Question about 2009 Hyundai Genesis

2 Answers

How do i remove the dash from a 2009 genesis. There is a mouse problem and i want to get into the complete vent system.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 49 Answers

Buy a Chilton or Haynes manual... They're usually pretty descriptive and will yield some good tips and hints as well.

Posted on Nov 24, 2014

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 352 Answers

CONSULT THE DEALER, AND/OR A SHOP MANUAL.....IT COULD BE FIXED WITHOUT REMOVING ENTIRE DASH

Posted on Nov 24, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GMC Acadia AC not working properly


Not sure if I'm too late to answer this one, but you're describing a low refrigerant condition. The hissing noise and constant cycling of the compressor clutch are indicators of that. You should recover the system, record how much refrigerant was recovered, evacuate the system (with a vacuum pump), add A/C dye, and recharge the system to capacity. Common leak areas on these vehicles include the A/C condenser (located in front of the radiator), and the evaporator (located inside the dash, and requires complete removal of the interior dash to replace it). If you can't find a visible leak after running the recharged system with dye for several weeks and it starts to blow warm again, you will need to use an R-134a leak detector to "sniff" areas of the system for a refrigerant leak.

Apr 22, 2013 | 2009 GMC Acadia

1 Answer

Smells like something dead inside 2009 mountaineer. Worse when ac is turned on. Have removed everything from car and vaccumed. Just started suddenly. We live in country and suspicious for mouse,...


o god, try looking at cabin box filter. The only thing really is to remove the dash and all heater tubes and vents. I hope its easeir than this for you though. I have a transport that mice got into the heater system and i had to strip the inside entirely except for electrical. Mind you the van had sat for about a month with a blown engine, but it took around six to eight months to rid the smell as they of course did their #s in everything let alone the smell of death. you have to find it or it gets worse. best of luck to you. Anything you remove dont forget to wash it with soap and water.

Apr 04, 2011 | Mercury Mountaineer Cars & Trucks

2 Answers

2010 Equinox - Bad smell


it is common to get mice or? in the blower motor, you have to drop the blower motor out from under the dash? and check for debris

Jul 31, 2010 | 2009 Chevrolet Equinox

1 Answer

Need illustration of vent system ducting


If you want to do a good job you are going to have to pull the dash. Once it's out you will see every thing.

May 25, 2010 | 2009 Toyota RAV4

1 Answer

I believe a mouse as died in the vent system. Any idea how to clean out the vent system


at least have to get under dash to locate vents ducting and remove it may have to remove dash to get to all of the vents and ducting yuckk!!

Oct 26, 2009 | 2006 Nissan Sentra

1 Answer

Paint removed from vent trim on dash


these vents should snap in. If you look closely at the inside of the vent, there should be either two U shaped cuts on either side with the bottom of the U facing you, or maybey a couple of metal tabs. Either way, you should be able to place a precision screwdiver into the tab and pry it inward on one side then gently pull that side to you. It should rock outwards and come out of the dash if you pull it to the side you took out first. Let me know if this helps :)

Jun 15, 2009 | 2009 Chevrolet Silverado 2500HD

3 Answers

Replacment of heater core on 01 chevy S-10


Have replaced my heater core in my 2001 regular cab 4wd in december 2009. Had to pull the complete dash including the complete metal dash behind the dash that you see. Also had to remove the right passenger side inner fender well to acess the remaining two bolts that hold the heater core cover to the firewall. Its an insane job to do but the repair shop books call for 9 1/2 hrs to do the job. I'm not an expert but this is what it takes.

Mar 01, 2009 | 2001 Chevrolet S-10

Not finding what you are looking for?
2009 Hyundai Genesis Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...