Question about Cars & Trucks

1 Answer

<!-- from fixya rte -->Why is there a Fault light on VSL 66 - Cars & Trucks

Posted by on

1 Answer

Because you have yet to check for the fault codes,
have them diagnosed & the vehicle repaired

Posted on Nov 21, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Set the timing on a 66 thunder bird


Connect a timing light sensor to the #1 plug and point the light at the harmonic balancer. Rotate the distributor (after loosening the hold-down nut) until the indicator shows the index mark at the proper location (which is probably 6-12° BTDC). If you can get hold of a "Chiltons" manual for the car, you'll be good. The '66 T-Bird had either a 289 or a 350. Be sure to get the right manual for your engine.

Jan 18, 2015 | Cars & Trucks

1 Answer

I have a code 66 motor runs rough and idles up and down check engine light when sshift in 1st gear bucks and jerks stalls out


Code 66: Mass Air Flow sensor circuit below minimum voltage.
I recommend you replace the MAF sensor

Apr 27, 2011 | Ford Mustang Cars & Trucks

1 Answer

463A COD ERROR VW PASAT


hi i need help i have vw passat 1.9 tdi 66 kw 99 year i have problem the car dont have power to go . turbo its on bot car dont have speed and i have fault 463A and fault 04D5 can same 1 help me pls
ty

Jul 18, 2010 | 2003 Volkswagen Passat

1 Answer

WHY IS THE SERVICE ENGINE LIGHT ON IN MY SATURN??


The Check Engine light will light when the ECU stores a trouble code.
Counting the Flashes
To retrieve trouble codes, turn the ignition key to the "on" position with the engine OFF.
The Check engine light will flash many short blinks. The total number of blinks equals the code number. For example, flash,pause, flash,flash = code 12.If more than one code is stored, the Check engine light will flash the codes in sequence (lowest to highest) with a pause between each code. The codes will repeat until the key is turned to the OFF position.

11 Transaxle codes present 12 Diagnostic check only 13 Oxygen sensor circuit 14 Coolant sensor/high temperature 15 Coolant sensor/low temperature 17 PCM fault - pull-up resistor 19 6X signal fault (92-95 models) 21 Throttle position sensor-voltage high 22 Throttle position sensor-voltage low 23 IAT circuit low 24 VSS circuit-no signal 25 IAT circuit-Temp out of high range 26 Quad driver output fault 32 EGR system fault 33 MAP sensor - voltage out of range high 34 MAP sensor - voltage out of range low 35 IAC - rpm out of range 41 Ignition control circuit-open or shorted 42 Bypass circuit - shorted or open 41/42 IC control circuit grounded/bypass open 43 Knock sensor circuit shorted or open 44 O2 sensor indicates lean condition 45 O2 sensor indicates rich condition 46 Power steeringpressure circit(91 models)open or shorted 49 High idle indicates vacuum leak 51 PCM memory error 53 System voltage error 55 A/D error 58 trans fluid temperature too high 59 Trans fluid temperature too low 66/67 A/C pressure sensor 81 ABS message fault 82 PCM internal communication fault

Mar 10, 2010 | 1992 Saturn SL2

2 Answers

What trouble codes are 32, 66, 67, 81, 82, or 83


32-EGR , 66-CONTROL SOLENOID CIRCUIT FAULT, 67-TORQUE CONVERTER CLUTCH CIRCUIT, 81-82-83-SOLENOID CIRCUIT FAULT HOPE THAT HELP U.

Mar 03, 2010 | 1995 Chevrolet Suburban

1 Answer

I have no break lights on my 66 tbird. There is


Those cars had the sesquential (sp?) brake lights/turn lights during those years. There is a box in the truck somewhere that needs to be by passed or replaced. I can remember such a problem on my mother's car way back in the day(years ago) It was under warranty so I don't know what they did.

Jul 02, 2009 | Ford Thunderbird Cars & Trucks

2 Answers

1996 subaru legacy engine light code 66


It's in 'safe mode'. Fault 66 is a nightmare! Usually caused by the sensors not talking to each other properly or 'disagreeing' with each other. Check all the sensors are pluged in & have good connections. A dirty connection can cause this code to appear. Disconnect the battery & touch the + & - leads together to discharge the system & reset the computer & fault codes

Apr 10, 2009 | 1996 Subaru Legacy

2 Answers

What is a code 66


I checked on my Mitchell's program and I don't show a code 66. Try to get the codes again. Turn the key on/off 3 times what watch the flashes. I can get you the information to you soon.

Jun 22, 2008 | 1997 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...