Question about Cars & Trucks

1 Answer

96 silverodo won't shift out of 1st unless I let off the gas then shifts but it won't go to od at all just goes as fast as I want but when I let off the gas to coast I have to give it some gas before it feels like it'll go again

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Check the cable from your throttle body to the transmission.

Posted on Nov 24, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1998 Ford Explorer

there is an sensor on the speed odmeter cable on the side of transmission. it will kill thr overdrive and cruise control but not the speedometer. about $50.fixed 2 explorers that way

Posted on Sep 29, 2008

  • 55 Answers

SOURCE: 4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD

check fluid conditon and level, may be a faulty soleniod

Posted on Apr 24, 2009

Molson02536
  • 3854 Answers

SOURCE: 4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD

The EMC detected and problem so it's in limp mode, As long as it's in limp mode the 4th and OD will not activate. Take care not to burn up the transmission by running it hard while your in the limp mode.
Your going to have to get the truck scanned to clear any codes and why there are DTC codes. Auto Zone scan for free and most auto shops charge $10.00 to $20.00 to scan sine they want the business.
If you want to clear the codes your self you can put the ignition to the run position and pull the ECM (Batt) fuse out for 20 sec and place it back in then start the truck. It may stall but let it, just start it again and this would have cleared all the DTC code history.
The transmission should be running fine unless there is a problem and the service engine light will be on again and you'll be in limp mode still with an updated DTC in the ECM.
Good luck and hope this helps.

Posted on May 26, 2009

  • 115 Answers

SOURCE: 96 contour. od light flashing. codes are po732

could be a shift solenoid or another problem with your transmission

Posted on Aug 26, 2009

J-Chris Ward
  • 731 Answers

SOURCE: 1992 GMC Suburban not shifting into OD, Transmission Modulator?

The shift down linkage on the carburetor below the gas pedal cable might need to be adjusted to increase the hydraulic pressure on the internal clutch plates in the transmission it shows you how to do that in a car manual.

Posted on Sep 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

96 chevy silverodo will not shift out of 1st until I let off the gas at high rpm then shifts to 3rd but that's it won't shift any higher


You probably need to service the tranny as in change filter and fluid and in addition to that there is a little round piece which is most likely plugged into the rear of the trans just above the pan with a vacuum line going to it, called a modulator valve which controls shifting, replace it also.

Nov 24, 2014 | Cars & Trucks

1 Answer

96 silverodo won't shift out of 1st until I let off the gas then shifts but then won't shift any higher


sounds like your not getting enough voltage to the shift solenoids. My alternator went out and when the battery voltage got really low the trans wouldn't shift. As soon as I put a new alternator on and charged the battery the trans worked like it should. If your motor is turning over slowly try charging or replacing the battery and see if that helps.

Nov 24, 2014 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Problems shifting into overdrive in my 96 chevy 1500 4x4


i have a 90 chevy 2500 2wd 350ci.when i go to start my truck the key turns hard in the ignition,the check engine light and brake light come on the heater dont work,and the transmission will shift from 1-2 at real high rpm and shift hard,no 3-od.this comes and goes,but all happens at the same time.some times it last for 10 min,sometimes its days.what is going on?

Apr 24, 2012 | 1996 Chevrolet K1500

1 Answer

2000 Ford Focus. Transmission won't upshift unless I let up on the gas pedal. It will shift if I'm accelerating easy, but under a heavier load it won't. - Catalytic Converter isn't blocked...


it sound like it could be a vacuum problem. I have experienced this on cars i have worked on it usually turns out to be a vacuum problem 90 percent of the time.

Jul 14, 2011 | Ford Focus Cars & Trucks

1 Answer

1992 GMC Suburban not shifting into OD, Transmission Modulator?


The shift down linkage on the carburetor below the gas pedal cable might need to be adjusted to increase the hydraulic pressure on the internal clutch plates in the transmission it shows you how to do that in a car manual.

Jan 07, 2010 | 1992 GMC Suburban

1 Answer

Goes into neutral and then shifts hard into 1st on slowdown


It sounds like your input clutch seals are rolling. Is the check engine light on. It could also be the pressure control solenoid could be causing the problem aswell

Sep 02, 2009 | 1998 Buick Century

3 Answers

4L60E Shifts fine in 1st, 2nd, & 3rd but will not shift into OD


check fluid conditon and level, may be a faulty soleniod

Apr 24, 2009 | 1994 Chevrolet C1500

3 Answers

1987 Honda Accord Automatic Jolts in 2nd Gear


You need to change the clutch pads on the cars for a smoother drive...............

May 16, 2008 | 1987 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...