Question about 2000 Plymouth Voyager

1 Answer

Y is my auto shutdown relay clicking and van wont start

Did a small bump fender bender..turn off the van at the time then restarted and drove home. next day go to start van and auto shoutdown relay is clicking..i changed the relay and same thing..go to turn key and get only relay clicks..then hav to take out relay or undo battiery to stop the clicking

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 49 Answers

The last time I saw this, it turned out to be a bad ECM due to shock. This was a Grand Caravan which didn't have any major damage as a result of the colision.

Posted on Nov 25, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

280zlvr
  • 126 Answers

SOURCE: 1997 plymouth voyager wont start

hi there under the fuse box where bad fuse was check to see if the plug connectors this is where the fuse plugs into it is probably burnt or damaged . disconnect battery and then unclip or unbolt fuse box look under box to see all wires that connect fuses are all in good shape replace female spade connector where needed and off you go also check to see if alternator is charging proper and not overcharging causing wire and or connector to overheat ok good luck i;ll be waiting response

Posted on Jul 12, 2008

  • 23 Answers

SOURCE: van wont start

check the small connector at starter for voltage when cranking if ok try the hammer test if starts bad starter (ie) tapping starter with hammer while trying to start.

Posted on Aug 26, 2008

roniecon
  • 6826 Answers

SOURCE: My Plymouth Voyager 98 won't start but when the

Spray some wet grafite spray in the key slot,plenty of spray and work the key back and forth.Remove the battery cables and clean the battery terminals ,and the battery post real shiney,and put them back on.Make sure you have good battery voltage also.Don`t take it for granted that the battery is good,take it off and have it checked and or charged on a good slow(2 amp) charge.Now when you are sure the battery is good ,and the connections are good,then if the starter clicks,grab the shifter and pull it up and down without moving out of park,while you hold the starter engaged.If it starts then the neutal safty switch is bad.Now if it keeps on clicking(it will be the starter clicking)replace the starter.You can lightly tap the starter with ahammer while trying to start the van,and start it,but the starter will need to be replaced.If I can help you any further,let me know.>>>roniecon@gmail.com

Posted on Sep 23, 2009

Testimonial: "Thanks so much Roniecon. You were right and after cleaning all connections it worked... i am driving again. "

  • 1757 Answers

SOURCE: what would cause the auto shutdown relay to click

Mostly likely it is the Relay that is beginning to go bad. One way to test this is to use the Spare Relay of the same Type (size and shape). OR switch out a similiar Relay of the same type (size and shape) THAT IS A NON-ENGINE OPERATION RELAY. Check again the operations. If the "new" Relay in the Auto Shutdown Relay no longer clicks, then it most likely was the Relay that should be replaced. However, IF you used the "old" Relay in another function, put your finger on this Relay while the function is "On" and determine if it is now clicking. If it is clicking, then it is definitely the Relay and needs to be replaced.
Let me know if this helped, or if you have addtional information or questions. Feel free to contact me at FixYa.com!

Posted on Jan 15, 2010

emissionwiz
  • 75822 Answers

SOURCE: Just turns off on it's own, Wait 60 sec. restart press pedel it dies.

This engine is electronically controlled so the first thing that must be done here is to have the systems control computer tested for fault codes and then do the proper diagnostics based on those codes.

Posted on Jun 07, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My van won't start after driving a short distance, it will start again after 3 to 5 minutes but then will act like it's going to stall while I'm driving. What's wrong?


Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Mar 19, 2015 | 1997 Dodge Caravan

2 Answers

Car wont restart after minor fender bender


this may be due to the battery check that whether it is in good condition

Jun 06, 2008 | 1997 Ford Taurus

2 Answers

I have a 2004 Chrysler 300M and I have had a finder binder on the passenger side now my car will not start but the interior lights work.


check to be sure your 'Fender bender' didn't break the electrical connections to your starter, or any other wiring under the hood. be thorough

Oct 19, 2014 | 2004 Chrysler 300M

1 Answer

My car wont start in the morning i checked all the sensors they are good brand new fuel pump and all the fuses are good. my mechanic say he is stumped. i used lucus oil incase of a clogged injector still i...


Some cars have a safety shut down fuel pump relay,Have you hit a big bump or had a fender bender? Oil pressure sender will stop the pump,is the fuel filter plugged,Have you cheked the fuse, is there power to the pump? Is the tank empty? Is there power to the injectors? Engine computer?

Mar 05, 2012 | Cars & Trucks

2 Answers

Replaced timing belt engine will not start


check for spark at the sparkplugs, and listen to hear the fuel pump going when key is turned on. if no pump noise and no spark it can be the auto shutdown relay located on the drivers side fender behind battery. the auto shut down shuts off power to the ignition and fuel pump if the timing belt snaps. ,,,, if you have spark and fuel pump works then check firing order on plug wires , if they are in right place then check timing , if timing belt was replaced without lining up the timing marks it wont run

Dec 31, 2010 | 1995 Plymouth Voyager

2 Answers

Starter relay location on a 1992 dodge caravan


Check along under hood on driverside fender area. Closest to windshield should be auto shut down, then next one toward front of van should be start relay. Probably a total or 4 or 5 there. Should be able to feel it click when starting, just to be sure no one mixed them up.

Sep 08, 2009 | Dodge Caravan Cars & Trucks

1 Answer

Looking for the auto shutdown reset on a 1999 Dodge caravan se\


There is a relay : but no button the relay is in the fuse box center by the drivers fender under the hood also check your fuses

Jun 21, 2009 | 1999 Dodge Caravan

1 Answer

I got a in a little fender bender, car will turn but wont start


Turn the key to the on position and plug in a scan tool and scan the computer. use the trouble code and go to mitchell on demand and search the trouble code and the program will tell you what is malfunctioning and how to fix it.

Apr 09, 2009 | 1998 Honda Civic

1 Answer

1996 dodge grand caravan died while driving, wont turn over


I had similar problem with Durango and replaced the "brain" with a refurbished PCM -- google for reburbished PCMs and call the Florida Company and ask they guys there what they think. My fix was < $300.00 by replacing the brain.

Mar 15, 2009 | 1996 Dodge Grand Caravan

1 Answer

Wont start


ford has a fuel cut off switch in case of a fender bender sometimes located in trunk or by pass floor board need to reset switch

Jun 06, 2008 | 1997 Ford Taurus

Not finding what you are looking for?
2000 Plymouth Voyager Logo

148 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...