Question about Cars & Trucks

1 Answer

92 Chevy 1500 4x4 700r4 trans rebuilt less than 5k with monster in a box kit + new TV cable and torque converter , now I have no reverse. The transfer case works fine.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Ensure you linkage is connected correctly, even if it is slightly out of adjustment it can cause this issue.

Posted on Nov 23, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 840 Answers

SOURCE: 2003 Chevy Silverado

i would check both ways first and see what the mechanical rate is in your area take it to a auto body dealership to have it done cahrges are 85.00 to 110.00at the dealership or private shops ok Please rate my response thank you very much

Posted on Feb 02, 2009

  • 25 Answers

SOURCE: 87 samuria tansfercase problem

It doesnt need rebuilding. The shifter sheet that the gear shifter sits on is worn out or not even there which allows the shifter not to operate properly.

You can order a poly one from vendors like Lowrangeoffroad, Trail Tough, Petroworks, and some others.

Posted on Mar 17, 2009

  • 9 Answers

SOURCE: 94 Chevy Silverado 4L60E Trans. Lost all drive gears

Internal gear selector in Tranny is shot...try replacing with used..or get to a tranny shop..Good luck

Posted on Jun 16, 2009

emissionwiz
  • 76846 Answers

SOURCE: how much does a rebuilt transfer case cost for a

about $600
contact these folks for exact price.
http://www.transfercases.com/order.htm

Posted on Dec 23, 2009

  • 12 Answers

SOURCE: Volkswagen 01M torque converter stuck

You have to be very careful with input shaft rings. They like to eat into the pump stater. Also always buy new vb don't buy rebuilt because they only work 2 out of 5 times. I know this for experience

Posted on Jun 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 jeep 42re trans no drive only has reverse after checked sensors and solenoid A friend of a friend rebuilT it new torque converter filter and fluid and still only reverse after everything replaced


find a friend of a friend of a friend , next time.
LOL
if all forward gears are dead, and the manual lever works.
the trans is bad.
try with TCM unplugged to trans.
and all forward gears dead,
with no TCM , 1st gear must work, it must move.
unplugging it , prevents any TCM wrong doing.
and only the internal manual valve now works,
does it?

Jun 30, 2015 | Jeep Cars & Trucks

1 Answer

88 jeep wrangler 4.2 l with auto trans. Rrbuilt motor and rebuilt trans. Have no reverse. Was told they didnt install new torque converter for some reason. Could that be the problrm?


it could also be the pump, If this was done at a shop ,I would have them answer for it or go to the better business bureau

Feb 14, 2013 | Cars & Trucks

1 Answer

1984 chevy 1/2 ton pick-up either 350 or 400 trans dont know which reverse gear works but no 1,2,3 seems to try to move but wont


Sounds like you need a new transmission. It can only be one of two things: Transmission is old and needs replaced or the torque converter is bad. But if your going to replace the torque converter you might as well make sure you have a good transmission because you have to drop the transmission to get to the torque converter. No point in droping the transmission and replacing the torque converter to find out you need to drop it again because the transmission is bad. You should be able to drop the transmission is a few hours. You only have 3 bolts on the fly wheel and one bolt for the transmission mount and about 6 bolts connected to the engine. Then you have your fluid lines speedometer cable and drive shaft. And your dip stick.

Feb 04, 2011 | Chevrolet C1500 Cars & Trucks

1 Answer

1995 Ford Explorer, 4.0, 4x4, near 200k miles. Vehicle shudders at light acceleration at approx. 55mph after deceleration. The symptom is intermittent and is less likely to occur with harder throttle. I...


1995 ,and changing gearboxes ,is it honestly worth it ,this vehicle is 15yrs old and not worth more that 500 euros in its present condition ,their are two of these gas consuming monsters here in a local car dealer and i expect he would pay you to remove them ,anyway if you do change it then i doubt if you need to change the torque converter ,but you will have to remove it with the box so you can locate it in the new one prior to fitting ,their is a dog clutch shape that has to align for the front pump drive .Best advice is to renew the vehicle with a diesel coupled to a manual gearbox

Dec 09, 2010 | Ford Explorer Sport Trac Cars & Trucks

2 Answers

Torque Converter Clutch Circuit Stuck On


the torque converter clutch circuit is inside the torque converter and is not something u can repair, the torque converter must be cut apart and rebuilt by companies who specialize in this, so all you can do is pull the transmission out of the car and replace the torque converter with a rebuilt or new unit.

May 27, 2010 | 1996 Chevrolet Cavalier

2 Answers

New automatic transmission was installed but does not go forward or in reverse?


Heres some ideas start with the basics make sure you have trans fluid to the correct level. Next maybe the torque converter was not bolted on. Last maybe the trans is defective I know you say its new but even new parts come defective.

Dec 02, 2009 | 2004 Suzuki Forenza

1 Answer

92 olds cutlass ciera trasmission slips in reverse


Sorry, there are no electronic controls for reverse on the 125 trans. It will need rebuilt or replaced.

Apr 07, 2009 | 1992 Oldsmobile Cutlass Ciera

2 Answers

Transmission stuck in neutral


There are diagnostic pressure tests that can be performed at a shop. Requires special adapters,guages and spec sheet. Most likely trans failure. Possible failed torque converter or front pump.

Mar 30, 2009 | 1999 Ford Windstar

1 Answer

Chevy TH350 trans problem


if you just had it rebuilt should ba a warranty if is was im sure you wouldnt be on here asking so did you install new torque converter when the trans was rebuilt? check the trans filter not clogged how long did it run after the rebuild or did you install it yourself after the rebuild and it doesnt work ? let me just say the torque converter should always be replaced with the transmission new or rebuilt and when the transmission is being installed you have to make absolutely sure the converter is all the way back on the trans if not you will damage the front pump on trans and would need to replace it .

Mar 23, 2009 | 1985 Chevrolet Nova

2 Answers

My reverse is gone what do I do?


the "sun shell" or reaction shell broke inside the transmission< if you notice 2nd gear is also gone or working funny. Transtar makes a hardened shell that costs about 40$ but you need to remove the transmission to fix it, and overhaul is best. The burnt fluid smell is because the torque converter has been slipping when you are on the highway, sonex makes a repalcement valve that should be installed by a train proffessional. Solution is rebuilt trans with new converter and parts i have listed in the paragraph

Feb 21, 2009 | 1995 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...