Question about Cars & Trucks

1 Answer

I have 04 mg 1.4 and srs light comes on now and again ? no manual ? thanjs

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 11,800 Answers

The light can be triggered when a a person sits without putting the seatbelt or because of a fault. If it triggers at random then it's a fault in the wiring circuit - a bad sensor switch, a loose connector (most likely) or a broken wire. You will need to check all of the above at the seats.

Posted on Nov 24, 2014

  • jan Nov 24, 2014

    reading other comments on its says its to do with the air bag ?

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

What does the red symbol like a driver with a ball in front of him means on the dashboard


This is a air bag fault light .it comes on when you have a fault in the air bag system.

Feb 19, 2017 | Cars & Trucks

1 Answer

How do I fix the SRS light... The car has been sitting for a few year and only started up each month , now the SRS light is not working


The supplemental restraint system (SRS) warning light is most commonly known as the airbag system light. This is a computer controlled system .
When the vehicle is first started, the SRS light should come on for 1 to 5 seconds while the system goes through a self-test sequence. If the light goes out, then the system is ready. If the light stays on, there is a fault somewhere in the SRS system.
if the light won't come on at all, the coputer system needs to be checked out.

Oct 09, 2014 | 1994 Lincoln Mark VIII

1 Answer

The SRS light will go off. Tell how to turn it off.


Hi, you cannot turn it off rather you have to reset it by following the instruction below...
  1. Turn ignition switch off, remove service connector cover.
  2. Connect (jump) the MES (Memory Erase Signal) connector (this is 2 pin connector wrapped on yellow plugged in the front of the under dash fuse box).
  3. Turn ignition switch on.
  4. SRS light will come on for 6 secs then go out, remove the jumper within 4 secs after the light goes out..
  5. The SRS light will come on again, reconnect the jumper within 4 secs after the light has come on.
  6. The SRS light will go off, remove the jumper with in 4 secs after the light has gone off.
  7. The SRS light will blink 2 times indicating the memory is reset.
  8. Turn the ignition switch to off and wait for 10 seconds.

May 25, 2011 | 1994 Honda Civic

1 Answer

How to erase srs fault


You'll need a scanner to erase any code, including an SRS light. If the light is on, indicating there is an issue within the SRS system, it really requires diagnostic and repair due to safety concerns. If the repair is not done to the vehicle and the code is erased, the light will just come back on again.

Jan 02, 2011 | 2005 Subaru Forester

1 Answer

After changing my ML350 battery the SRS light is on, can I reset it without going to the dealer


you can try disconnecting the battery again and see if the light goes away but usually when a srs light comes on the only way to clear it is with the 'sds' which the dealer has and sometimes the independent shops might have one too. Mercedes doesn't allow you to reset it from the vehicle due to it being safety related. when the srs light is on all your airbags and seatbelt etr's are disabled. if your vehicle has pre-safe then you will have to just drive it around til it relearns the steering angle sensor again. if that's the case it will say see owners manual in the display of the instrument cluster when showing the fault.

Sep 29, 2010 | 2002 Mercedes-Benz CLK-Class

1 Answer

Battery was low and put in new battery,problem SRC Light stays on how can I reset the SRC light?


I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

Jan 13, 2010 | 1997 Honda Civic

2 Answers

Srs light on


1st you need to either buy or make the "SCS Service Connector" #07PAZ-0010100 from H and A Accesories for $3.51. Use a speaker harness for an older Honda which you can buy at a local stereo shop such as Circuit City or Best Buy, and cut the wires and looped them together. You can also use a paperclip but that will make it a little more difficult because you have to connect it and disconnect it a few times quickly. 2nd you need to find the MES (Memory Erase Signal) connector as pictured below scs_small.jpgsrs_plug_small.jpg
It is a yellow connector with two wires in it that is plugged into the fuse box, unplug it and pull it down. Once you have done that you can begin the process of erasing the memory. NOTE: This will only reset your SRS System if what caused it to trigger has been fixed, Ex: turning the ignition on with any SRS Plugs disconnected, such as pulling your seat out.

1st step in erasing the memory is to turn the ignition off and connect the SCS Service connector to the MES Plug.

2nd Turn Ignition on. SRS indicator light will come on for about 6 seconds then go off.

3rd Disconnect SCS service connector for MES connector within 4 seconds after SRS indicator light goes off. SRS indicator light will come on again.

4th Reconnect SCS service connector the MES connector within 4 seconds after SRS light comes on. SRS indicator light will go off.

5th Disconnect SCS service connector from MES connector within 4 seconds. SRS indicator light will indicate that memory is erased by blinking 2 times.

6th Turn ignition off, and wait 10 seconds. Start vehicle like normal and light should come on and go out like normal. You have reset your SRS light, congrats.

If it does not work the first time try it again, the timing has to be perfect. My first time it took me 3 attempts before it worked, but it did work.

Aug 16, 2009 | 2002 Honda Civic

1 Answer

Srs airbag light is on on my 99 pontiac grand prix


If the seat belt light comes on intermittently with the belt buckled, it may have a bad switch in the buckle or a loose connection @ the switch. This may also set a diagnostic trouble code in the srs control module & keep the srs airbag light on.

Mar 27, 2009 | 1999 Pontiac Grand Prix

2 Answers

SRS light on 1997 acura CL


1.bend a paperclip into a u shape. 2.disconnect the yellow plug in your fuse box under the steering wheel and insert the paperclip into the plug that is now hanging there to complete the circuit.3.turn the ignition on and the srs light will stay on for 6 seconds, then turn off.disconnect the paperclip within 4 seconds after that and the light will come back on.4. reconnect the paperclip within 4 seconds and the srs light will turn off again.5.within another 4 seconds of it going off, disconnect the paperclip and the light will blink letting you know that you have completed all the steps right. you can also use some speaker wire

Feb 01, 2009 | 1997 Acura RL

1 Answer

Trouble lights on dash


Hey, The SRS mean " Suplement Restrain System"

Or Air Bag System.

If you have the SRS light, you have problem with the Air bag system. and need to take codes to see what happen or what is damaged.
Honda 2000 Accord come with a yellow connector behind of the Instrument panel fuse box. That is used to take manual codes from the SRS computer.. to see the problem.

I hope this respond your question,

Thank's

Jul 05, 2008 | 2000 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...