Question about 1992 GMC Jimmy

1 Answer

How do I remove the digital cluster


Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 209 Answers

Gently pry off the trim bezel on the outside of the dash to detach the clips. You may have to tilt the steering wheel down all the way to get the bezel out of the way. Once it is out of the way, you can see the screws holding the instrument cluster in place.

Posted on Nov 23, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Instrument cluster illuminates intermittently on 1990 eldorado

If this is the analog intrument cluster and the entire instrument cluster is intermittently losing illumination, remove the instrument cluster light fuse and replace it with a new fuse. It is remotely possible that the actual fuse holder wires have broken due to age and would need to be soldered back together.
If this is the digital instrument cluster and the entire display is going dead, it could be anything from the wiring harness to the BCM. If it is the digital instrument cluster, I can really only recommend taking it to a reputable shop or Cadillac dealer to service.

Dec 21, 2016 | 1990 Cadillac Eldorado

1 Answer

Ho to fix the audi tt digital instrument panel

You pull the cluster out and have it rebuilt. Check online for repair facilities, there are lots of the. They will supply removal instructions on request and a shipping container t send it in, turnaround is about 10 days.

Aug 17, 2016 | 2001 Audi TT

1 Answer

How do I remove the digital cluster instructions on. A gmc jimmy 1992

detrim the dash panel, snaps around the perimeter, a few bolts underneath, I think...when istr. panel is visible, you will see the surrounding mounting screws, remove, pull cluster forward, disconnect electrical connectors....reverse to install

Nov 22, 2014 | 1992 GMC Jimmy

1 Answer

How can you take the instrament cluster out of a 97 ply voy 6 cyl 3.3. how do you do it with step by step instructions?

Take the screws out of the dash on the driverside. There will be roughly 8 screws. The dash will be removible by pulling slightly around the edges. Pull the top part of the dash off first then work your way down past the steering wheel. The instrement cluster has 4 screws in it take them out. Tilt the top of the instrument cluster forward. Disconnect the pig tail and slowly remove. I say slowly cuz I. Had some places I had to feness out. Reverse the instructions for reinstall. Email me if u need more help.

Oct 02, 2012 | 1997 Plymouth Voyager

2 Answers

How do you replace dashboard lights behind speedometer on 1993 sonoma

You will have to remove the cluster to access the bulbs. Not too terrible of a job, but it is a little time consuming.

Aug 27, 2011 | GMC Sonoma Cars & Trucks

1 Answer

Need schematics or instructions to disassemble dashboard on a 1995 Chev Tahoe. "idiot" lights need replacement

Disconnect the negative battery cable. If it is equipped with tilt steering, lower it to the lowest position. Unfasten the 8 clips that retain the instrument cluster bezel and remove the bezel. There are 4 clips on the top of the cluster and 4 on the bottom of the cluster bezel. Unplug the electrical connections from the headlamp switch, dimmer control and any other accessory switches that would interfere cluster removal. Unfasten the 4 cluster retaining screws and remove the cluster making sure nothing contacts the circuit connections. Turn the bulb assembly 1/2 turn to the left to remove. To reinstall, Install the bulb assembly. Place the cluster into position without touching the connector pins. Install and tighten the cluster retainers. Install the remaining components in the reverse order of removal.

Oct 23, 2010 | 1995 Chevrolet Tahoe

1 Answer

Dash board is digital and the dash lights went out seeking information on how to remove the dash board console 1993 chevy blazer tahoe LT

Remove the 5 mounting screws from the instrument cluster trim plate and remove the trim plate. Remove the 4 mounting screws from the instrument panel face plate and remove the face plate.Remove the instrument light grid from the center of the cluster. From behind the instrument cluster reach behind the speedometer and disconnect the speedometer cable by releasing the tab. Pull the cluster forward just enough to detach the "check engine" light bulb from the center of the cluster. Remove the instrument cluster from the dashboard.

Jan 13, 2010 | 1993 Chevrolet S-10 Blazer

1 Answer

Need to replace instrument cluster/AC bulbs

Hello, You can obtain a 2004 Ram Factory Service Manual with all of that information available from The reason why it may be so important is because right before the removal instructions the service manual has diagnostic instructions to try. There are numerous pages on removing the instrument cluster, and cluster bezel.

(1) Disconnect and isolate the battery negative
cable. (For Airbag)

(2) Remove the cluster bezel from the instrument
panel. (Refer to 23 - BODY/INSTRUMENT PANEL/

(3) Remove the four screws that secure the instrument
cluster to the instrument panel structural support
(Fig. 5).

(4) Pull the instrument cluster rearward far
enough to access and disconnect the instrument
panel wire harness connectors for the cluster from
the connector receptacles on the back of the cluster

(5) Remove the instrument cluster from the instrument

Oct 01, 2009 | 2004 Dodge Ram 1500

2 Answers

1995 Cougar Odometer/trip-meter inop

Section 13-01: Instrument Cluster—Conventional 1995 Thunderbird, Cougar Workshop Manual REMOVAL AND INSTALLATION Instrument Cluster Removal and Installation
  1. Disconnect battery ground cable (14301) .
  1. Remove screws holding instrument panel reinforcement (017A28) .
  1. Remove screws holding instrument panel lower shield (045G02) .
  1. Remove fasteners holding steering wheel column as outlined in Section 11-04 . Gently lower steering column.
  1. Remove fasteners holding the instrument panel finish panel (044D70) and gently pry off.

  1. Remove four instrument cluster retaining screws. (Do not remove screws from the instrument cluster main lens (10887) and instrument cluster mask (10890) ).
  1. Slide the instrument cluster (10849) to the right of the instrument panel opening and unhook the instrument panel harness from the back of the instrument cluster .
  1. Remove the instrument cluster from the instrument panel (04320) .
Speedometer/Odometer Federal law requires that the odometer in any replacement speedometer (17255) must register the same mileage as that registered in the removed speedometer . Since the speedometer mileage cannot be reset on this unit, affix odometer sticker to driver's door pillar and record original vehicle mileage. Removal
  1. Disconnect battery ground cable (14301) .
  1. Remove the instrument cluster (10849) as outlined.
  1. Remove seven screws retaining the instrument cluster mask (10890) and instrument cluster main lens (10887) .
  1. Remove speedometer assembly.
  1. Position the speedometer assembly to the instrument cluster back plate (10848) and install.
  1. Position the instrument cluster mask and instrument cluster main lens to the instrument cluster back plate and install the seven retaining screws.
  1. Install the instrument cluster as outlined.
  1. Connect battery ground cable and check the operation of the speedometer .
please rate if this helps

Mar 24, 2009 | 1994 Mercury Cougar

2 Answers

Speedometer not working

I would hold off on trying to buy a new or used instrument cluster unless your sure thats the problem.... your vehicle is equipped with a speed sending unit and that can be faulty ask your self is the other functions of the cluster working? tachometer, fuel, lights etc? then may only be sending unit for speed have it checked out by a pro or follow instructions of troubleshooting section of your repair manual I always try to keep it simple did you check the fuses and relays? then move on from there. If it is sending unit or cluster heres a place I have used for years to get hceap good used and new parts Peach street autorecycling 18003652341 ggod luck and dont forget to rate me if I have helped.

Dec 29, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
1992 GMC Jimmy Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides