Question about Cars & Trucks

1 Answer

My 2003 hynadi sonta was fine this morning took it and got gas got on the highway about 30 mins into the drive it started shaking it idle pretty bad then check engine ligt went on, turned off and back kn still shaking not as bad when driving it. My Mom took it around block said shaking stopped and light still on any ideas?

Posted by on

Ad

1 Answer

We have has dash check lights for 35 years, on
all vehicles, but the questions still keep coming

Stop using it & have a repair shop check for OBD
Codes,Diagnose them & find the problem

Posted on Nov 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

SOURCE: runing rough for 1 min. after start cold engine

95 vw golf 2.0l. engine blue smoke

Posted on Nov 01, 2008

  • 141 Answers

SOURCE: Engine runs rough after about ten minutes /idles really low

Just trowing some suggestions out there, but, I would check the idle air control valve (solenoid) or the throttle position sensor. If they check out then my last guess would be the map sensor or the vaccuum to the map sensor. Hope I was able to help. Best wishes.

Posted on Jan 17, 2009

  • 112 Answers

SOURCE: tcs light, check engine light flashing and constant shaking..

Use an OBDII scanner, some auto parts stores will do this for you free of charge.
Codes P0300 through P0306 indicate mis-fire and you may also get codes reflecting Cat damage from running that way.
I know of one TL from this series (2000 3.2 TL) which had a warranty REPLACEMENT OF TRANSMISSION!!! free of charge and this very problem was solved. I still do not know why they were related. Talk to Acura customer relations about this.

Posted on Jul 09, 2009

  • 632 Answers

SOURCE: '00 VW jetta, ck engine lt on & now exhaust is loud

This sounds more like you have an exhaust leak and it doesn't mean the check engine light has is related to your louder exhaust note. I don't understand how checking the 02 sensor be related to it either unless he meant if it came loose or lost it all together which is rare but not impossible. What I can suggest is have someone with a VAG 1552 scan tool or equivalent like the Ross Tech (PC app) scan your system. If there are faults, a specific DTC will be in stored in memory. Depending on the issue which determines the difficulty and financial investment involved fixing your problem.

Posted on Sep 23, 2009

  • 2 Answers

SOURCE: Audi A4 ESP light comes on and car shakes/vibrates strongly

I am dealing with this issue with my 2003 a4. The Esp Is your tractioon controll, which is tied into your Abs system. Your Brake light Circuit is also tied in, so. Check your Brake Fluid, all Rear Bulbs, then look into Abs wheel speed sensor. $100 bucks each. The yaw sensor is unlikely culprit, but the ESP Controll module which is located under glove box is most likely the suspect.<!-- from fixya rte -->

Posted on Aug 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine sputters, exhaust shakes, lagging accelleration


check the plugs again and see if they are oily again, if they are NOT oily check the ignition coil if it is giving current to all four plugs, if not ,change it.it might be shorting out when it is hot.........If the plugs are oily again, and assuming the valve cover has been changed,sorry to say you have an internal eng.piston ring problem. more tests must be done to pin point the problem.

Jan 28, 2014 | Toyota Corolla Cars & Trucks

1 Answer

No clue what is wrong... and apparently neither does my mechanic...


sounds like you got some water in your gas ,, or your mass air flow sensor is shorting out , or dirty

Jan 28, 2014 | Toyota Corolla Cars & Trucks

1 Answer

2005 chrysler town and country when i start the van it shaking vibration hard in park and in reverse it and in neutral and in drive it perfect.it drives good on highways no shaking


try to increase the idle-rpm..
Example - at standstil condition when you start your van, have look at rpm... say 1000 or 1200 or 1500.. whatever it may be..
Keep idle-rpm a little bit higher, if previously it was 1200rpm then set it to 1500 rpm..
If the problem is solved then..
1) clean ur airfilter
2) check spark plug condition
good or bad... if bad then replace..
3) check fuel supply line, if it is damaged or folded

Nov 22, 2013 | Cars & Trucks

2 Answers

My Toyota tercell, 1997 has started to shake pretty bad while idling, it stops some when the AC kicks in but shortly after starts to shake again. Runs fine while driving.


Sounds like you may have a bad motor mount. While driving and under a torque situation you wont notice it as much,but at idle you will as it has extra room to move.

Apr 22, 2012 | 1997 Toyota Tercel

1 Answer

My 91 Pontiac 6000 LE, V-6, 3.1 engine, will start good, go great on the highway but then when I slow down, it stalls out. Starts up but acts like it is choking out and dies again. When it does go, it...


You have a bad idle air / idle sensor. Your car believes that you are in idle at all times so when you come to a stop the engine floods. When the fuel evaporates you can drive again. Drove me crazy when it happened to me.

Sep 12, 2011 | 1991 Pontiac 6000

1 Answer

Every morning my car starts up fine and drives normal. No weird sounds or nothing. But after like 10 miles of driving, when I idle at a stop sign the RPM starts to drop up and down pretty low. After that...


I have the same problem few days ago and found my solution on Fixya Expert Sources website. Here you will get all the top sources of your problem. All the sources of this site provided by top Fixya Gurus. Have a good look at the sources of the page. Go through the sources to find your solution. Hope it will help.


View Count:9

Aug 11, 2011 | 1990 Toyota Celica

1 Answer

My "GMC Envoy 2003 XL SLT 4.2 liter 6 cylinder",check engine light came on.every morning i start the car to warm-up and it's o.k. but then when i put it on drive"It starts to shake when i step on the brake...


First thing to do is to clean the throttle body and throttle plate thoroughly. While performing the cleaning, disconnect the battery for about 30 minutes. This will force the PCM to relearn with a clean throttle body. See if this helps with running and the codes. Also make sure the gas cap is tightened properly.

Sep 29, 2010 | 2003 GMC Envoy Xl

1 Answer

1991 pontiac trans am will start and idle but after 25-2800 rpm'


how about highway driving will it cruse at highway speeds and if you were to step down on it does it bog down ? and does it still have the cats on it ? just a thought..

Apr 28, 2009 | 1991 Pontiac Firebird

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...