Question about 2011 Dodge Avenger

1 Answer

How 2 turn off seat belt light 2011 dodge avenger?

Posted by on

1 Answer

Pull on the front seat belts a few times

If the rear ones are use- try them also

Nothing--- you will need a scan tool to check the
SRS Module for codes

Posted on Nov 21, 2014

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

localwonder
  • 6784 Answers

SOURCE: diagram for a serpentine belt replacement for 2000 avenger dodge

HI. i have posted the diagram requested below.

7109f62.jpg

Posted on Aug 24, 2009

Testimonial: "This was exactly what we needed, Thank you so very much. "

c17hydro
  • 2984 Answers

SOURCE: 1998 Dodge Avenger serpentine belt issue

What size of motor, do you have a/c and which belt are you replacing? Not sure about your engine size since you did not list it so please pick the applicable motor:

Sebring Coupe And Avenger (2.5L VIN N Engine)

  1. Disconnect the negative battery cable.
  2. Loosen the tension pulley locknut.
  3. Rotate the adjusting bolt to decrease the belt tension.
  4. Remove the drive belt from the engine.
To install:
  1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
  2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
  3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
  4. After the belt is installed and adjusted properly, tighten the locknut to 17 ft. lbs. (23 Nm).
  5. Connect the negative battery cable.

2.0 DOHC

Power Steering Pump And A/C Belt
  1. Disconnect the negative battery cable.
  2. Loosen the tension pulley locknut.
  3. Rotate the adjusting bolt to decrease the belt tension.
  4. Remove the drive belt from the engine.
To install:
  1. Position the replacement belt around the pulleys, making sure the belt routing is correct.
  2. Adjust the belt by rotating the adjusting bolt until the correct tension is reached. Refer to the procedure earlier in this section for belt adjustment.
  3. Once the desired tension is reached, secure the locknut. Recheck the belt tension.
  4. After the belt is installed and adjusted properly, tighten the locknut.
  5. Connect the negative battery cable.

Posted on Oct 29, 2009

  • 63 Answers

SOURCE: 2008 Dodge Avenger check engine light

Not sure if this will work for you but worth a shot. I own a 2005 dodge neon. I know the ecu's are different but maybe dodge was smart and made all the cars this way. Insert you key into ignition. Turn key forward until you are at the last position right before the car starts to crank over. Repeat this for a total of three times then on your digital odometer display, you will see a set of numbers displayed. this will be your code for the malfanction(s) that set your check engine light. Like I said, it might not work on your car but give it a shot. If not, rent an obdII scanner and get your codes. Then you know where to start looking to fix your problem.

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2011 Dodge Avenger will not read any diagnostic machines.


certain scanners will not work on dodge or ford cars
they require a different protocol to run the scanners
take it somewhere else with a scanner that can read dodge products and get the code readings

Jun 26, 2017 | Dodge Cars & Trucks

1 Answer

2011 Avenger. Why do the instrument lights flicker while it is running?


Do headlamps flicker as well? Bad alternator. No? Bad light switch.

Jun 09, 2015 | 2011 Dodge Avenger

1 Answer

How do i clear the check engine light on a 2011 dodge avenger


You can go to Autozone and ask them to put on the code reader and find out what the problem is and diagnose from there. Once defined , you can then repair the problem (hopefully) and the light will go out.

Sometimes it can just be as simple as the gas cap needs to be taken off and then put back on and make sure to get 5 - 10 clicks on it. See if that helps.

Feb 16, 2015 | 2011 Dodge Avenger

2 Answers

Replace blown tail light 2011 avenger


The tail lights on this should be led lights and I don't believe you can just replace it. I believe you have to replace the whole unit. If its still under warranty take it to the dealer and have them replace it.

Oct 31, 2013 | 2011 Dodge Avenger

1 Answer

2011 dodge avenger wet fuse box


Try letting it just dry out and it should be good. If you pulled a fuse put it back in. It could be supplying power to those things that are now showing up.

May 22, 2013 | 2011 Dodge Avenger

1 Answer

2008 Dodge Avenger Airbag light stays on


i got a 2011 dodge avenger the airbag warning light stay on , can u someone give me an idea how to fix it please?

Dec 13, 2011 | 2008 Dodge Avenger

2 Answers

Belt route 2011 dodge avenger


I find this diagram that I hope that help you...


10_3_2011_12_27_53_am.jpg

Oct 02, 2011 | 2011 Dodge Avenger

2 Answers

2.4 Dodge avenger belt Diagram


I find this diagram AVENGER Engine L4 2.4L 2360cc 144ci GAS FI N K that I hope that help you...


10_3_2011_1_14_07_pm.jpg

Oct 02, 2011 | 2011 Dodge Avenger

Not finding what you are looking for?
2011 Dodge Avenger Logo

116 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...