is the evap canister located on a 1997 chevy s10 blazer


The canaster it self is located on the drivers side rear of the wheel near the bumper has three hoses connecting to it 1 goes to the rollover valve on the fuell tank 1 to the canister vent solenoid on the member over the spare tire and the other 1 to the canister purge solenoid located on the mid left side of the intake manifold . What codes do you get ?

Jan 28, 2011 | 1997 Chevrolet Blazer

1 Answer

No crank on an 88 chevy s10 blazer. Good battery and lots of juice. No noise from starter. No click or clunk from starter or solinoid.


need to check the s wire on the starter solinoid for current when you turn your key to start,if the test light come on, and you have current to the large wire on the solioid you starter is bad, but of course you have to have enough current from the battery, I hope this helps you

Jan 12, 2010 | 1988 Chevrolet S-10

2 Answers

Help blazer won't take gas...


Hi: Canister you thinking about is located behind L rear bumper end cover. Won't have anything to do with Blazer not taking gas though. If you look behind the filler on the rubber filler pipe you should see a small rubber line with a black breather on top of it, that is what lets air out of your gas tank when filling vehicle, check it to see if plugged or damaged. Hope this helps. Please rate suggestion... ty

Feb 25, 2009 | 2002 Chevrolet Blazer

1 Answer

Fuel Pressure Relay location


Hello, There is no fuel pressure relay. If you mean fuel pump relay, you can find this by opening hood, look towards driver's area, on the firewall just below the cowl vents you should see a relay with 5 wires going to it.
CYA, Gator241

Feb 09, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

Can't find the oil filter where is it located 95 chevy blazer cant find oil filter for an 2002 pontiac grand am


You probably have a canister filter which is located under the hood. You have to screw off the top of a canister and the oil filter looks like a small cylinder-like paper filter. Did you check your owners manual?

Aug 08, 2008 | 2002 Pontiac Grand Am

Not finding what you are looking for?
2002 Chevrolet Blazer Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...