Question about Nissan Pickup

1 Answer

My car is over heating Nissan hardbody zd30 engine?

Change thermo start change water tap and clean the radiator

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 59 Answers

Thermo fan not cutting in /clutch fan faulty.
headgasket blowen...check for bubbles in the radiator if lots of bubbles then its a headgasket /cylinderhead problem

Posted on Nov 20, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: Hi, I have a 2001 nissan

hi. was just looking at your problem of (sentra) overheating and actually, i am a mechanic for nissan and have changed many head gaskets for this particular vehicle equipped with 1.8 liter motor and found that they are notorious for this problem of faulty head gasket's.Unless you did't properly bleed the system,which i doubt because you seem mechanically inclined since you already changed every other part of the system,i would't doubt that this is the problem.Anyway, by the time you read this, you have probably already found this out..Just thought i would let you know this info.Good luck!...by the way,if you haven't already changed you cam and crank sensors,do that too,before you get stuck and get the part's at the dealer!!!!-they are redesigned from the old one's!!just some advise to try to help you out!!! John from N.Y.

Posted on Aug 15, 2008

  • 1 Answer

SOURCE: RADIATOR FAN

If you've got the hydraulic fan, check to see that the solenoid at the power steering pump is plugged in. My 1993 3.0 had this happpen, and that's what was wrong. You have to pull the front passenger side wheel off to access the pump. Just stick your hand up in there and feel around. You'll find it. One way to check is to let the car idle and turn the a/c on full blast. You should hear the fan start to roar after a few seconds. If it doesn't, then check the solenoid wire. Worked for me!

Posted on Sep 14, 2008

  • 20 Answers

SOURCE: DASHBOARD RADIATOR INDICATOR LIGHT COMES ON WHEN ENGINE IS COLD

you might need to get the water level sensor checked, it may be faulty

Posted on Nov 28, 2008

  • 166 Answers

SOURCE: I have a 1996 nissan

sounds like you have a thermostat problem also did you bleed the cooling system of all the air before you put the radiator cap on?
if you have not bleed the system and there is a air lock you will have over heating problems.
the way you can try bleeding the car is let it get up to temp with the rad cap off and let the fans cycle twice and wate till all the air bubbles stop stop coming out.
if the air dosn't stop coming out for a long long time you may have a blown head gasket

Posted on Jan 02, 2009

  • 52 Answers

SOURCE: water boiling problem?

Check your radiator, any coolant left?

Posted on Feb 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan hardbody 2005 ZD30 idle meter has stopped working any help


idle meter has stopped working Makuwa, check to see if there is a fuse for tachometer and replace if faulty.

Apr 02, 2016 | Nissan Cars & Trucks

1 Answer

Nissan navara 2002 twin cab diesel zd30 malfunction light comes on randomly


NISSAN NAVARA questions and answers

www.roadtestreports.co.uk/vans/nissan/navara/qanda/
Results 1 - 40 of 322 - Ask and answer questions on a variety of NISSAN NAVARAmodels. Help and advice ... Have a Navarra Rally Raid 2004 double cab pick up. ... Navara V6 2011 - loss of power & engine management light on. .... ZD30 I have changed the diesel filters after noticing that it's jerking when I'm on full throttle.

Nissan Patrol GR Y61 ZD30 starting problem - YouTube

? 1:23
https://www.youtube.com/watch?v=JxHKfYDCgFQ
Jan 16, 2013 - Uploaded by sspyropoul
After replacing the diesel filter seals and water trap i had no problem .But you ... They still glow for like 15 ...Missing: twin ‎cab ‎randomly

Nissan D22 Navara receives YD25 2.5-litre diesel

www.themotorreport.com.au/.../nissan-re-power-their-d22-navara-range
Jan 31, 2008 - Nissan's popular Navara D22 workhorse range has been ... On top of the 4x4 DX single cab's equipment, the dual cab ST-R adds .... the yd25 engine have a overheating problem, so how comes nissan is ... I believe it is a ZD30 engine. .... with no problems except a cracked injector line (pretty random fault).

Jan 13, 2016 | Nissan Cars & Trucks

2 Answers

ZD30 ENGINE. Why is there a no start/hard start problem?


seams it is still make good enough contact if can find a proper replacement go ahead an replace before it leaves you stuck on side of the road

Jul 22, 2015 | 2004 Nissan Frontier

1 Answer

Nissan Sunny 2004 model, manual transmission, 1.6 litre engine: problem: Radiator got leakage from the top side (at the junction of plastic and metal). The leakage is very fast that in 5km the water...


I have used JB Weld on plastic tanks, it is a 2 part epoxy that dries hard and is easy to apply, and works well on radiators. You have to clean and dry the surface, and rough it up a little with emory cloth or sandpaper, but I did it on my neighbors car and it lasted for over a year and a half, I just put in a new radiator for her but the fixed one still did not leak, she just wanted to replace it because she could afford to do it. JB Weld is amazing stuff, and you can get a fast dry formula and after it is done you can drive it within a few hours, no problem.

Jan 25, 2011 | Nissan Maxima Cars & Trucks

1 Answer

I have a 2000 nissan xterra my heat dont warm up i change my thermo stat if i get my heater core flush what are my chances of it working what are the major problem with the 2000 nissan xterra i done...


forget all the above items you mentiond,the heater metrick/core should be ok if you put a cooler flush through the system,im looking at the thermo switch mounted on the top of the water system it will have two wires on it and tells the engine when to let hot water through the core,also if its not working the engine will not perform great so try this and forget about new spark plugs/wires/coil pack ,as these are nothing to do with heating.adrian,,,

Dec 31, 2010 | 2000 Nissan Xterra

2 Answers

Replace thermostat. Engine temperature gauge hardly moves and heat into passenger compartment luke warm. Unable to locate thermostat in engine compartment.


The thermostat is where your lower radiator hose meets the engine block. There are three bolts to remove to get to it, if your engine is a V6

Nov 29, 2010 | 1991 Nissan Pickup

2 Answers

Aloha,have 98 base mustang, overheating after many replacements


i would change the water pump and check for plugs in the heater core

Sep 26, 2009 | 1998 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...