Question about Cars & Trucks

1 Answer

I got answers to my problem of my 2002 dodge Durango. But it also vibrates sometimes when I drive it. Sometimes it feels like the wheel wants to come off. I have the wheel bearing fixed already.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,568 Answers

You need to raise each side of the front so the wheel is clear of the ground, then 'wiggle' the wheel to see if play is present.
If so, you may have worn tie rod ends needing replacement.

Posted on Nov 20, 2014

Testimonial: "If so, how much will that be to replace?"

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: 2001 Dodge Durango Power Lock Problem

Is this your problem?
http://dodgeram.info/tsb/2003/08-023-03.htm

Posted on Oct 15, 2008

66 chrgr
  • 1011 Answers

SOURCE: Crank sensor location 1999 dodge durango

the crank sensor is located passenger side back of the engine were the trans and engine come together .there are 2 - 13mm.bolts that bolt to top of the engine.

Posted on Feb 22, 2009

  • 79 Answers

SOURCE: Vibration and noise from front end while driving

Jack up the front end and put stands under it and block rear wheels. Look at axle boots and see if they are cracked. Try turning wheel back and forth sharply and see if you can hear any clicking. Problem could be outer axle joints. If the boots are cracked or you hear a clicking noise you will have to replace the axle. The axle and boot come as a complete unit. Please let me know what you find out.

Posted on Apr 15, 2009

Danniboi
  • 1098 Answers

SOURCE: When driving my 2002 Dodge Durango 5.9 it makes a

Could be the wheel bearing or anti roll bar bush.

Posted on Jan 13, 2010

  • 2 Answers

SOURCE: How to replace front wheel bearing on a 2002 Dodge 1500

You take off the right tire. You have take all the bolts out from underneath the

Posted on Feb 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 Dodge Durango will not go back into all wheel drive from four wheel drive can I bypass the switch or what to do to get it out of 4 wheel drive


all wheel drive is four wheel drive , i think you mean back to 2 wheel drive , no way to bypass the four drive switch , have to take to a transmission specialist

Mar 27, 2015 | 2002 Dodge Durango

1 Answer

2002 Dodge Durango SXT 4.7L RWD shaking (serious vibration) badly between 70 to 80 mph


If it were me I would take out the drive shaft and check the play in the universal joints (I know you said they were replaced). Unlike ball joints they should exhibit good freedom of movement and flop from one position to the next as the shaft is rotated in the hand. Check that the bearing cup retaining clips are present on all sides. If there is any tightness in a bearing it is possible that either one of the cups has been pressed (hammered?) in too far or that a needle bearing was dropped from the outer race into the cup during assembly. Also check that the cup holders (arms) are not bent, sometimes if care is not taken to support the back of the 'arms' when installing the bearing cups the 'arms' will bend.

Feb 28, 2017 | 2002 Dodge Durango

1 Answer

Blower heater, locks , interior lights go off & on & hear arcing @ glove box (2000 dodge durango)


Could be a Relay coming in and out. Get whatever that allows you to replace it out of the way then listen. Sometimes you can just feel around the area and fill the vibration. They aren't expensive.

Feb 11, 2013 | 2000 Dodge Durango

1 Answer

My 2000 dodge Durango is making a loud humming noise. When you go over 20mph. It feels like it is under my feet when I am driving and my steering wheel is vibrating. Any ideas what it nay be.


Check the front tyres for hi / low spots, flat spots, bulges. Try rotateing your wheels front to rear & see if the steering vibration disapears & noise move to rear.

Jun 29, 2012 | Cars & Trucks

1 Answer

Bought a 1999 durango lady said it needs a tranfer case replaced was driving down road and transfer case broke and blew apart took to mechanic replaced transfer case but started vibrating after driving...


This type of vibration is typically caused by a bad universal joint on the drive line. I've seen a case where a bad u-joint caused the transfer case to crack and explode. Replace all the u-joints on the front and rear drive lines. They are usually only around 15 bucks each at NAPA and will be much cheaper than another T-case.

Jun 19, 2011 | 1999 Dodge Durango

1 Answer

2003 Dodge Durango vibrates at 60 mph


Check the transfer case and u-joints for wear.

Mar 07, 2009 | 2003 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...