Question about Cars & Trucks

1 Answer

<!-- from fixya rte -->Disconect the hose to heater - Cars & Trucks

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 65 Answers

I take it you have a leaking heater core. You can buy two hose clamp pliers and they squeeze the hose tight and no water will flow when you put them on the hoses.

Posted on Nov 22, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Where is the heater core located and how to change the heater core on a 2000 Nissan frontier 2.4 L cylinder

If it has a AC you have to pump down the AC remove the entire heater and AC unit so you can disconect AC lines and heater hoses ,you have to drop the steering column and remove the glove box, its a big job I would buy a manual so you know what all you have to disconect.

Mar 02, 2015 | 2000 Nissan Frontier

1 Answer

How can I tell if the heater core in a 2001 FORD FOCUS IS PLUGED OR is NO GOOD ?


Dec 21, 2014 | Ford Cars & Trucks

1 Answer

How to disconect heater pipes going to rear heater

\look at the passenger side rear fire wall inside your engine compartment you will see a big plastic heater control valve that all the hoses front and rear heater hoses hook up to that one plastic valve find the two hoses that lead off towards the rear of the body of your suburban ten take tem off and buy a short piece of 5/8 or 3/4 hose and connect those two empty nipples together and make sure you hose clamp them together tightly so they dont leak and overheat your truck ok

Aug 04, 2014 | 1996 Chevrolet Suburban

2 Answers

How to replace heater core in 2002 oldsmobile intrigue

most heater cores are behind the dash board on the passenger side.Look inside your engine u will see two hoses running to the firewall on the passenger side.They r going to your heater core.Sometimes you have to remove the dashboard completely it all depends on the car.

Oct 08, 2013 | Cars & Trucks

1 Answer

Hello i have a 1999 chevy blazer heater does not work i check the climate control i install a new one and still does not work did check water houses going to heater radiator and they do not get hot car has...

there most likely air in system. disconect the hoses that go to the core and run water threw th core and the hoses with a gardenhose reconect the hoses and run the truck .hope it works common promblem.goodluck.

Jan 21, 2011 | 1996 Toyota Corolla

1 Answer

Heater core how to replace the heater core

normally you have disconect the battery recover A/C gas, drain your coolant, disconnect two heater hoses connected to heater core, take off steering wheel, column, center console, take off both A-pillar trims,remove complate dashboard, disconet two line from condenser or expansion valve, take off A/C/Heater housing and dismatle the housing to access the heater core. good lock

Jan 12, 2010 | 2000 Kia Sportage

2 Answers

How to install a heater core on a 2005 dodge grand caravan

Very easy if you go through the lower part near the peddles

Dec 24, 2009 | 2005 Dodge Caravan

1 Answer

1996 econoline heater core

The blower motor is not connected in any way to the heater core. A very basic set of tools should suffice.

Apr 29, 2009 | 1998 Ford Econoline

1 Answer

How do I change out a heater core on a 1997 GMC 1500 Pickup truck

you need to remove the glove box disconect the heater hoses look behind the glove box some heater boxes are two pieces and you can remove the heater half some you need to remove the whole piece if that is the case let a garage do it because they need to disconect the a/c so it needs to be evacuated and recharged if it is a two piece box just remove the bolts that hold the heater core under the dash and pull the box strait back good luck

Dec 22, 2008 | 1994 Chevrolet C1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides