Question about Holden Cars & Trucks

1 Answer

I have as problem with my holden 308.it was fine when I drove it last Saturday when I started it up Monday went straight up to 3000revs.all linkages and cables ok carby arm sitting on idel it is a 308

Made sure all linkages and cables in the correct position

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 61 Answers

Push the Carb throttle arm home, take of air filter and see if butterfly fully closed, if not repair.

Posted on Nov 22, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: abs light on

I'm a Ford service adviser. There are many reasons for the
abs warning indicator to come on. The usual cause is from a
faulty speed sensor. Either a wheel speed sensor or the
differential speed sensor. I don't think the light is related to your vandalism. You might want to take the truck to an auto parts store and have them read the codes for you. Most auto parts stores will do this for free.
Good Luck

Posted on Jun 23, 2008

  • 1 Answer

SOURCE: 97 nissan sentra windshield wiper linkage arm disconnected

Most likely you will have to replace the wiper linkage from the center pivot to the left or drivers-side wiper pivot. The plastic piece in the linkage gets brittle over time and breaks down. To save a hassle in the future, replace both linkages. It should be under $20.00 for parts.

Posted on Sep 14, 2008

  • 1 Answer

SOURCE: Truck won't start something to do with Anti-Theft tried removing positive cqble to reset alarm nothing, possible wire off Anti Theft Unit Truck drove fine parked for one hour and went to leave, the en

not positive but look in owner manual for a fuel pump reset button i had this problem at one time and that fixed it it is usualy under the dash area somewhere on the drivers side or in a kick panel (decorative cover on the side firewalls inside the cab)....good luck i hope this helps!

Posted on May 15, 2009

  • 491 Answers

SOURCE: 2005 Dodge Caravan with Dead Battery. Replaced

Disconnect battery from vehicle overnight to check for internal battery drain.......just take one of the cables off.
If the battery is still up and starting the vehicle after being disconnected after a day or two......the drain IS in the vehicle and will have to be checked again.
Do it yourself.
Buy a cheap 12 volt test light.
Place it between the cable you removed before.
One end on the battery post and the other on the cable end.
Now....with the key off......
If the light glows brightly....you have TOO MUCH drain.
We want a dim glowing light.
The dim light is just the memory circuits in the electronics and OK.

With the doors closed....take out one fuse at a time until the light glows dim.......the fuse that dims the light is the problem circuit.
If no fuse dims the light...remove relays one at a time.
Remember....some fuses and relays could be in the engine compartment and under the dash.
If no relay dims the light disconnect ALL alternator wires.
Remember....anything that uses power will make the light glow ....keep those doors closed (we do not want interior light drain affecting the test ) and if you have a under hood light check it first by removing the bulb.
We do not want false readings.

Posted on Sep 22, 2009

  • 1 Answer

SOURCE: transmission cable falls off linkage arm

I'm looking for this part too. The shifter arm in my Trailblazer has become disconnected from the transmission cable and I currently have it held on with wrap ties. Any luck finding this part and installing it?

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the MIL code "PO 320" mean, please?


code p0320 refers to cam shaft position (CKP) sensor/engine speed (RPM) sensor--circuit malfunction=== causes --wiring--CKP/RPM sensor ---ECM
because the engine runs ok until it is on cruise control I would be investigating the RPM sensor for a fault
The cruise control takes its control from the RPM sensor and if that circuit is interminable the the cruise control doesn't know what rpms to maintain.

Jan 29, 2015 | Cars & Trucks

1 Answer

2005 Chevy Silverado, 4.3 liter, 2wd. It won't start


could be moisture is that year a coil pack or distributer

Dec 04, 2012 | 2005 Chevrolet Silverado

1 Answer

I drove the car saturday and all was fine. Got in it monday and it won't start. It turns overs and tries to fire but won't. It has gas, a charged battery. What am I missing. I just bought this...


I've had trouble like that with my car before. Check the starter. A lot of times the starter can have the same symptoms as a battery. Hope this helps!

May 24, 2011 | Chevrolet Cavalier Cars & Trucks

2 Answers

My 1999 yukon wont start i changed master air flow


Fuel pumps are real common to go out on those vehicles

Mar 15, 2010 | 1999 GMC Yukon

2 Answers

99 Sunfire Coolant keeps dumping


You need to find the source of the leak. it hasn't overheated yet because you keep catching it and re-filling. From your description, it sounds a lot like a bad water pump seal (part of pump) but without physically looking you can't be sure of that. when the pump seal begins to fail, internal pressure while running often will drive the seal tighter against the shaft stopping the leak. as pressure drops as the engine cools, the seal relaxes and permits seepage.
With time, that will change and it will leak all the time.

Oct 06, 2009 | 1999 Pontiac Sunfire

2 Answers

Engine runs wild with white smoke


If its a 4JX engine then its injectors and seals at fault dont run it any more cos it may blow up - like rods through the side !
The diesel is going straight into the engine without being injected and as the fuel lift pump is mechanical it wont stop on the key .
Should be under isuzu warranty though they are doin that repair on 1998 Troopers over here for free .

Apr 04, 2009 | 2002 Isuzu Trooper

1 Answer

Wont Crnk


did ya get it goin???? havent heard from you???????

Oct 26, 2008 | 1995 Jeep Cherokee

1 Answer

Wont Crank


It's probably one of these:

1.NSS- (Neutral Safety Switch)
2.CPS- (Crankshaft Position Sensor)

**Look here-
CPS 1/2 way down..
http://www.lunghd.com/Tech_Articles/Engine/Basic_Sensors_Diagnostics.htm

**And here-
NSS.. .
http://www.cherokee-jeep.com/1-2swremov.htm

Oct 24, 2008 | 1995 Jeep Cherokee

3 Answers

Wont Crank


im thinking its the starter..i would take it out and brin it into like an autozone they test them for free..

Oct 24, 2008 | 1995 Jeep Grand Cherokee

1 Answer

Won't start!


the spark from the starter is a loose wiring or short starter,but the main thing is you can crank it,check it, you have a spark at plugs if yes check if your pump is working

Jun 17, 2008 | 1991 Volvo 740

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Holden Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14337 Answers

Are you a Holden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...