Question about Cars & Trucks

1 Answer

The motor does not work only the panel lights comes on

Every where I can think off

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Cars & Trucks Expert
  • 496 Answers

Check you Battery and the Battery Connections.

Posted on Nov 23, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Window on left derivs side not working

Possibly the switch or the motor itself. Need to pull the door panel and test for power at the window motor plug while working the switch. The positive and negative reverse at the motor plug through the switch. Touch a test light to the motor's plug and hit the switch eaither way. No light and the switch is bad. The light comes on and the motor is bad.

Sep 02, 2011 | 2005 Dodge Caravan

3 Answers

My driver side window wasn't working so i replaced the switch but the driver side window still wont go down. Any info on how to repair my problem, thinking its the motor but can't find any videos...

remove your door panel, disconnect the motor plug, grab your car battery with 2 cables one in each terminal and connect them on the motor plug, one cable in each pin, be careful that the cables don´t touch each other. The polarity doesn't matter, cause if you change them they are going up or they will go down ok. If the window it's up and it doesn't move change the polarity and it should go down. If it works then it could be the switch or something electrical from the plug to the switch. If it does nothing then it´s probably that the window motor doesn't work anymore and you should cange the whole mecanism.

May 14, 2011 | 1985 Buick Regal

1 Answer

When i turn the air on in the front it wont work.but if i turn it on in the back it works just fine.sometimes i can kinda hear it come out the front but nothing is comming out

If you mean you can't hear the fan running in the front, but can hear it run in the back? I think thats what you're saying. There are 2 separate fans. If the front fan works on high speed only, its the blower resistor at fault, usually has a burnt resistor. If no fan speed on any settings, then the front blower motor is faulty. both are common problems. Both are assessable under the passenger side dash, behind lower panel. Find the blower motor and check for power on the purple wire and good ground on the black wire (test light if available) if good power, needs blower motor.

Jan 25, 2011 | 2004 Pontiac Montana

1 Answer

Driver window problem?

Does the window work about half way the stops and if you wait a few min. does the window start working again ? If so it is most likely the window mtr. Another easy ck is to turn the key on without the engine running and operate the drivers window and watch the dome light .If the dome light dims with each direction of the switch then it is most likely the window motor (do this in the garage or at night easier to see the dome light.) If the dome light dims in only one direction than most likely the window switch . The best way is to take the door panel off and disconnect the window motor and connect a test light across the wires and operate the window switch. The test light will light in both directions if the wiring and the switch are good. Then replace the motor. If the test lights in only one direction (up or down ) then you will nee to ck the switch or wiring.

Feb 23, 2010 | 2003 Oldsmobile Alero

2 Answers

I have a 1998 Pontiac Grand Prix. the heat and a/c won't work

needs a new blower motor which comes with a built in reostat ,expensive ,and its a job and a half to fit ,best advice ask a local mechanic to confirm ,grandad in alicante spain

Dec 12, 2009 | 1998 Pontiac Grand Prix

1 Answer

Driver's side window switch doesn't work.The switch that lowers and raises the driver's side window in my 1998 Toyota Avalon has stopped working. Until last week, it worked sporadically. I think the switch...

i know on some toyotas, you do not need to remove the door panel just the handle where the switch assembly is located...if the panel around the switches is plastic then pry GENTLY up on the plastic to dislodge it from the door handle and inspect connections there...if everything checks out fine, then check fuses...perhaps this was a problem for so long that the window motor finally blew a fuse. if so replace both fuse and motor...if fuses okay, then with a long screw driver locate any screws under the door handle, bottom of the door panel, mirror panel etc, and remove...then gently pry outwards on door panel until it is released. disconnect your harness at the window motor and hook in a test light and operate the switch..if light illuminates, replace motor..if not, then replace switch or switch panel..which ever/.

Nov 13, 2009 | 1998 Toyota Avalon

2 Answers

Power windows click but don't work. The drivers window works fine. Replaced the control in drives door. That didn't help

I've exactly the same proble with my drivers window.
i don't think it is the motor as i can hear it trying to wind down.
sounds like the clips for your windowthat the motor attaches itself to the glass have come loose

Aug 22, 2009 | Volkswagen Passat Cars & Trucks

1 Answer

Same exact problem.

Could be the plunger motor/ vaccum plunger under the hood. If the cruise light is on, the computer thinks it is working.

Jun 25, 2009 | 2003 Jeep Grand Cherokee

2 Answers

Just The Turn Signals

Ok remove the under dash plastic panel on both sides. or just lower it remove the lower part of the instrument panel in the center, the CONVIENCE CENTER is behind that panel in the center you will need a TORX screwdriver and I believe that you also need to remove the ashtray i think but please if I'm wrong forgive me
If gthis information is helpful please rate this a fixya! and if I can be of any additional help on this question please contact me here or email me at Thanks so much, Randy

Sep 13, 2008 | 1997 GMC Jimmy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides