Question about 1998 Mercury Grand Marquis

1 Answer

Have 98 Grand Marquis Clear marker light does not work on either side the amber does whats the problem? I have replaced both bulbs

I have replaced both bulbs

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 3,495 Answers

Are you talking about front--back, both? Did you check voltage and ground at the bulb socket?

Posted on Nov 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Mercury Grand Marquis Side Marker, Driver Side

Hi, I checked my manual at the shop today and of course it had no information on the side marker light. But it did show that when you remove the front headlight assembly, you gain access to that side. I had a car in the shop for a different problem and I think you can get to it from the bottom after removing the plastic cover under the car below the bumper.

Posted on Aug 28, 2008

fyrebyrd1
  • 121 Answers

SOURCE: no brake lights

Sounds like it has a bad brake lamp switch. It's possible that if you have a third brake lamp and that works, but the others don't, it is a bad multifunction switch. The brake switch is located on the brake pedal. The multifunction switch incorporates your turn signal/ hazard/ high beam lever mounted on the steering column. As confusing as this sounds, I hope this helps.

Posted on Dec 07, 2008

rtpflh
  • 546 Answers

SOURCE: Side Marker Bulbs

you need to remove entire assembly to access bulbs.it is secured by small hex head screws & a ''sliding tab'',an L shaped piece you pry up w/a flat screwdriver.

Posted on Sep 20, 2009

  • 4 Answers

SOURCE: 2004 merc grand marquis. how to adjust headlights, replace turn s

ther is a plastic guard with 3 locking caps that need to be turned clockwise a quarter turn to remove. remove from the front. you will then have be able to see and have access to the lights and adjustment screws

Posted on Jun 13, 2010

shinehutt
  • 254 Answers

SOURCE: how do you replace headlight

you have to remove the whole lens usually two bolts onrad upper rad support remove grill and rmove lens unitturn on headlight mark which bulb to take out looking at other side light

Posted on Jan 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why would only one out of 4 marker lights work?


you are right all marker lights come off of one fuse, inside instrument panel, number 29, a 10 amp fuse my manual does not give a lamp number, it has a chart, head lamps (high) lamp 9005 60 w type a, headlamp (low) 9006 51 w type b, front marker lamps 5w type d, for the rear it says to use a lamp 7443 21.5 w type d, I do not use these, I have special lights on mine, hope that it helps

Mar 28, 2015 | 2007 Scion tC

Tip

How To Install Replace Side Marker Lights Mercury Grand Marquis 98-02 1AAuto.com



How To Install Replace Side Marker Lights Mercury Grand Marquis 98-02 1AAuto.com

on May 18, 2012 | 2002 Mercury Grand Marquis

Tip

How To Install Replace Headlight and Bulb Mercury Grand Marquis 98-02 1AAuto.com


How To Install Replace Headlight and Bulb Mercury Grand Marquis 98-02 1AAuto.com

on May 18, 2012 | 1998 Mercury Grand Marquis

1 Answer

How do i replace headlight 2004 grand marquis?


The Crown Vic and this Marquis are the same procedure, so please watch the video at this link

Aug 08, 2012 | 2003 Mercury Grand Marquis

1 Answer

Front signals work but back ones wont blink and im not sure which bulb is sapost to blink. i checked my fuses, it was good.one of my side marker bulbs is out, could that be it? Its a 1997


It only takes one bulb to blow, that side wont blink, it will stay on, blinker lights have amber lens or amber globes if you have clear lens.

Feb 26, 2011 | Cadillac Seville Cars & Trucks

1 Answer

How do I change the front side marker light bulbs?


Bi-Xenons - 6000K D1S
High Beams - Osram Nightbreakers H7
Fogs - PIAA H11 Yellow Ion
Cornering Lights - Osram Nightbreakers H3
Front Park Lights - High-Powered LEDs with built-in resistors
Front Signal Lights - Sylvania Silverstar 7507A ST (Silver Bluish but lights up Amber)
Front Sidemarkers - InviSilver W5W (Silver but lights up Amber)
Rear Signal Lights - P21W Stealth Bulbs (Silver but lights up Amber)
Reverse Lights - Sylvania Silverstar 7506ST or Error-Free LEDs
License Plate Lights - C5W Error-Free High-Powered LEDs
  • Turn the engine off and approach the side of the porsch with the burn-out side-marker light. If you are replacing both, start at either side; the replacement procedure is the same.
  • 2 Remove the screws from the plastic fender liner. Peel back the liner to access the area behind the fender.
  • 3 Reach your hand inside to gain access to the side-marker light's backing. Push the backing forward to release the side-marker lens; it's held in place by small clips.
  • 4 Grab the lens on the outer side and turn it over to access the back. Gently turn the bulb to release it from the plastic lens.
  • 5 Pull the bulb straight out to remove it from the electrical socket. Insert a new bulb, but do not touch the glass part of the bulb with your hand.
  • 6 Push the new bulb into the side-marker lens. Turn it clockwise to install it. Push the side-marker lens back into place. Apply gentle pressure to the lens to pop it back into its mount.
  • 7 Replace the screws along the edge of the fender liner.


  • Dec 04, 2010 | 2006 Porsche Cayenne

    1 Answer

    Had a problem with a right, amber side marker on right side


    Usually one of the holes in the marker light where screw goes in, has metal contact where screw meets light, but if not, and they are not push in wire connection type from behind, then just run your white wire up through hole in housing, and bare the end & tighten it up under screw holding light to body. White should be ground, brown should be power.

    Jul 02, 2009 | 2004 Dodge Ram 2500

    3 Answers

    Replace parking/marker bulb front pass 98 Jeep Grand Cherokee


    look in between the marker and headlights its a screw there screw it out

    Apr 04, 2009 | 1998 Jeep Grand Cherokee

    1 Answer

    I ned to change left side marker light up front bulb 194na how do i get assembly out on 1996 mercury grand marquis


    I changed the front left marker light on side of headlight assembly by unscrewing the screw on the far back of it. then i just pulled it off. it felt like it was gonna break but it came off just fine

    Mar 22, 2009 | 1996 Mercury Grand Marquis

    1 Answer

    Side marker lights not working voltage only at left front socket


    the front white side marker lights come on with the turn signals to light your way around corners they dont blink they just illuminate the right or left corners the ones at the rear left and right come on with the back up lights,, i have a 86 vette too look for ground wire problems as they are more common on these cars, you may have voltage at the light socket but if its not grounded good no light s

    Jul 20, 2008 | 1986 Chevrolet Corvette

    Not finding what you are looking for?
    1998 Mercury Grand Marquis Logo

    58 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Mercury Experts

    yadayada
    yadayada

    Level 3 Expert

    76164 Answers

    fordexpert

    Level 3 Expert

    5522 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Are you a Mercury Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...