Question about Cars & Trucks

1 Answer

It just idles when Iput into gear won't move.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 30 Answers

Selector cable/sensor shot? Try check that first. That would be the cheapest repair. If not that could be the transmission.

Posted on Nov 19, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When engine is cold all gears work. when engine warms up,the car will not move when I pres gas.when iput in drive car would move slowly but rev up high


if automatic check fluid level, if fluid fine probable defective transmission, have scanned for codes and analized by good transmission shop

Jan 31, 2016 | 2002 Chevrolet Impala

1 Answer

Have a 1990 cadillac deville engine runs smooth in park/,neutral when iput in gear and accelerate it shutters changed plugs / wires no help could it be tranny or cv joint no noises from either


Does idle rough in gear if so may have bad fuel injectors. not saying that it is not transmission or joints, need to make sure the engine is running properly first.

Nov 12, 2014 | 1990 Cadillac Deville

1 Answer

2004 Lincoln aviator goes into gear but won't move


bad transmission maybe. Try going into a lower gear (2 or 1) and giving it a little gas and holding it there. (about 2500 rpm) Hold it there for about 30 seconds.
If it still doesnt move, look under at the side of the transmission where the shifter cable connects and make sure it is moving.
Make sure the brake is on and the wheels are blocked and have a friend shift it back and forth while you look.
Sometimes, the connection pin comes out and you wont shift. .
If it does move right away, head to the transmission shop.

Dec 30, 2012 | 2004 Lincoln Aviator

2 Answers

Whenever i put my blazer in gear it dies


I'm assuming it's the 2.8, I'm not sure when they started putting the 4.3 V6 in them.
Anyway, a few things come to mind when something won't idle.1. EGR valves. If they are open at idle, it won't idle. It's open at cruising speeds when the engine is warm, but not at idle or full throttle.
2. Idle air controller (IAC): This is a little electrical valve located on the side of the throttle body. It regulates the amount of air that the engine needs to idle at the correct speed. It makes up for stuff like cold temps, being in gear, or having the A/C on at idle. They also get full of junk and jam up, or simply fail electrically. Replacement is extremely simple.
3. Ignition timing. If the timing is late (********), engine vacuum is lowered and it struggles to idle, even without the load of a transmission in gear.
4. Vacuum leaks. Crunchy old vacuum hoses make everything worse.

Apr 07, 2012 | Chevrolet Blazer Cars & Trucks

1 Answer

My 1998 Honda civic ex won't move but the motor


Have you just replaced the clutch? Taken out the transaxle, and put it back in? Are you sure transmission was in good condition before this? If so, review your procedure carefully to be sure you got it all back right.
Watch the slave cylinder while someone depresses clutch. You should see the little plunger move slightly out and move the clutch lever back. The lever moves the release bearing inside bell housing into contact with the pressure plate. If slave cylinder doesn't move at all, try bleeding again. The plunger has to move when clutch is engaged.
I'm not sure what you mean by "will shift but won't go into gear". You mean it's actually going into a gear position and car won't move? Or it won't go into any gear, period. As if you had no clutch?

Nov 06, 2011 | 1998 Honda Civic

1 Answer

Gas peddle won't produce rpm's. kind of a rough idle. Vehicle will move when put into gear and brake released but pressing gas does nothing.. (automatic)


did you check and see if the cable snapped for the accelerator, have someone push the peddle a few times and you watch to see if the accelerator lever that the cables connect to move if not they obviously broke and need to be replaced

Aug 26, 2011 | 2000 Volkswagen Beetle

1 Answer

My 2002 saturn vue won't go into gear


Sir ,
Kindly tell us whether your engine starts up properly to idle . If yes , then your problem is with the transmission system or with the clutch plates . If the clutch plates are too empty , the gear would be almost stuck . If the car is in N-neutral , try pushing it and while moving slightly try to change the gear . Engine oil and transmission oil should be checked up regularly .
At present situation you will have to have your gear system unjammed or opened up by a professional and have your gear box replaced or checked for jammed gears which is pretty time consuming and difficult job . Else you will have to replace the clutch plates and youre ready to fly again .
Thanking you , Dixon Dominic

Jun 01, 2011 | 2002 Saturn VUE

1 Answer

I HAVE 98 V70 NON TURBO LIGHT CAME ON AND READ P0120 AND IPUT A NEW TPS ONIT AND THE SAME PROBLEM START UP AND THE IDEL GOES UP AND DOWN THEN SHUT OFF OR SOME TIMES GOES TO NORMAL


Check your idle air control valve.It is mounted on your throttle body.Remove it and turn the key without starting it.If it doesnt move then it needs to be replaced.

Mar 07, 2010 | 1998 Volvo V70

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...