Question about Cars & Trucks
Try using a scanner to see if there is a code recorded and then use the scanner to reset the CPU program
Posted on Nov 23, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Problem is a faulty Steering Angle Sensor (part of Steering Module) located in steering column ...replacement part $600.00.
Posted on Apr 16, 2009
Misalignment of the belt, incorrect belt, worn or loose tensioner, Too tight of an adjustment (many service centers do this on purpose so when the belt breaks in it becomes properly adjusted, I do not believe in this philosophy), The belt is actually one long belt called a serpentine belt.....
Posted on Feb 21, 2010
SOURCE: ESP/BAS warning light on. went
Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.
If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..
Posted on Feb 13, 2011
Tips for a great answer:
Nov 05, 2016 | 2006 Dodge Durango
Sep 01, 2014 | 2004 Dodge Durango
Jan 12, 2014 | 2004 Dodge Durango
Jun 18, 2012 | 2005 Dodge Durango
Jul 06, 2011 | Dodge Durango Cars & Trucks
Nov 17, 2009 | Dodge Durango Cars & Trucks
Jun 04, 2009 | 2006 Dodge Durango
27 people viewed this question
Usually answered in minutes!