Question about Cars & Trucks

1 Answer

ALT. NEW CHANGE AND BATTERY AND IS NOT CHARGING

NEW ALT. CHECK AND NEW BATTERY

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Cars & Trucks Expert
  • 161 Answers

Make sure your alternator was polarized correctly. You may also need to replace the coil pack.

Posted on Nov 26, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alternator not charging


is it charging at 14.9 ? 14. any thing is at 1000rpms ( no lights or radio etc working) 13.23 to 13.86 volt is good enough to charge battery. what is the charge rate.

Jan 30, 2014 | Acura CL Cars & Trucks

1 Answer

Charging system voltage low


there are only 3 parts. but the causes are 25 or more.
1: belt missing slipping,
2: engine rpm below 800 RPM (lots of ways ,ask )
3: ALT had.
4: wiring to ALT bad.
5: bad battery or its connections, (wires)
6: bad fuse. see fuse link a11? on fFM page 20?
7: car is PCM alt controlled, it can be bad too. see 2 field wires on ALT and PCM on page 20? below?
8: battery temp sensor bad. making PCM think battery overheats.
the fSM covers all tests above.

pick car here, then pick charging.
5 alternators used on the 5 diffr.engines. got the wrong one?

the see wiring diagrams at end and chapter 20 inside, charge.
pdf page 118 for gas engine, if diesel next few.

Jan 07, 2014 | 1998 Jeep Cherokee

1 Answer

Montero sp not charging


sometimes "new" alternators and batterys are bad from the factory, or sent out with a defect. Check your battery connections from battery to alt/starter, check connection of battery ground. Check ground from engine to frame or body.

Dec 17, 2013 | 2001 Mitsubishi Montero Sport 4WD

1 Answer

New battery not charging after changing the alternator


First make sure both battery cables are free of corrosion and ground is secured to chassis and engine then check to see if theres an alt. fuse or bat. fuse blown. Another way to test charging sys w\out an meter is to remove the ground terminal from the bat. with the car running, if the alt. is good car stays running, if all else fails take the alt and bat to a parts store that will test them for free

Dec 14, 2013 | Chevrolet Venture Cars & Trucks

2 Answers

Alternator


No it is not charging. It should be at leaset 13.4-14.2 volts

Jun 12, 2013 | 1995 Oldsmobile Cutlass Ciera

3 Answers

No charging condition - tested new alt, tested new batt


OK....Since you've tested ALT & BATTERY?..Then you should inspect that missing fuse for horn and see if maybe it's been put in as a replacement in a port for anything to do with charging system,ie: alt,battery or other?....Then check ANY fuse links on the wiring/battery cables and other like to altenator etc....If you dont know what a fuse link is,most times it's on the hot wire that goes to starters,close to it,and to explain what it is--it's a short length of wire that is smaller,like a filament,like a bus fuse,cept these are coated and you cant se theyre blown,you have to do a continuity test to see if filament type wire isnt broken.....Another thing you may want to try is ADD an additional body ground wire from battery negative post to body of vehicle.I had a 71 Monte Cralo way back and I went through a similar thing and NO electronics thank god! But I added a fresh,thick wire from battery to body heavy bolt type screw and problem was solved....Hope I ahave helped,please post if it did...Thanks JD

May 02, 2017 | Cars & Trucks

1 Answer

99 elantra alt not charging battery' installed new alt and battery and fuse good and still no charge on battery


check 10 amp ECM fuse. Your alternator voltage is regulated by the ECM. If the fuse is good, consider replacing the ECM.

b4f4aeb.gif

Oct 05, 2010 | Hyundai Motor 1999 Elantra

1 Answer

Not charging


First tell me why you don't think it's charging.
Because of the voltage reading you are getting at the battery terminals? The range you want is between 13.6v to 14.2v. The higher the voltage the lower the amps. and true the other way, the lower the voltage the higher the amps. If you get a reading of 13.6v or lower, the alt is nearing or at max output. An alt can only run at maximum for around fifteen minutes and it will start slinging solder from overheating. It's a good indication the battery is either totally dead or junk. Charging above 14.2 the alternater is running wide open and is only putting out high volts which will cause the battery to boil , in turn destroying it. This is a bad alternater. All alternaters have integrated voltage regulater with the exception of ver few of the earlier ones. You cannot test an alternater by removing a battery cable to see if the engine keeps running without taking great risk of damaging the alt, regulator. So tell me why you feel it isn't charging. Remember an alt is not made to charge dead batteries. Their sole function is to maintain the battery charge. Without a battery, the alt won't last 10 seconds.
Hope to hear from you and good luck.

Sep 23, 2009 | 1986 Chrysler LeBaron

1 Answer

My 2001 dodge ram 1500 5.2 v-8 check gauges light comes on and the battery gauge is not charging half way and as soon as I drive it , the gauge goes to none charging but I can drive it and it doesn't give...


on the alternator did you put the little washers where the regulator bolts on back of the alt they must be tight and also the ground cable from the battery to the alt bracket must be tight and grounded sounds like a loose connection
the washers go between the alternator and wires coming out of the harness and the alt also it probalbly goes dead occasionally when you crank it up

Feb 02, 2009 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...