Question about Cars & Trucks

1 Answer

Why is my 1982 wb statesman engine reving at 3000 revs at start up all linkages and cables in correct positions.thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 57 Answers

Sounds like dashpot i stuck when u accell quickley and then return to idle their is a dashpot that keeps the plate from snapping shut iy lets it close slow if it is out of adj or just stuck it could hold yout throttle plate open

Posted on Nov 22, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My1991 mazda 626 will not rev up over 3000 rpm


DO YOU MEAN WHEN YOU ARE ACCELERATING? Or do you mean sitting and reving the engine? If you are just reving the engine in park then the rev limiter is kicking in.

Feb 07, 2012 | 1991 Mazda 626

1 Answer

Engine is reving while idling


I think you mean 3000 RPM right? Or are you talking about your idle, even still 300 cant be. Let me know...

Nov 25, 2011 | 2000 Mercury Sable

1 Answer

Engine revs to 3000 rpms when clutch is pushed in


Check all cables and linkages from the clutch pedal out. Check engine compartment for vaccume leaks.
Make sure and set the parking brake before you start inspecting the vehicle

Jun 24, 2011 | 2002 Ford Ranger Regular Cab

2 Answers

1995 mazda mx6 2.5 v6 kl engine. Replaced head gasket cam timing and enerything fine but when u start it the engine revs to 3000 rpm for about 5 seconds then comes down. then starts reving itself to about...


Hi,
Looks like vacuum leaks and some sensors are not connected.
Re check everything again and tell us what happen, so that we could guide you better.
Thanks for using Fixya!

Dec 08, 2010 | 1995 Mazda MX-6

2 Answers

1982 firebird trans am with the 5.0 V8. when started ti immediately goes to 7000 rpm. Looked at the throttle linkage and it appears to be free and working correctly. what else should I be looking for?


DOES ENGINE REV OR JUST TACH READS 7K?
IF JUST TACH READING THERE IS FIX ( RESISTOR)
IF REVS CHECK FLOOR MAT OR SECONDARY ON CARB. HUNG OPEN

Dec 08, 2010 | 1983 Pontiac Firebird

1 Answer

Vw polo maintains engine revs when foot is off the accelerator.


You need to check the cable the runs from the gas pedal to the engine, it might be rusty and need some drops of penetrating oil at the point it meets with the engine accelerator valve.

Feb 11, 2010 | 2007 Volkswagen Golf

1 Answer

Automatic choke is stuck on my bmw


the 318 is fuel injected and has no automatic choke,it does have a cold start system to aid in cold starts,the most likely cause of your problem is a bad or dirty throttle position sensor.you may also need to clean the throttle body and throttle linkages or cables

Apr 29, 2009 | 1996 BMW 318

1 Answer

R reg escort reving


Sounds like an accelerator cable that is getting stuck in its sheath or linkage under the hood the is sticking. Try pulling up the accelerator pedal when the engine is racing; if it drops down to normal idle, then the above is a good place to start.

Nov 23, 2008 | 1998 Ford Escort

1 Answer

Engine sputters when load is applied.


check vacuum lines, MAP and MAF to be sure they are correct.

Oct 03, 2008 | 1998 Chevrolet Camaro

2 Answers

Car problems


I have same problem with 2002 laguna. Before warning lights and revving at 2000rpm starts car feels jumpy. Have to stop, take card out of slot and back again to start without fault. Happens a few miles drive later again. Anyone got a solution?

Sep 06, 2008 | 2003 Renault 181

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...