Question about Cars & Trucks

Open Question

2003 deriot 60 series alternator, air condition, 2 belt assembly

Posted by on

  • Ron Seidl Nov 21, 2014

    Hi Anthony g Clements, I want to help you with your question, but I need more information from you. Can you please add details in the comment box? What is wrong? What kind of vehicle and how old?

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I locate the tensioner for the alternator belt on a 2003 kia spectra?


I wondered the same thing and looked for days on end. To my surprise, there is no tension pulley for the 2003 Kia Spectra. The Kia 4 cyl has two (2) belts. The outside belt services the power steering and air conditioning. The inside belt (the one you want to service) services the alternator and water pump. The alternator tension is set by two (2) adjustment screws located on the alternator. One screw is used as a locking bolt and the upper bolt is used as the adjuster. You must first loosen the locking bolt which is located between the belt and the alternator housing. Loosen about 6 to 8 travels of the wrench (size 13mm), then tighten the upper bolt until you have no more than 1/2 inch of movement in the belt when you press down. After the correct tension is achieved, tighten the locking bolt and your done. As long as you're down there, you might as well check the outer belt as well. Same principle, one locking and one adjuster. Good Luck, Fred

Feb 25, 2015 | 2003 Kia Spectra

2 Answers

Belt diagram for alternator belt 03 kia


your Kia dealership can print you a diagram.

Feb 20, 2014 | 2003 Kia Spectra

1 Answer

How do you replace the alternator in a 2003 V40? no manual available on our island...


NOTE Make a note of the anti-theft radio code
  1. Remove or disconnect the following:

    Engine splash guards, if equipped Negative battery cable Drive belt Power steering pump Mounting bracket Connector and wiring Upper mounting screw Upper screws for the air conditioning (A/C) compressor. Move the screws approximately 30 mm forward. Lower screws for the air conditioning (A/C) compressor Alternator

11_22_2011_3_09_12_am.gif

    Fig. Typical alternator mounting


    To install:
    Install or connect the following:


    Alternator Upper bolt. Do not tighten Mounting bracket Two bolts for the air conditioning compressor Tighten bolts to 18 ft. lbs. (25 Nm) Connector and wiring Power steering pump Drive belt Negative battery cable Engine splash guards, if equipped







Nov 22, 2011 | 2003 Volvo V40

1 Answer

Need a digram for alternator belt on mk5 golf 1.6 fsi 04 reg thanks


The serpentine belt routing diagram on VW Golf mk5 1.6 FSi m.y. 2004

1. Without A/C (Air Conditioning)

tdisline_902.jpg


2. With A/C (Air Conditioning)

tdisline_903.jpg
AC = Air Conditioning (A/C)
CS = Crankshaft
G = Guide pulley
Gen = Generator (Alternator)
T = Tensioner
WP = Water Pump

Sep 20, 2011 | Volkswagen Golf Cars & Trucks

2 Answers

Where is the voltage regulator located?


The voltage regulator is built into the Alternator.

May 13, 2011 | 2003 Ford Expedition

1 Answer

Changing alternator



REMOVAL & INSTALLATION 2.2L Engines
CHRYSLER ALTERNATOR

  1. Disconnect the negative battery cable.
  2. Label and disconnect the wiring (for easy installation).
  3. Remove the air conditioning compressor drive belt, if equipped.
  4. Loosen the alternator adjusting bracket bolt and adjusting bolt. Remove the alternator belt.
  5. Remove the bracket and mounting bolts.
  6. Remove the pivot bolt and nut.
  7. Lift the alternator from the vehicle.

When lifting the alternator out of the vehicle on some years with A/C, clearance may be restricted by the condenser cooling fan assembly or the A/C compressor and mounting bracket assembly, if so, removal of one of these items will be necessary.
To install:
  1. Position the alternator against the engine.
  2. Install the pivot bolt and nut.
  3. Install the mounting bracket bolts, and adjusting bolt.
  4. Install drive belts and adjust to specification.
  5. Tighten all the mounting bolts and nuts.
  6. Connect all alternator terminals.
  7. Connect the negative battery cable.

BOSCH ALTERNATOR
  1. Disconnect the negative battery cable.
  2. Disconnect the wiring and label for easy installation.
  3. Remove the air conditioning compressor drive belt.
  4. Loosen the alternator adjusting bracket locknut and adjusting screw. Remove the alternator belt.
  5. Remove the bracket locknut and mounting bolt.
  6. Remove the pivot bolt and nut.
  7. Remove the alternator from the engine.

To install:
  1. Position the alternator against the engine.
  2. Install pivot bolt and nut.
  3. Set the mounting bracket in place and install the bracket mounting bolt and locknut.
  4. Install the drive belts and adjust to specification.
  5. Tighten all the mounting bolts and nuts.
  6. Connect all alternator terminals.
  7. Connect the negative battery cable.

Jan 02, 2011 | 1994 Plymouth Voyager

1 Answer

2003 volkswagon passat v5, looking for diagram fro the serpintine belt?


The serpentine belt routing diagram for 2003 VW Passat V5 2.3 liter

tdisline_64.jpg
CS = Crankshaft
F = Fan pulley
Gen = Alternator
G = Guide pulley

T = Tensioner pulley
AC = Air Conditioning
PAS = Power Assisted Steering

Dec 01, 2010 | 2003 Volkswagen Passat

1 Answer

How to Change alternator on 2003 jaguar


Hi!!

This instruccions are for supercharged and non supercharged engines, if your engine is not supercharged disgreggard steps 4 and 8
.
To replace the alternator, remove or disconnect the following:

1 Negative battery cable 2. Air intake assembly 3. Cooling fan assembly 4. Supercharger drive belt, if equipped 5. Accessory drive belt 6. Alternator air intake ducting 7. Alternator wiring connectors 8. Supercharger water pump, if equipped 9. Alternator Good Luck!! Don't forget to rate this post!!

Aug 08, 2010 | 2003 Jaguar X-Type

1 Answer

How do you remove alternator from 1995 Maxima


Hope this helps!



0900c152800760af.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 1: The large positive lead connection is protected by a rubber boot


0900c152800760b0.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 2: Make sure the alternator ground wire is also removed



0900c152800760b1.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 3: Remove the lower adjustment bolt ...


0900c152800760b2.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 4: ... followed by the upper pivot bolt. Make sure you support the alternator


0900c152800760b3.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Fig. 5: Using a C-clamp to push in the pivot bushing will make installation easier

1995-98 Models
  1. Disconnect the negative battery terminal.
  2. Remove the splash guard on the right side of the vehicle.
  3. Loosen the alternator belt idler pulley.
  4. Slip the drive belt off the alternator pulley.
  5. Remove the four air conditioning compressor mounting bolts.
  6. Remove the radiator fan and fan shroud.
  7. Move the air conditioning compressor forward.
  8. Disconnect the alternator harness connector.
  9. Remove the alternator mounting bolts, and lower the alternator from the vehicle.

To install:
  1. Hold the alternator in place and install the mounting bolts.
  2. Plug in the alternator harness connector.
  3. Move the air conditioning compressor back into location.
  4. Install the radiator cooling fan and shroud.
  5. Install the air conditioning compressor mounting bolts.
  6. Place the drive belt on the alternator pulley.
  7. Tighten the drive belt to the proper tension with the idler pulley.
  8. Install the splash guard.
  9. Connect the negative battery terminal.

Apr 08, 2009 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...