Question about 2009 Toyota Camry

2 Answers

Key broke off in ignition then something electronically went out. coincident or reason??

Replacing master fuse, but didn't 2nd opinion mechanic sd was ok. checked fuel pump but seems to b ok.

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 22,156 Answers

Its the transponder not picking up a signal so it will never start

Posted on Nov 21, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 14,585 Answers

Maybe the part that broke off has a chip in it and it has to be by the column to start.

Posted on Nov 21, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

mrgreenz
  • 962 Answers

SOURCE: My toyota camry (1997, LE, 4) tail light fuse keeps broken again.

go to http://www.autozone.com/...eId=0900c1528009104f . you may find a wiring diagram there for free.Please vote.

Posted on Nov 18, 2008

SOURCE: toyota hilux no fuel to injectors

im not sure on that particular vehicle but most trucks have a fuel pump shut off if the vehicle gets hit or is jarred real hard look in your book for the fuel pump reset button it is a inertia switch

Posted on Dec 11, 2008

  • 2 Answers

SOURCE: 4 cyl Engine starts and idles ok...give it throttle and it dies

I need to get a clear mental picture of what exactly is happening.

With this said, you stated that the car "runs fine" until warmed up.

Q: When you start the car when cold it idles fine?
Q: If you allow the car to idle until "fully" warmed does the car stall?
Q: As the car begins to warm up, Does the RPM fluctuate abnormally?
Q: Does the car Only stall when you press on the gas pedal or does it stall just sitting and idling in addition to pressing the gas pedal?
Q: If you can drive it while cold does the car stall during acceleration when warm or only at Stop Signs / Lights?
Q: If you wait 20min or so, can you start the car again?
Q: How many miles are on the car?

Posted on Mar 31, 2009

roniecon
  • 6826 Answers

SOURCE: 1999 toyota camry wont start

You most likely have no injector pulse,this is caused by a bad cam sensor,or pick up coil,or crankshaft sensor.

Posted on May 13, 2010

johnjnail
  • 1702 Answers

SOURCE: 01 Celica won't start, no

sounds like there is no power to the EFI relay, there is an EFI fuse in the under hood fuse/relay box, if fuse is ok take a power probe ( by the way there are 3 EFI fuses a 15 amp and 2, 7.5 amp ) remove the EFI relay and power up terminal #3 and see if the fuel pump powers up with the key on, this is the power circuit for the coil. injectors, and fuel pump.

check this out and let me know what you find.

Posted on Mar 24, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car wont start not a fuse not fuellodge is it more than irony that something electronically happened and car wouldn't start after key broke off in ignition??


Is the broken part of key still in ignition? if so it will need the top half of key close to it to run. the top half of key has a chip in it and without it the car wont start if this wae helpful please leave good feed back

Nov 20, 2014 | 2009 Toyota Camry

1 Answer

99 Olds Cutlass, new ignition problems


Obviously the mechanic is not getting down to the real
issue for some reason
Try a different shop
I can only guess but it sounds like you may need
a new ignition switch & then the proper adjustment
if one is required
You may be able to dajust yours to work ok if that
applies.
Seems odd the mechanic spends all that time in one area
& doesn't have a solution
You may have a bad door switch as well

Jul 26, 2013 | Oldsmobile Cars & Trucks

1 Answer

Starter Fuse Keeps Blowing When I Try To Start My 2001 Camry


The starter has gone to ground. This is either a coincidence of age or the repair shop left something disconnected that has slapped around and grounded the starter or some of their other work has shifted around and done it. It could just be a coincidence. If it went to ground internally, it will need replacing. If something shifted and grounded it out, putting that something where it belongs and THEN replacing a fuse should fix it. Most shops reuse your starter on their new engine.

Apr 16, 2017 | Toyota Camry Cars & Trucks

1 Answer

I had the valve cover gasket replaced, a major tune-up and an injector replaced. There was no sign of leakage from the heater core. Less than 24 hrs after the aforementioned work being completed the hose...


It may just be a coincidence. I would ask the mechanic to show you where the hose to the heater core is, and then have him show you where the other repairs took place. If the heater core pipe is very close to where he was working then it may be something he accidentally leaned on or disturbed while working. If it isn't right there in the area he was working, it may just be a case of bad luck. Accidents happen, and so do coincidences. You will have to decide for yourself after looking at the facts and making a reasonable judgement.

Dec 23, 2011 | Cars & Trucks

1 Answer

I have a 99 tahoe 5.7 4x4 has code p0758 shift solenoid B or 2-3. shift...i replaced it and problem still exist put it in drive and its in third gear??? whats my next step to many opinions out there to do...


I am going to have to say that sounds like a classic ignition switch problem. You see all of the power for the engine and transmission goes through the ignition switch first. If the switch is bad then electronic components will start to fail without explanation. Your solenoids are electronic and for some reason seems to be the first things that start to malfunction when an ignition switch is going out. If you change the ignition switch it should solve your problem. I hope this helps you out.

Aug 29, 2011 | 1999 Chevrolet Tahoe

1 Answer

After I had a new steering box put in my 1996 Yukon, the Air Bag light is always illuminated. Is this a coincidence? is there a way to diagnose the problem without gettting reamed by the dealer?


Not a coincidence in my opinion. One of two things likely occured. One, the blew the fuse for the SRS ( supplimental restraint system ) , or 2 the most likely of the scenarios, they didn't plug it back in. I'm not saying thats the only things that could be wrong, but they'd be the most common.

Jun 16, 2011 | 1996 GMC Yukon

1 Answer

I have a 1998 Ford Windstar. Got in to drive, turned the key to start and 'snap' something seems to have broke within the ignition lock cylinder... all of the accessories are on... the key...


This happened to to me with my ranger. I went and bought in ignition and a junk yard and no problems after that. That way your not out of a lot of money.

Jun 02, 2011 | 1998 Ford Windstar

4 Answers

Key will not go into ignition, drivers door lock stopped working


I had the problem with key not going into the ignition on 2005.5 Jetta had to have the car towed and ignition replaced which cost 375$. But what i read afterwards is there is a locking mechanism in the ignition it is a white thing that slides so you cant get your key in this can be moved with a a small aharp object ant you can then get your key in!!!

Mar 14, 2009 | 2006 Volkswagen Jetta

1 Answer

Won't start after some do-it-yourself work


Sounds like you broke the ignition switch.

Mar 11, 2009 | 2001 Kia Rio

1 Answer

Can an Alternator Belt installation cause a timing belt problem?


I cannot see any reason for the belt to cause timing belt to jump. unless they messed up something installing belt.might wanna get a second opinion

Oct 22, 2008 | 2001 Hyundai Sonata

Not finding what you are looking for?
2009 Toyota Camry Logo

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...