Question about 2001 Lincoln Navigator
Defrost fan comes on and when you start the car it goes off. Do I pull the fuse and if so which fuse to pull
Unless it stays on for a very long time (like over an hour), this is probably normal. What's happenning is the coolant sensor is still sensing hot coolant in the engine. (Assuming you're turning the engine off after it's been running a while.
Posted on Nov 19, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Here is how to tell if system is working.Get into the vehicle and close door. Set ignition switch to on position and move the gear shifter to neutral. After a few secs. you should hear the compressor turn on. If it comes on then put shifter back to park leave ignition on and exit vehicle. Compressor will stop when you open the door but should start back up in a couple of secs. after you close the door. You can then walk around the vehicle and listen for leaks.
If compressor does not come on there are 3 fuses and a solid state relay that controls it along with the module.
The 3 fuses are no. 109(50amp) in the battery junction box under hood.This is the direct feed to compressor thru the solid state relay. The other 2 fuses are located in the interior fuse panel and they are no. 6 (5amp) and no. 12(15amp).
What we usually see though if compressor does not run is either a bad compressor or the solid state relay. They both are rather expensive so I would have an experience tech look at it then.
However If you feel confident enough and have a voltmeter or test light respond back and I will tell you which wires to check.
Posted on Mar 12, 2009
Hello Callahan5922....this sounds like a stuck blower motor resistor. I assume the blower won't function in the a/c mode either? If you have a digital multimeter you can check this. I believe it's fuse #2....if the digital indicator goes up or down when you increase or decrease the fan speed thats good. Locate the blower motor resistor....you wil find it located on the fire wall behind the right valve cover hiding behind the heater hose, it's about the size of a cigarette pack. With the engine off, and key in on position, turn the A/C on High, and rap a tap tap tap on the resistor. You might be suprised when the blower motor takes off a runnin,
I hope this is the answer you need and i was able to help solve this for you. Good luck...
Posted on May 13, 2009
Most likely the problem you are experiencing with the park assist is a fault in one of the sensors mounted in the rear bumper. I would not consider it to be a major fix, however there will be a few hours labor involved as the bumper cover needs to be removed to replace the sensors.
Posted on Jul 08, 2009
Tips for a great answer:
Aug 14, 2016 | Lincoln Cars & Trucks
Dec 03, 2014 | 2001 Lincoln Navigator
Jun 14, 2014 | 2005 Lincoln Navigator
Dec 28, 2012 | 2001 Lincoln Navigator
Feb 27, 2011 | 2001 Lincoln Navigator
Oct 28, 2009 | 1999 Lincoln Navigator
Sep 11, 2009 | 2002 Lincoln Navigator
Mar 03, 2009 | 2001 Lincoln Navigator
49 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: