Question about 2005 Dodge Stratus
Best you watch a video on a similar motor
Basically get under the car & remove the bolts
holding it on.
Posted on Nov 24, 2014
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
Posted on Oct 18, 2009
Disconnecting the power to the car, or computer for any length of time will not reset the check engine light, or service needed lights. The memory for these lights is stored in non-volatile memory of the computer in the car.
In an OBDI or an OBDII system you must access the computer to reset these lights.
As a suggestion if you have a local autoparts store they sometimes have a �Loan a Tool� program where you can rent a cheap computer access tool (This is not an endorsement, but I know Autozone rents this tool for both systems).
If after resetting this light, it returns then you will need to correct the problem before it can be properly reset.
You must take the battery cables off for about 15 mins. Then connect cables again. Light should come on a few seconds when starting then cut off!
Posted on Dec 19, 2009
jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you
Posted on Apr 13, 2010
Tips for a great answer:
Feb 12, 2016 | Dodge Cars & Trucks
Sep 24, 2015 | Dodge Stratus Cars & Trucks
Jul 18, 2015 | Dodge Cars & Trucks
Feb 01, 2013 | 2005 Dodge Stratus Coupe
Aug 16, 2012 | 2005 Dodge Stratus Sedan
Sep 18, 2011 | Dodge Stratus Cars & Trucks
Aug 24, 2010 | 2005 Dodge Stratus
Nov 11, 2009 | 2004 Dodge Stratus
Aug 21, 2009 | 2003 Dodge Stratus
517 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: