Question about Cars & Trucks

1 Answer

Where is the fuse for a Jabsco fuel transfer pump #23870?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 274 Answers

Get a Haynes repair manual,it should tell you everything you need to know

Posted on Nov 24, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Not getting fuel, where is the fuel transfer pump located


In or at the fuel tank. When you turn the contact key, do you hear the pump humming? If not, have you checked the fuse under the dashboard?

Jul 03, 2015 | 2004 Dodge Ram 2500

1 Answer

2002 lincoln ls wont start . no fuel going to engine . fuel pump is good cause i tested it . checked all relays and fuses and diodes in fuse boxes and all are good . reset the fuel cut off left of the...


How did you test the fuel pump?
Which one Distribution Pump or Transfer Pump?
Do you have fuel presuure at the rail?
Do you have a crank signal or spark?

V8--V6!

Nov 29, 2010 | 2002 Lincoln LS

2 Answers

My 2008 toyota tundra ran out of gas i went and got gas, put the gas in but it wont start


I believe that the engine fitted into your vehicle is diesel fueled....Once this type of engine runs out of fuel, it is necessary to 'bleed' the system and remove all air from the fuel line
  • Open the bonnet (hood)
  • On top of the fuel filter housing is a flat silver metal plunger which must be pumped until it becomes hard.
  • Once the air has been removed, the engine should start.
Regards Johngee10

Nov 06, 2010 | 2008 Toyota Tundra

1 Answer

My 2002 LS blows # 17 fuse that go's to the fuel pump, It is an 15 amp fuse, that is located in the trunk, And the car stalls. Do I need a new fuel pump? look like there is two fuel pumps. Thanks Mike


There are to pumps
Delivery and Transfer Pumps
I will look over my wiring diagrams tomorrow ,and get back to you

Discribe in detail, the stalling and drivabiltiy issues
Also,have you had a lot of COP Ignition Coil problems or Throttle Body issues or ETC Failsafe?
Any code issues in last year?

V6 or V8

Oct 22, 2010 | 2002 Lincoln LS

2 Answers

Cant get power to fuel pump?? pump not buzzing when ignition on??? is there a fuse or relay??


There is a fuse and a relay , they are mounted in the fuse box up under the dash on the driver side.

May 19, 2010 | 1988 Volkswagen Cabriolet

1 Answer

06 cummins wont start


COULD BE GLOW PLUGS NOT OPERATING.CHECK GLOW PLUGS FUSE AND RELAY.THE FUEL TRANSFER LIFT PUMP NOT WORKING CHECK ITS FUSE AND RELAY.OTHER POSSIBLE CAUSES.STOP UP PRIMARY FUEL FILTER.AIR IS GETTING IN FUEL SUPPLY LINE.FAULTY INJECTION PUMP.OR FAULTY PCM.

Jan 25, 2010 | 2006 Dodge Ram 2500

1 Answer

Need to locate fuel pump on 96 jetta


1996 Volkswagen Jetta 2.0L SFI 4cyl

On a Digifant fuel system, the fuel pump is mounted in a reservoir under the rear of the vehicle. The fuel filter is also in this area. The reservoir holds one liter of fuel and is supplied by a small transfer pump in the tank. The transfer pump can be replaced separately even though they are installed and removed as a unit.

The Motronic system uses two fuel pumps. The first is a small transfer pump to get the fuel out of the tank and the second boosts the fuel pressure to the necessary amount. The transfer pump is located inside the tank and the main pressure pump can be found under the vehicle. This transfer pump is located under the rear seat and is part of the fuel gauge sending unit. The main fuel pump can be found in the reservoir in front of the rear axle beam. There is a check valve inside this pump to maintain pressure in the lines, especially on hot days, to avoid vapor lock. The fuel filter is mounted to the side of the reservoir. This filter has no specified replacement interval and should be good for the entire service life of the vehicle. Whenever the ignition key is in the on position, the pump should run for at least two (2) seconds to pressurize the fuel lines. If the Engine Control Unit (ECM) does not see a signal from the Hall Effect sensor in the distributor it will shut the pump off. If a Hall Effect signal is present, the pump will continue to run as long as a signal is detected. It is this Hall Effect signal that signals the ECM that the engine is rotating therefore indicating that fuel is needed. The pump is operated via a relay that is controlled by the ECM. This relay is located in the vehicles fuse panel. The main contacts of the relay can be jumped to run the pump during testing.

More details in Autozone.com (free register).

Good luck (rated this help).

Sep 21, 2009 | 1996 Volkswagen Jetta

1 Answer

How do i fit new fuel pump


the first thing is to figure out which pump... there is a transfer pump (in the fuel tank) and a high pressure pump (under the right rear of the car) get under the car and have someone turn the key to "run"... if you HEAR a humming sound coming from the pump that you can SEE, then it is most likely the transfer pump... if you hear NOTHING then remove the boot on the pump and check for voltage on the positive terminal using a light or a meter. If no voltage then check fuse or the fuel pump relay. (hint: you should hear a "clicking" sound with your ear close to the fuse panel when you turn the key...) VW fuel pumps are really reliable as long as you don't have too much dirt or water in the tank. Eliminate the electrical circuit and high pressure pump as suspects before looking at the transfer pump. Hope this helps.. (oh, and have a clamp handy when changing the high pressure pump to avoid a huge fuel spill!)

Apr 13, 2009 | 1989 Volkswagen Cabriolet

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...