Question about 2008 Toyota Land Cruiser

1 Answer

200 series vibrating around 1400 - 1600 RPM. Any ideas of the problem.

Eliminated gear box, harmonic balancer, tyres, wheel bearings

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 12 Answers

Will it vibrate in park or neutral? or going down the road?

Posted on Nov 22, 2014

Testimonial: "It will vibrate around 1400 rmp's even in park if the rev's are that high"

  • Randy Freeman
    Randy Freeman Nov 22, 2014

    Are you sure the motor isn't missing. Sometimes one running rough will cause a vibration.

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
Levyathos
  • 60 Answers

SOURCE: Grease wheel bearings

Hi... You remove them with a 20-24mm wrench. Wash them in solvent in order to get rid of the old grease, and repack them with high quality bearing grease that you can obtain from a regular part store. Pack as much grease as possible in them, then put back. You should be good for another 50,000 miles.

Posted on Aug 21, 2008

  • 119 Answers

SOURCE: steering wheel shakes at 75

check the steering joints, wheel hub bearing worn or in the hub there is two big nut check the iner one if it is loose.after dont forget to lock nut with washer.
change swevel bearing it has two bearing each side one on top and bottom.
put the grease jop done.

Posted on Oct 19, 2008

  • 2976 Answers

SOURCE: Prado 1993 vibration at high speed

If your tires are excessively worn or is you have a puncture sealant in them, it can cause these issues.

Posted on Aug 04, 2009

  • 9 Answers

SOURCE: 100 series 1995 landcruiser. Vibrates between

It sounds like either your front shocks or your rotors

Posted on Apr 08, 2010

oberkiuler
  • 51 Answers

SOURCE: strong juddering/vibration coming from the front

You should check tires for uneven wear,wheel bolts. Also loose parts in suspension.

Posted on Jul 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Steering is vibrating when ot reaches 100kph & above. What may be the root cause? What is to fix? Thanks


The first thing to have check are the tires, the from tires since the steering is vibrating. Also take your car to have all of the tire balance, if they are out of balance it will vibrate at higher speed. Thos two are the most common issue for a vibrating steering wheel.

Mar 09, 2015 | Cars & Trucks

1 Answer

Why do my 2003 bmw 745i vibrate while driving


several reason that should be checked.. Check for balance Check the condition of the tyres . check for sidewall bulges and belt separation. check the discs are not warped. check that the steering joints are not worn. Check cv joints ("u") joints in the drive shafts .Run the fault codes and check for engine misfire on a cylinder.. Check the wheel alignment. Check all pulley bearings and unit bearings on the motor that are belt driven. Check harmonic balancer if fitted.

Jul 29, 2014 | 2004 BMW 745i

1 Answer

My 2005 crv honda vibrates at 40klm and through to 70klm tyres have been changed around at the honda dealers but still vibrating


When you had the tyres swopped round, did they check the balance of each wheel and if all wheels ran true (not bent or buckled), or any deform in a tyre. Generally if you can drive through a vibration it is due to a wheel being out of balance. Other cause of vibration, is wheel alignment being out, (constant, and gets worse as you speed up). Drive shaft out of true (balance or bent)

Jan 05, 2014 | 2009 Honda CR-V

1 Answer

What causes vibration in front right side near or in the wheel?


vibrations come fro bent shafts , bad wheel bearings out of adjustment bearings, warped disc rotors, faulty tyres ( band shifted ), bulges on side walls, out of balanced tyres

Dec 29, 2013 | 1998 Nissan Altima

1 Answer

I have a Citroen xsara piccaso 1.6hdi and have a vibration on the n/s front any ideas


jack the front up and spin the wheel ,lay you pound to a penny the front tyre is deformed ,i blame the garage that checked the tracking and balancing for not checking the tyre first ,but as they only pay peanuts then no doubt it was only a semi skilled grease monkey you got to it for you ,change the wheels front for the rear and then it will be ok

Apr 13, 2013 | Citroen Cars & Trucks

2 Answers

1999 S10 4CYLINDER ENGINE VIBRATION


Im sure you have a harmonic balancer. Its the pulley on the crank. If you look at it closely you'll see the thin layer of rubber. If the engine vibrates throughout its normal rpm range when idling or driving it could be a vacuum leak, and it is possible to have two plug wires reversed and have the engine run. Where the timing gears lined up, exactly? Maybe you just built a monster engine!

Dec 22, 2012 | Cars & Trucks

1 Answer

2004 GMC Safari Motor Vibrates


exhaust resonance is unlikely
vibration is caused by something spinning that is out of balance
it can also be from a misfire or a mechanical problem
considering the mechanical problems
harmonic balancer - replaced delete reference unless loose bolt
loose clutch pressure plate --no information as to auto or manual--possible
cracked flex plate--no information as to auto or manual ---possible
failing cam shaft lobes --cam nobes wearing off causing valve timing problems --very possible
faulty hydraulic lifters --pumping up and holding a valve off the seat -possible
hydraulic follower failure --excessive valve clearance altering valve timing --very possible
ignition timing too far advanced -- tune up should have checked that but is a possibility
failed water pump bearings --noisy but a possibility
viscous fan hub ( if not electric fans )-- a distinct possibility--bearing failure and fan running off center-off balance
injectors --- any injector squirting but not the same amount as the others will cause a harmonic unbalance --possible
except for the cam shaft as mentioned , the engine has done 30.000 miles so any fault in the rebuild would be shown up before that mileage was done
drive line problems ---unlikely as you state it vibrates when stationary and that confines it back to the engine and transmission
only parts spinning are the engine parts and the input shafts , torque converter or clutch

Mar 25, 2017 | 2004 GMC Safari

2 Answers

Severe vibration from engine


If it makes the mirror blur without driving the wheels, then I would say main bearing issues.

Jun 08, 2017 | 1998 Ford Explorer

1 Answer

Around 30mph a vibration comes from the right rear of the car. whats the likelyness that its a wheel bearing?


most likely to be tyre/wheel damage (from kerbing etc), wheel balancing, wheel bearing or suspension bushes worn. pretty much in that order.

Feb 27, 2011 | 2000 Chrysler Concorde

Not finding what you are looking for?
2008 Toyota Land Cruiser Logo

67 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...