Question about Cars & Trucks

1 Answer

I habe a terex d400c dozer it doesnt like to engage the drive it has to warm up then u have to rev the motor real hy to get it to engage once engaged u can shuttle between f and r without problem unlesd u let it idle for a few min the its back to the high rpms again

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,156 Answers

Low on tranny fluid

Posted on Nov 22, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Thunder55
  • 318 Answers

SOURCE: 1995 grand cherokee trans not shifting in to second gear

Check transmission fluid levels,,replace lost fluid as needed,,,if this does not work,,take the car to a mechanic,,,sorry to say,,this kind of problem almost alway's requires a transmission mechanic to repair.

Posted on Jan 16, 2009

  • 1 Answer

SOURCE: High RPMs

The fans problem could be its clutch assembly. Replacing the clutch can solve it, it should help with engine performance. Might cost from $100 to $300 depending on the route you take

Posted on May 05, 2009

  • 1 Answer

SOURCE: 2004 jeep grand cherokee idling problem. Revs motor 200 to 500 rpms higher while driving.

I had the exact same problem on my 04 GC. I put some Techron Concentrate Plus Fuel System Cleaner in from Wal-Mart and it seemed to fix the problems right away. Let me know.

Posted on Jun 01, 2009

  • 11 Answers

SOURCE: High idle.

try clean idle speed control.

Posted on Jul 05, 2009

  • 1071 Answers

SOURCE: Integra revs RPMs when idling

idle air control motor or just a plain old vacuum leak

Posted on Jul 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a terex d400c dozer when u start up it


Ensure the transmission fluid is full. That can cause this issue.

Nov 23, 2014 | Cars & Trucks

1 Answer

Starter on 1.9L z3


Chances are you have a bad starter solenoid

Feb 19, 2014 | Cars & Trucks

1 Answer

My 1998 Camry (manual) once warmed up revs up to 2000rpm's when the clutch is depressed or no gear is engaged.


You have a MASSIVE vacuum leak....OR... IAC motor took a dump or the wires have fallen off. The fuel pressure regulator hose is leaking or has fallen off.i::: will pump full pressure and flood the injectors.
When It dies go FULL throttle to start.

Nov 14, 2012 | 1998 Toyota Camry

1 Answer

1986 K5 Blazer 4x4 wont move when put in drive or reverse even in 4x4


Hi Don, have you checked the gear box oil level? Regards John

Sep 01, 2012 | Cars & Trucks

1 Answer

4 wheel drive doesnt work.front driveshaft is working.front tires will not engage


i am not sure but i think you have an electric motor on your front axel that engages the 4 wheel drive. check that to make sure it is engaging. a haynes manual would really help you out with this.you can get one at most parts houses for around 15 bucks.

Dec 26, 2010 | 1988 Chevrolet K1500

1 Answer

Car wont crank at all. started once after battery replaced. starter doesnt even engage now.


Clean the battery post real good,and shining ,and the cable ends also,then replace them on the battery,and tighten real good.

Jan 16, 2010 | 1990 Volkswagen Golf

1 Answer

Once in Drive, Jeep does not easily shift back to Park


Try to check the trans mission gears of your 1995 jeep grand cherokee.The shift fork and the clutch sleeve of the trans mission is locking to the other gears .And then also check the starter motor and its solenoid.if the starter motor solenoid is destroyed or worn out replace .

Jul 28, 2009 | 1995 Jeep Grand Cherokee

1 Answer

Four wheel drive computer clicks when i try to engage 4x4


tap on the 4wd motor on the transfer case while someone is pushing the button, if engages you need a new motor

Jun 30, 2009 | 1987 Ford Ranger

1 Answer

My Clutch won't engage into gear. Need advice!


Did you check the clutch reservoir under the hood mounted on the firewall, driver side? Make sure level is up where it should be. If it's real low, you may have to bleed the system to get the air out. If you need to add fluid, use brake fluid.

Apr 16, 2009 | 1997 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...