Question about Cars & Trucks

1 Answer

Cleaned throttle body getting fuel pressure new plugs wires distributer cap rotor the works and it won't idle has no power even with the pedal to the floor

Posted by on

Ad

1 Answer

No Vehicle shown

Need lots of info- to get involved in the
issues your having

Who is working on it?

Posted on Nov 24, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 83 Answers

SOURCE: i have no power to my fuel injectors on 88 saab 900 turbo

There should always be power at the injectors as long as the fuel pump is on. The fuel injection ECU provides a ground to the injectors to turn them on.
You most likely have a bad fuel injection ECU. This is a very common failure on 88,89 and 90 SAABs.

Posted on Mar 25, 2009

  • 201 Answers

SOURCE: Bogging while heavy accelration.

vacuum advance working ? do manuel check with cap and rotor button off and see if it's moving. chris

Posted on May 08, 2009

rockitman187
  • 2559 Answers

SOURCE: rough idle

Check or replace the EGR

Posted on May 27, 2009

  • 34 Answers

SOURCE: 1997 chevy silverado 1500 350 vortech, new fule pump not working

before you drop tank again, check fuses & relay.then disconnect fuel line @ filter turn key to on position should hear fuel pump run and get gas stream out of line. if no flow from line new pump faulty be sure & remove negative battery cable first good luck.

Posted on Jun 20, 2009

  • 169 Answers

SOURCE: 91 Jeep wrangler New everything idles rough, no Power then dies

you check for miss how is compression

Posted on Aug 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 infiniti QX4 3.3L (engine has a distributer) stalls out especially when revved from idle. Also won't start or very difficult to start, haven't been able to get it to start for a couple days...


pull one ignition cable out of cap just enough to see the tip of connector and crank it, a spark should jump from cap to tip of wire. no spark means you need the whole distributor replaced. buy it from nissan or infiniti dealer, it comes with cap rotor installed and 12 mo 12k mile warranty, no matter who installs it. dont waste time with aftermarket rebuilt distributor, those are not reliable. https://parts.infinitiusa.com/

Apr 06, 2017 | Infiniti QX4 Cars & Trucks

2 Answers

Half power


check the throttle position sensor.or any oil getting leaked from the throttle body.if its leaking then the oil needs to be cleaned from the throttle body. check out.keep updated.thanks.

Feb 28, 2010 | 1997 Jeep Wrangler

1 Answer

89 laredo 4.0 Starts, Idles but no power


Have you checked the fuel pressure while pressing the gas pedal? Pressure should stay above 40PSI

Jul 13, 2009 | 1989 Jeep Cherokee

1 Answer

87 chevy truck with TBI idles too fast


Spray the intake with carb cleaner to find the vacuum leak. Check where the EGR mounts and the throttle body gasket sense you had both off.

May 10, 2009 | 1987 Chevrolet R20

1 Answer

Car hesitates when i let off the gas pedal


probably need new fuel injectors,or plugs wires, replaced the spark plugs, wires, distributer cap and rotor, run it if still the same, do a compression test if the is good replaced fuel injectors

Jan 30, 2009 | 1991 Cadillac Seville

2 Answers

Engine power loss


Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). in this list u will find a answer to ur problem Shaun 2 Inspect Spark Plug Fouled, damaged or broken spark plug(s). 3 Inspect Fuel Filter Clogged or dirty fuel filter 4 Inspect Distributor Worn, loose or incorrectly adjusted distributor. 5 Inspect Distributor Cap Loose or cracked distributor cap 6 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. grey_line.gif 7 Inspect PCV Valve Plugged or damaged pcv valve. grey_line.gif 8 Inspect Air Filter Restricted or clogged air filter. grey_line.gif 9 Inspect Catalytic Converter Clogged, damaged, defective or faulty catalytic converter. grey_line.gif 10 Inspect Automatic Transmission Improperly adjusted kickdown cable adjustment or internal transmission problems. grey_line.gif 11 Inspect Fuel Pump Improperly functioning fuel pump or circuits. grey_line.gif 12 Inspect MAP Sensor Improperly connected or faulty m.a.p. sensor. grey_line.gif 13 Inspect Mass Air Flow Sensor Improperly connected or faulty mass air flow sensor. grey_line.gif 14 Inspect Throttle Position Sensor Faulty throttle position sensor or throttle position sensor circuit. grey_line.gif 15 Inspect Timing Specification Incorrectly adjusted engine timing. grey_line.gif 16 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. grey_line.gif

Nov 13, 2008 | 2002 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...