Question about Cars & Trucks

1 Answer

How do I set up my direct deposit? - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

With your bank? Each bank has a different procedure. Review the online help or FAQ section on the company webpage.

Posted on Nov 19, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to change my retirement check to a different bank


Fill out a new direct deposit form (from new bank)
& give to your former employer,etc

Dec 02, 2014 | Cars & Trucks

1 Answer

When I changed my spark plugs last month I noticed oil on them and my gas is going to quick. And I changed the spark plugs and replaced the air filter.


Hi There..
it is not unusual for oily looking deposits to appear on sparkplugs on vehicles and the fuel to go if the mixture and timing are not set up properly.check your settings, by the manufacturers hand book, set the plugs to the correct diode gap and if you are able, get a compression test done on your motor. if you still find what you beleive to be excesive deposit on your plugs and blue/grey smoke comming from your exhaust, then I suugest having a look at the valve stem guide oil seals, the may of gone hard and are allowing oil into the combustion chamber..
Good Luck.

May 07, 2011 | 1999 Isuzu Rodeo

2 Answers

I have a 1997 nissan altma and the cooling fan has started running often even though car has nt run long, temperture hand shows overheating but car is not out of coolant


There might be a problem with the thermostat not allowing, or restricting the flow of coolant. Or your radiator might be full of deposits(deposits are caused over time by the insides breaking down, ie:metal) a radiator flush might be all you need. Some places offer this for fairly cheap, round $40. Some places charge alot because they can not recycle the coolant. Inquire with your local auto-parts store and see if they have any other recomendations? Advice is almost always free, and most of them can point you in the right direction of who might be the cheapest for good quality work in your area.

Basically, a radiator flush involves draining your old fluid. Putting in new fluid, running for a bit. Draining again, then filling with new fluid! That's about it.

The deposits in your radiator are blocking the holes for the coolant to flow through, thus there is less coolant flowing through the radiator to cool off before it goes to the motor to cool it off!

I hope this helps, and hope this is all your problem is! Good luck!

Mar 15, 2011 | 1997 Nissan 240SX

1 Answer

My a4 just lost power as if the turbo isnt kicking in, does anyone no what it could be


The use of contaminated gasoline or gasoline with a low content of deposit control additives may result in one or more of the following conditions:
^ Excessive accumulation of deposits on intake valves, intake manifold, fuel injectors and combustion chambers. ^ Engine runs rough after cold start. ^ Excessive engine cranking time. ^ Hesitations while driving. ^ Rough engine idle. ^ Reduced engine performance. ^ Poor fuel economy. Conditions may be severe enough to illuminate the MIL in conjunction with storage in the ECM data memory of DTCs for misfire (example: P0300, P030x) and / or lean fuel system (example: P0171, P0174, P1128, P1130, P1136, P1138).
Technical Background
^ Condition may be caused by use of contaminated gasoline. ^ Condition may be caused by use of gasoline with a low content of deposit control additives. Production Solution
Not applicable.
Service
If use of contaminated gasoline is suspected:
Consider advising the customer to change gasoline source (brand/gas station). Contaminated gasoline may exhibit one or more of the following characteristics:
^ May have unique color and odor. ^ May contain undissolved water. ^ May contain sediments and suspended matter. ^ May appear cloudy and (after settling) may show signs of separation. Repair:
Gasoline additive G 001 700 03 or G 001770 A2 can be used for removal of existing carbon deposits from:
^ MPI engine ^ Injectors. ^ Combustion chambers. ^ Intake valves. ^ FSI engine ^ Injectors. ^ Combustion chambers. Tip: For removal of carbon deposits from intake valves of FSI engines, refer to TSB 2019948.
Mix the additive with gasoline directly in the full fuel tank following the mix ratio. For example, 60 ml per 30 liters gasoline, 150 ml per 20 gallons of gasoline.

Dec 05, 2010 | 2001 Audi A4

1 Answer

How to change the spark plugs on the 3.0


1. Pull the hood release lever located under the dashboard.

2. Walk around to the front of the car, reach under the hood, find the latch and squeeze it. Open the hood.

3. Find the spark plugs, located in a row along one side of the engine (on an in-line four-cylinder engine) and attached to thick wires, called spark plug wires. Cars with V-shaped engines (which can have four, six or eight cylinders) will have spark plugs and spark plug wires on both sides of the engine.

4. Change one spark plug at a time, always putting the plug wire back on before changing the next spark plug.

5. Pull off one spark plug wire where it attaches to the plug. There is a little rubber boot at the plug end of the wire; pull on this part. Pulling higher up on the wire can damage the spark plug wire and cause it to separate.

6. Blow or wipe away any dirt or debris around the spark plug. You do not want anything to fall into the cylinder while the spark plug is out.

7. With the spark plug socket and a ratchet, remove the spark plug by turning it in a counterclockwise direction. You may need an extension for your ratchet if the spark plugs are deep-set or not directly accessible. Ratchets with flexible heads are especially helpful for hard-to-reach spark plugs.

8. Check the spark plug to make sure it needs replacing. A good spark plug should be lightly coated with greyish brown deposits. If heavy deposits are present, if the spark plug is black or if the electrode or core nose are damaged, the plug needs to be replaced.

Video - www.carbasics.co.uk - look in the 'how to' section.

Hope this is of help

Nov 28, 2010 | 2001 Dodge Stratus

4 Answers

WHEN WILL I GET PAID FROM FIXYA


Hi Danniboi, When you get paid: At the end of each month, FixYa audits your earnings. If you have earned $50 or more, your payment begins processing. That takes one month, after which your payment will be sent via your preferred payment method. You made over $50 in February, so your earnings will be sent to you in early April, but only if you select a valid payment method ASAP. Please go here, scroll down to the bottom of the page, and select one of the payment methods listed there. Payoneer Payoneer offers two payment methods. Experts can register for a special FixYa branded prepaid debit MasterCard, which can be used for online purchases, in stores, and at ATMs. US Experts can have their earnings Direct Deposited into their US bank account. Important note- If you want to receive payments via Direct Deposit, you must select the Direct Deposit link on the lower left corner of the Payoneer page (the page you'll get to by clicking the "Sign up now" link. PayPal You can also receive payments directly to your PayPal account. Go to PayPal.com to register. Once you have your PayPal account info (the email address which is associated with the account) enter it into the Premium Expert Information page. Please select a valid payment method immediately to ensure that you receive your April payment (for February earnings) on time. Please feel free to contact our Support Team directly at: http://www.fixya.com/contact

Mar 15, 2010 | 2000 Ford Focus

1 Answer

Sputting & misfiring , intake gasket replaced


Did you checked for possible oil deposited in the coils chamber? Did you get the codes? Go to an auto part where they have the code reader,get the codes and work on them accordingly. You will get some directions as to where to look for the problems.

Feb 12, 2010 | 2000 Kia Sportage

2 Answers

Why does my gas pedal stick while driving. 1995 isuzu rodeo. it happen when i try to accelerate. its worse when its cold.


The throttle-body (or throttle plate inside the throttle-body) is probably gunked-up with carbon deposits and needs a good cleaning.

Take the air snorkel off of the throttle body and look inside while holding the throttle plate open. If you have thick black deposits on the back side of the throttle plate, you can clean it by spraying some throttle body cleaner (Available at any parts store) onto a rag and using an old tooth brush to push the rag, clean all the black gunk out of the area.

I recommend an old tooth brush because using something hard like a screwdriver can scratch the inside of the aluminum throttle body and actually make the throttle stick worse. I don't recommend spraying the throttle body cleaner directly into the throttle body because it can end up in the air plenum where it may loosen some deposits that can cause severe engine damage.

Oct 17, 2009 | 1995 Isuzu Rodeo

3 Answers

Missfire on no 4cylender when hot and low compresion


you possibly have a warped head or blown head gasket.

Sep 15, 2008 | 2005 Mini Cooper

1 Answer

Honda accord 92


You horn is shorting by rust deposit.
If you really want to see witch one is defect, unplug them one by one and do a road test. The vibrations of the road loose the rust deposit and let them in contact with the horn circuit directly.Remember that you have 2 horns (bettwen the bumber and the radiator)

Jun 05, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...