Question about Cars & Trucks

1 Answer

My Mazda eunos, Tries to pull forward or shakes when I stop at traffic lights or park and also I have just replaced the spark plugs but it always cuts off, I have to keep my foot on the accelerator to keep it from cutting off. Any suggestions?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 274 Answers

Maybe you misplaced plug wires,you should only replace one plug at a time so you don't get them mixed up,you will need the firing numbers know to know where they are supposed to go

Posted on Nov 24, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

phoenixinks
  • 89 Answers

SOURCE: engine cuts out on acceleration

could be the pump or injectors or both. while your at it check your fuel tank for rust dirt any thing.

good luck

Jason

Posted on Jan 17, 2009

  • 147 Answers

SOURCE: car cuts out in traffic

check your fuel pump or its sensor in his way.

Posted on Apr 06, 2009

  • 10 Answers

SOURCE: Hesitates and cuts out when I accelerates, shakes and sputters!

Fuel filters are cheap and simple to change, so try that first. If that is not your problem it may be your catalytic converter. Before having that replaced, check your fuel return line. You should be able to blow thru the line with your mouth. If you can't, or it's really hard to do. . . then you have blockage. The blockage could be flooding your engine with fuel. Checking the fuel pressure with a gauge from an auto parts store may help you out. If the pressure is really high, then that may be your problem.

Posted on Apr 20, 2009

  • 298 Answers

SOURCE: 1999 renault clio auto, Im having problems with

Check timing belt and idling. Your idling revs should be poor. Check out tacho. It should be at least 700rev/min.

Posted on Jul 27, 2009

  • 59 Answers

SOURCE: code po705 mazda protege lx shaking rough start

The Code you refer to is P0705 Transmission Range Sensor Circuit malfunction (PRNDL Input). It is a possiblility that because this code is present, this sensor is malfunctioning. If it is malfunctioning, that means the engine needs to "guess" the value that this sensor is responsible for. In most cases when this happens, the engine will go for a value that ensures the car runs. The engine will not try to run smooth or efficently, it will only try to run. It is my guess that if you have the sensor checked and replaced, the problem might be fixed. Please let me know if this answers your question and please rate my response. Thank you

Posted on Apr 09, 2010

Testimonial: "that is good. where is the trasmission range sensor circuit located "

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My eunos presso surges while in idle and when i take off from a stop position it cuts out. please help as this is my only transport 4 me and my 2 boys


Try a TPS Sensor and have the throttle body clean and run a scanner on the car for truck to see if any codes are present.

Jun 13, 2012 | Mazda Cars & Trucks

1 Answer

My Mazda eunos 30X won't start


TRY EARTH LEAD DIRECT FROMBATTERY TO ENGINE FIRST.ASSUMING BATTERY IS FULLY CHARGED.(NEGATIVE END _ )

Jun 10, 2012 | Cars & Trucks

1 Answer

I have mazda eunos 30X engine turns over wont start


I do not know much about cars but I once had a similar problem. There is a plug that controls the fuel going to the pump. It is usually housed under the dashboard. Have you checked that? I cannot remember the name of it. Good luck.

Jun 05, 2012 | 1995 Mazda MX-3

2 Answers

P0300: SOMETIMES rough idle, shake a lot OR less power above 50mph then got this code


Spark plugs in your car are good for 100,000 miles. try changing fuel filter and add a can of B&G 44K fuel additive. This stuff is the best on the market and only available at dealerships. It conditions fuel pump and injectors, also absorbs water in fuel (methanol). Try this first, your car is too new for any other problems. this should help drivability and fuel mileage. If Nissan does not have B&G, I know Toyota does. Also stay with 91 octane fuel. Check oil and coolant often. do not risk overheating in traffic, watch your gauges......

Feb 28, 2017 | Nissan Sentra Cars & Trucks

1 Answer

Hello... I have a 2000 Mazda Protege 1.6.c.c. I had the timing belt replaced, the car runs fine but now, whenever I stop the car shakes...??? I need some help...!


in park idleing does it shake is the check engine light on when is the last time you changed plugs and wires fuel filter

Dec 01, 2010 | 2003 Mazda Protege

1 Answer

Hi, I have Mazda MPV 2003 (99 Kmiles). Several


did you check your transmission fluid

Mar 27, 2010 | 2003 Mazda MPV

2 Answers

I have a mazda protege 2003 and my car stinks like rotten eggs when i put on the gas and on top of that, my engine light is blinking and my car shakes when i stop at a red light!


i have a 2003 mazda protege. this is the third time my check engine light has come on. the first time the car started to shake when i stopped at a light and the check engine light came on. i had a readout done and it said misfire. i took it to a garage and they changed my spark plugs and wires. 2 weeks later it came on again and my car started to shake whenever i stopped. readout said misfire. they fixed the coils. it has been 2 weeks since then and my car started shaking again whenever i stop and the light came on. what could possibly be wrong with it?

Feb 06, 2010 | 2003 Mazda Protege

1 Answer

2005 Mazda 3 idles rough at stop light and sometimes dies


The ignition coil should be fine at that mileage. If spark plugs do not fix it suspect a faulty MAF sensor. If the MAF is sending a bad signal it will affect with the idle as the ecu is trying to compensate for the MAF.

Apr 22, 2009 | 2005 Mazda 3

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...